Kitchenaid KOSE500ESS, KODT107ESS, KODT100ESS, KODE307ESS, KODE300ESS Dimension Guide

...
B
D
E
A
C
G
F
PRODUCT MODEL SERIES PRODUCT DIMENSIONS
KODE300E KODE307E KODE500E KODE507E
KODT100E KODT107E WOD97EC0E KOSE500E
KOSE507E KOST100E KOST107E WOS97EC0E
Electrical:
To properly install your oven, you must determine the type of electrical connection you will be using and follow the instructions provided for it here.
Oven must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. The model/serial number rating plate is located under the control panel on single ovens and under the control panel on the upper oven cavity on double ovens. See the following illustrations.
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.
Ref. W10725670
12/2/14
27" (68.6 CM) AND 30" (76.2 CM) ELECTRIC SINGLE AND DOUBLE BUILT-IN OVEN
Page 1 of 2
Models rated from 7.3 to 9.6 kW at 240 volts (5.4 to 7.4 kW at 208 volts) require a separate 40-amp circuit. Models rated at
4.8 kW and below at 240 volts (3.6 kW and below at 208 volts) require a separate 20-amp circuit.
A circuit breaker is recommended.
Connect directly to the circuit breaker box (or fused disconnect) through flexible, armored or nonmetallic sheathed, copper cable (with grounding wire). See “Make Electrical Connection” section.
Flexible conduit from the oven should be connected directly to the junction box.
Fuse both sides of the line.
Do not cut the conduit. The length of conduit provided is for serviceability of the oven.
A UL listed or CSA approved conduit connector must be provided.
If the house has aluminum wiring, follow the procedure below:
1. Connect a section of solid copper wire to the ends of the flexible conduit leads.
2. Connect the aluminum wiring to the added section of copper wire using special connectors and/or tools designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer's recommended procedure. Aluminum/copper connection must conform with local codes and industry accepted wiring practices.
For power requirements for models MEW7527, MEW7530, MEW7627, MEW7630, MEW9537, MEW9627, MEW9530 and MEW9630, refer to the following table.
Voltage Single Single Double Double Double Convect/
Thermal Convect Thermal Convect Thermal
240 VAC 4083 W 4141 W 8163 W 8279 W 8221 W 208 VAC 3088 W 3145 W 6172 W 6288 W 6230 W 240 VAC 17.4 A 17.8 A 34.7 A 35.7 A 35.2 A 208 VAC 15.1 A 15.6 A 30.2 A 31.2 A 30.7 A
A
Single Oven
A. Model/serial number plate
Double Oven
A. Model/serial number plate
A
27" (68.6 cm) models
A. 28¾" (72.8 cm) max. overall
height
B. 25
" (64.6 cm) max. recessed
⁷⁄₁₆
width
C. 26
" (67.9 cm) recessed
³⁄₄
height
D. 23
" (59.1 cm) max. recessed
¹⁄₄
depth E. 27" (68.6 cm) overall width F. 12" (30.5 cm) from back of
control panel to start of strain
relief
G. 48" (121.9 cm) flexible conduit
length
30" (76.2 cm) models
A. 28¾" (72.8 cm) max. overall
height
B. 28½" (72.4 cm) max. recessed
width
C. 26
" (67.9 cm) recessed
³⁄₄
height
D. 23
" (59.1 cm) max. recessed
¹⁄₄
depth
E. 30" (76.2 cm) overall width
F. 12" (30.5 cm) from back of
control panel to start of strain relief
G. 48" (121.9 cm) flexible conduit
length
B
G
F
A
27" (68.6 cm) models
A. 51
" (130.0 cm) max. overall
³⁄₁₆
height
B. 25
" (64.6 cm) max.
⁷⁄₁₆
recessed width
" (124.0 cm) recessed
¹³⁄₁₆
height
D. 23
" (59.1 cm) max.
