KitchenAid KUDS01IL, KUDS01DL, KUDS01FL, KUDS01VM Quick Reference Guide

DISHWASHER

Consumer Reference Guide

For questions about features, operation/performance, parts accessories or service, call: 1-800-422-1230

In Canada, call for assistance 1-800-461-5681, for installation and service, call: 1-800-807-6777 or visit our website at...

www.kitchenaid.com or www.KitchenAid.ca

LAVE-VAISSELLE

Guide deréférence pour leconsommateur

Au Canada, pour assistance composez le 1-800-461-5681, pour installation ou service composez le 1-800-807-6777 ou visitez notre site web à...

www.KitchenAid.ca

Table of Contents / Table des matières

PARTS AND FEATURES ................................. 2

START-UP ........................................................4

LOADING .......................................................... 5

CYCLES AND OPTIONS................................ 10

PIÈCES ET CARACTÉRISTIQUES ................14

MISE EN MARCHE .........................................16

CHARGEMENT ...............................................17

PROGRAMMES ET OPTIONS .......................22

Models/Modèles KUDS01IL, KUDS01DL, KUDS01FL, KUDS01VM

8531781

PARTS AND FEATURES

This manual covers several different models. The features on your dishwasher may vary from those shown below.

C D

A. Upper spray B. 2-Position top rack adjuster (two) C. FLEXI-FOLD DOWN™ flexible tines D. Removable top rack E. SATINGLIDE

F. Model and serial number label G. Water inlet opening (in tub wall) H. Removable rack inserts (three)

I. 4-way HYDRO SWEEP™

spray arm

upper rack track

J. Bottom rack

K. Detergent dispenser

L. Vent (on some models)

M. Active vent (Model KUDS01FL)

N. SURE-HOLD

O. Top rack

P. FLEXI-SPLIT™ divided tines Q. SURE-HOLD R. Middle spray arm

S. Silverware basket

T. CULINARY CADDY

utility shelf

light item clips

utensil basket

U. Overfill protection float

V. Heating element

W. SURE-HOLD

X. Rinse aid dispenser Y. WHISPER QUIET

insulation system

Z. Control panel located on door front

(Model KUDS01IL) AA. Control panel (Model KUDS01DL) BB. Control panel

(Models KUDS01FL, KUDS01VM)

mesh sack

sound

KUDS01IL

KUDS01DL

Control Panels

KUDS01FL

KUDS01VM

START-UP

Before using your dishwasher, remove all packaging materials. Read this entire Consumer Reference Guide, as well as the User Instructions. You will find important safety information and useful operating tips.

Using Your Dishwasher

For all models:

1. Rinse aid is essential for good drying. Be sure to fill the

dispenser before you use your new dishwasher. Each filling will last about 1 to 3 months depending on your usage.

7. Push door firmly closed. The door latches automatically. NOTE: The features on your dishwasher may vary from those

in the illustration below.

2. Scrape large food soil and hard items (toothpicks or bones)

from dishes. You do not need to prerinse your dishes.

3. Properly load the dishwasher. (See “Loading.”) Load dishes

with space in between so water will reach the soiled surfaces. Make sure nothing prevents the spray arm(s) from spinning freely.

4. Add detergent. Always use a high-quality brand detergent.

(See “Dishwasher Use” in the User Instructions.)

5. Run hot water at the sink nearest your dishwasher until the

water is hot. Turn off water.

For Model KUDS01DL:

8. Press the Start pad on the front of the dishwasher door. Or

press the Start pad to repeat the same cycle and options as in the previous cycle.

NOTE: If the dishwasher is not started within 30 seconds after selecting the cycle and options, it will revert to the last cycle and options completed.

IMPORTANT:

■ When the cycle starts, you will see a rotating pattern of lights

in the display window indicating that the unit is operating. This pattern will continue for up to 6 minutes while the multiple sensors check the incoming water temperature, rinse aid usage and soil level on dishes and cookware. The sensors then determine the ideal cycle for your dish load. After sensing is complete, the display will show the number of minutes left in the cycle and the cycle countdown will begin.

6. Press the desired cycle and option selections on the top, or

front, of the dishwasher door. (See “Cycles and Options.”) For Models KUDS01IL, KUDS01FL and KUDS01VM: Press

START. Or press START to repeat the same cycle and options as the previous cycle. The selected cycle and option lights will flash once.

