1. Center board 1/4 in. (6 mm) max. above refrigerator
2. Two, 2 in. x 4 in. x 32 in. (5 cm x 10 cm x 81 cm) boards
3. Attach to studs with 6 -#8 x 3 in. (7.6 cm) screws
4. Compressor cover
21
3
2" (5 cm)
4
Built-in Refrigerators, Side by Side and Bottom Mount
®
PRODUCT MODEL NUMBERS OVERALL DIMENSIONS
CABINET OPENING DIMENSIONS
ANTI-TIP REQUIREMENTS
DOOR SWING DIMENSIONS
Electrical: A 115-volt, 60-Hz, AC-only, 15- or 20-
ampere, fused, electrical supply is required. A
time-delay fuse or circuit breaker is recommended.
It is recommended that a separate circuit serving
only this appliance be provided.
Water Supply: Use only 1/4" copper tubing for
water line. Water line to refrigerator must provide
15-100 psi water pressure.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 2266877
04-17-03
Width of Refrigerator:
Model Width A (above)
36 in. (91 cm)
42 in. (106 cm)
48 in. (122 cm)
36-1/4 in. (92 cm)
42-1/4 in. (107 cm)
48-1/4 in. (123 cm)
831/
8"
(211 cm)
A
(see chart following)
361/
4" (92 cm)
831/
8"
(211 cm)
251/
8"
(64 cm)
3
2
1
231/
2"
(60 cm)
24"
(61 cm)
831/
8"
(211 cm)*
3
1
/
2" (9 cm)*
Front view
Side by Side Bottom Mount
Model Width A
36 in. (91 cm)
42 in. (106 cm)
48 in. (122 cm)
35
in. (89 cm)
41 in. (104 cm)
47 in. (119 cm)
Top
view
Side view (all models)
1. Stud location
2. Grounded electrical outlet location
3. Recommended water shutoff valve location
4. Plumbing hole and water line location (wall or floor)
80" - 90"
(203-229 cm)
4"
(10.2 cm)
6"
(15.2 cm)
3" (7.6 cm)
831/4" (211.5 cm) min.
84
3
/4" (215 cm) max.
to bottom of solid soffit.*
231/2"
(60 cm) min.
11"
(28 cm)
77"
(196 cm)
A
Width
(see chart following)
1
2
4
6"
(15.2 cm)
6"
(15.2 cm)
3
Width of Opening:
Model Width A (above)
36 in. (91.4 cm)
42 in. (106.7 cm)
48 in. (121.9 cm)
35-1/2 in. (90.2 cm)
41-1/2 in. (105.4 cm)
47-1/2 in. (120.7 cm)
130˚
130˚
90˚
90˚
110˚
110˚
D
C
E
B
A
F
130˚
90˚
23"
(58 cm)
51"
(130 cm)
59"
(150 cm)
Location must
permit doors to
open to 90° min.
Allow 4-1/2 inch
min. space
between
refrigerator side
and corner wall.
A
B
C
D
E
F
36"
36-1/16" (92 cm)
38-1/2" (98 cm)
40" (102 cm)
43-1/2" (110 cm)
19-3/4" (50 cm)
14-1/2" (37 cm)
42"
38" (97 cm)
41" (104 cm)
42-9/16" (108 cm)
47" (119 cm)
23-1/4" (59 cm)
17-1/2" (44 cm)
48"
40" (102 cm)
43-1/2" (110 cm)
45-1/4" (115 cm)
50-1/2" (128 cm)
26-3/4" (68 cm)
19-3/4" (50 cm)
The solid soffit must be within 1 in.
(2.5 cm) maximum above the
refrigerator. If the solid soffit is higher
than 1 in. (2.5 cm) or one is not
available, prevent the refrigerator from
tipping during use as shown.
Locate the board(s) so the bottom
surface of the board(s) are 84 in.
(213 cm) from the floor.
Securely attach one or two 2 in. x 4 in. x
32 in. (5 cm x 10 cm x 81 cm) wood
boards to wall studs behind refrigerator.
Use 6 - #8 x 3 in. (7.6 mm) (or longer)
wood screws. The wood screws must
be screwed into the studs at least
1-1/2 in. (3.8 cm). The board(s) must
overlap the compressor cover.
Side by Side
Bottom Mount
KBLC36FK
KBLP36FK
KBLS36FK
KBRC36FK
KBRP36FK
KBRS36FK
KSSC36FK
KSSC36QK
KSSC42FK
KSSC42QK
KSSC48FK
KSSC48QK
KSSP36QK
KSSP42QK
KSSP48QK
KSSS36FK
KSSS36QK
KSSS42FK
KSSS42QK
KSSS48FK
KSSS48QK
1. 25-1/8" (64 cm) dimension is to front of top grille.
2. Power cord (24 in. [61 cm])
3. 5 ft. (1.5 m) water line tubing taped to back