¹⁄₄
recessed depth
E. 27" (68.6 cm) overall width
F. 12" (30.5 cm) from back of
control panel to start of strain relief
G. 66" (167.6 cm) flexible
conduit length
E
30" (76.2 cm) models
A. 51
height
B. 28½" (72.4 cm) max. recessed
width
C. 48
height
D. 23
depth
E. 30" (76.2 cm) overall width
F. 12" (30.5 cm) from back of
control panel to start of strain relief
G. 66" (167.6 cm) flexible conduit
length
C
D
" (130.0 cm) max. overall
³⁄₁₆
" (124.0 cm) recessed
¹³⁄₁₆
" (59.1 cm) max. recessed
¹⁄₄
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.
Ref. W10725670
12/2/14
CABINET DIMENSIONS - SINGLE OVENS
Page 2 of 2
g
CABINET DIMENSIONS - DOUBLE OVENS
Single Oven Undercounter (without cooktop installed above)
A
B
E
27" (68.6 cm) models
A. 27" (68.6 cm) min. cabinet
width
B. 1
¹⁄₂
" (3.8 cm) min. top of cutout to underside of countertop
C. 5
¹⁄₄
" (13.3 cm) bottom of cutout to floor
D. 25
¹⁄₂
" (64.8 cm) cutout width
E. 28" (71.2 cm) min. cutout
height
D
30" (76.2 cm) models
A. 30" (76.2 cm) min. cabinet
width
B. 1
¹⁄₂
cutout to underside of countertop
C. 5
¹⁄₄
cutout to floor D. 28 E. 28" (71.2 cm) min. cutout
height
C
" (3.8 cm) min. top of
" (13.3 cm) bottom of
¹⁄₂
" (72.4 cm) cutout width
Single Ovens Installed in Cabinet
D
F
G
E
27" (68.6 cm) models
A. 27" (68.6 cm) min. cabinet
width
B. 1" (2.5 cm) top of cutout to
bottom of upper cabinet door
C. 32" (81.3 cm) bottom of cutout
to floor
D. 25
¹⁄₂
" (64.8 cm) cutout width
E. 1
¹⁄₂
" (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 28" (71.2 cm)* recommended
cutout height
G. 24" (60.7 cm) cutout depth
A
B
C
30" (76.2 cm) models
A. 30" (76.2 cm) min. cabinet
width
B. 1" (2.5 cm) top of cutout to
bottom of upper cabinet door
C. 32" (81.3 cm) bottom of
cutout to floor
D. 28
" (72.4 cm) cutout width
¹⁄₂
¹⁄₂
E. 1
" (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 28" (71.2 cm)* recommended
cutout height
G. 24" (60.7 cm) cutout depth
Double Ovens Installed in Cabinet
A
D
F
G
E
*NOTE: The cutout height can be between 26¹⁵⁄₁₆" (68.4 cm) and
29⁷⁄₁₆" (74.8 cm) for sin
27" (68.6 cm) models
A. 27" (68.6 cm) min. cabinet
width
B. 1" (2.5 cm) top of cutout to
B
bottom of upper cabinet door
³⁄₄
C. 14
" (37.5 cm) bottom of cutout to floor is recommended.
³⁄₄
4"-14
" (10.2-37.5 cm) bottom of cutout to floor is acceptable.
D. 25
¹⁄₂
" (64.8 cm) cutout width
E. 1
¹⁄₂
" (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 5 0
" (127.6 cm)*
¹⁄₄
recommended cutout height
G. 24" (60.7 cm) cutout depth
le ovens.
30" (76.2 cm) models
A. 30" (76.2 cm) min. cabinet
width
B. 1" (2.5 cm) top of cutout to
bottom of upper cabinet door
C. 14
³⁄₄
" (37.5 cm) bottom of cutout to floor is recommended.
³⁄₄
4"-14
" (10.2-37.5 cm) bottom
of cutout to floor is acceptable.
¹⁄₂
D. 28
" (72.4 cm) cutout width
E. 1
¹⁄₂
" (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 5 0
" (127.6 cm)*
¹⁄₄
recommended cutout height
G. 24" (60.7 cm) cutout depth
*NOTE: The cutout height can be between 48⁷⁄₈" (124.1 cm) and
52³⁄₁₆" (132.6 cm) for double ovens.
C
Loading...