NOTE: If the dishwasher is not started within 30 seconds after selecting the cycle and options, it will revert to the last cycle and options completed.

■ The cycle countdown pauses and the water heating light

glows while the dishwasher heats the water to a set temperature. (See “Cycle Selections.”)

To p R a c k

The top rack is designed for cups, glasses, and smaller items. Many items, up to 9" (22 cm), fit in the top rack. (See recommended loading patterns shown.)

NOTE: The features on your dishwasher rack may vary from the drawings shown.

10 place setting

FLEXI-FOLD DOWN™ flexible tines

The row of tines on the left-hand side of the top rack can be adjusted to make room for a variety of dishes.

To adjust the flexible tines

1. Grasp the tip of the tine that is in the tine holder.

2. Gently push the tine out of the holder.

3. Lay the tines down, toward the center of the rack.

SURE-HOLD® utility shelf

Fold down the extra shelf on the left-hand or right-hand side of the top rack to hold additional cups, stemware or long items such as utensils and spatulas.

12 place setting

■ Place items so open ends face down for cleaning and

draining.

■ Load glasses and cups in top rack only. The bottom rack is

not designed for glasses and cups. Damage can occur.

■ Place cups and glasses in the rows between tines. Placing

them over the tines can lead to breakage and water spots.

Cup and glass load

■ China, crystal, and other delicate items must not touch each

other during dishwasher operation. Damage may occur.

■ Load plastic items in the top rack only. Only plastic items

marked “dishwasher safe” are recommended.

■ Load plastic items so the force of the spray does not move

them during the cycle.

■ To avoid chipping, do not let stemware touch other items.

■ Small bowls, pans, and other utensils can be placed in the top

rack. Load bowls in the center section for best stability.

FLEXI-SPLIT™ divided tines

The row of tines on the right-hand side of the top rack can be adjusted to make room for a variety of dishes.

To adjust the front half

1. Grasp the tip of the tine that is in the tine holder.

2. Gently push the tine out of the tine holder.

3. Move the tines to the left to make room for larger dishes.

Move the tines to the right to wedge plastic or other lightweight items against the side of the rack.

To adjust the back half

1. Grasp the tip of the tine that is in the tine holder.

2. Gently push the tine out of the holder.

3. Lay the tines down, toward the center of the rack.

SURE-HOLD® light item clips

The light item clips hold lightweight plastic items such as cups, lids, or bowls in place during washing.

To move a clip

1. Pull the clip up and off the tine.

2. Reposition the clip on another tine.

Adjustable 2-position top rack

You can raise or lower the top rack to fit tall items in either the top or bottom rack. Raise the top rack to accommodate items up to 9" (22 cm) in the top rack and 13" (33 cm) in the bottom rack, or lower the top rack to accommodate items up to 11" (28 cm) in both the top and bottom racks. Adjusters are located on each side of the top rack.

Removable Top Rack

The removable top rack allows you to wash larger items such as stock pots, roasters, and cookie sheets in the bottom rack.

IMPORTANT: Remove dishes prior to removing upper rack from dishwasher.

To remove the top rack

1. Pull the rack forward slightly to access track stops.

2. To release, press the button of the track stop finger grip and,

pull track stop out of the track.

3. After removing both track stops, pull rack out.

To replace the top rack

1. Place the rollers on each side of the rack into the rack tracks

and push the rack back.

2. While pushing the button in the center of the track stop finger grip, insert track stop into rack and slide until it locks into place. Release the button.

3. Pull on the track stop to make sure it is locked into place.

4. Repeat on the other side.

BottomRack

The bottom rack is designed for plates, pans, casseroles, and utensils. Many items, up to 13" (33 cm) tall, fit in the bottom rack. (See recommended loading patterns shown.)

NOTE: The features on your dishwasher rack may vary from the drawings shown.

To raise the top rack

Lift the rack on either, or both, sides until the rack is level.

NOTE: The top rack adjusters must be level.

To lower the top rack

Press both rack adjusters and slide the rack back to its original position.

10 place setting

12 place setting

■ Do not load glasses, cups, or plastic items in the bottom rack.

Load small items in the bottom rack only if they are secured in place.

■ Load plates, soup bowls, etc., between tines.

■ Overlap the edges of plates for large loads.

■ Load soup, cereal, and serving bowls in the rack in a variety of

ways depending upon their size and shape. Load bowls securely between the rows of tines. Do not nest bowls because the spray will not reach all surfaces.

Utensil load

■ Load cookie sheets, cake pans, and other large items at the

sides and back. Loading such items in front can keep the water spray from reaching the detergent dispenser.

Removable rack inserts

Your dishwasher is shipped with 3 removable rack inserts. (See illustration below.) The large, medium and small removable rack inserts allow you to adjust the rack for the type of load you are washing. This is useful when washing a variety of dishes, pots and pans, or roasters.

Mixed load

■ Secure heavily soiled cookware face down in the rack.

■ Make sure pot handles and other items do not stop rotation of

the spray arm(s). The spray arm(s) must move freely.

■ Do not load items between the bottom rack and the side of

the dishwasher tub because they might block the water inlet opening.

CULINARY CADDY® utensil basket

Use the utensil basket to hold specialty cooking utensils (wooden spoons, spatulas, and similar items), or overflow silverware items.

A. Large rack insert B. Medium rack insert C. Small rack insert

Large rack insert

The large rack insert allows you to wash a number of large plates, platters, and trays. Removing this insert allows you to wash larger items such as casseroles, large mixing bowls, stock pots, and roasters.

The basket hangs on the bottom rack in the right-hand corner. Load the basket while it is on the bottom rack or remove the basket for loading on a counter or table.

NOTE: Spin the spray arms. Be sure items in the basket do not stop the rotation of the spray arms.

Medium rack insert

The medium rack insert when in the position as shipped, allows you to wash a number of medium plates, and bowls. With the small insert removed, you can move this insert forward in the rack to wash another row of large plates.

Removing rack inserts

To remove large and medium inserts

1. Pull handle out to the right and lift up to release.

2. Lift insert out of rack.

To remove small insert

Front view from inside rack

Insert placement for 2 rows of large plates.

Small rack insert

The small rack insert allows you to wash smaller plates, saucers, and bowls. When you remove this insert, you have more flexibility when moving the medium insert forward or back to wash larger items.

1. Pull out toward the back of rack and lift up to release.

2. Lift insert out of rack.

NOTE: It will be easier to install the inserts if you remove the

silverware basket from the rack.

Installing rack inserts

To install large insert

1. Place the large insert end legs under the 2nd from the right

wire as shown below.

2. Make sure that the three hooks on the back of the insert are placed over the back wire in the bottom of the rack.

3. Push down on insert until handle fits against outer rack edge.

4. When center tab under handle locks in under the middle side

rack wire, the insert is in place. (See illustration.)

To install medium insert

1. Place the medium insert end legs under the 2nd from the right

wire as shown below. IMPORTANT: Make sure that the curved wires, on the bottom

of the insert, fit over a wire in the bottom of the rack as shown.

2. Push down on insert until handle fits against outer rack edge.

SURE-HOLD® mesh sack

This sack hangs on the front of the bottom rack. Use it to hold small items that could otherwise “fly” around inside the dishwasher during a cycle.

Silverware Basket

Load the silverware basket while it is in the bottom rack or take the basket out for loading on a counter or table. (See recommended loading pattern shown.)

NOTE: Unload or remove the basket before unloading the racks to avoid spilling water droplets on the silverware.

■ Load items with covers down, using the separators, to prevent

silverware nesting.

■ Place small items such as baby bottle caps, jar lids, corncob

holders, etc., in the section(s) with hinged cover(s). Close the cover to hold small items in place.

3. When center tab under handle locks in under the middle side

rack wire, the insert is in place. (See illustration.)

To install small insert

Front view from inside rack

1. Place small insert in front of rack so that the feet on the back

of the insert hook under the 2nd wire from the front, and the curved front edge of the insert is aligned with the center wire on the front side of the rack. (See illustration.)

2. Push down on insert until handle fits against outer rack edge.

■ When covers are up, mix items in each section of the basket

with some pointing up and some down to avoid nesting. Spray cannot reach nested items.

IMPORTANT: Always load items (knives, skewers, etc.) pointing down.

NOTES:

■ Do not load silver or silver-plated silverware with stainless

steel. These metals can be damaged by contact with each other during washing.

■ Some foods (such as salt, vinegar, milk products, fruit juices,

etc.) can pit or corrode silverware. Run a rinse cycle if you do not have a full load to wash immediately.

Front view from inside rack

3. When center tab under handle locks in under the middle side

rack wire, the insert is in place. (See illustration.)

+ 19 hidden pages