KitchenAid KGCS166GWH1, KGCT055GWH0, KGCT055GBL0, KGCS166GWH0, KGCS166GSS1 Installation Guide

m [] []

15" (38,1 cm}

278

30"(76.2cml

30" _ \

\

153,3cm)

36" (91,4 cml

36=,

- • {91,4cm_

Read and save these

IMPORTANT:
Installer: Leave Installation

Instructions with the homeowner,
Homeowner: Keep Installation

Instructions for future reference,
Save installation Instructions for local

electrical inspector's use,

43-(1o

{109,2_m_ \

Write down the model and serial numbers
before installing cooktop,

Both numbers are on the model/serial
rating plate, located on the underside of

the cooktop burner box,
Model #

Serial #

Part No, 3191827 Rev, B

Befere youstart°°°

Your safety and the safety of
others are very important.

We have provided many important
safety messages in this manual and
on your appliance. Always read and
obey all safety messages.

This is the safety alert
symbol.

This symbol alerts you to
potential hazards that can kill or hurt
you and others.

All safety messages will follow the
safety alert symbol and either the
word "DANGER" or "WARNING".

These words mean:

You can be killed or seriously

injured if you don't immediately

follow instructions.

You can be killed or seriously

injured if you don't follow
instructions.

All safety messages will tell you
what the potential hazard is, tell you
how to reduce the chance of injury,
and tell you what can happen if the

instructions are not followed.

Important: Observe aH governing
codes and ordinances.

WARNING: _fthe
information in this manua_

is not followed exactly, a
fire or expRosion may result

causing property damage,
persona_ injury or death.

m Do not store or use

gasoline or other

flammable vapors and

_iquids in the vicinity of

this or any other

appliance.
WHAT TO DO _FYOU

SMELL GAS
o Do not try to _ight any

appliance.

o Do not touch any

eRectrica[ switch.

o Do not use any phone in

your building.

o _mmediatemy cam[your

gas supplier from a
neighbor's phone. Follow

the gas supp_[er's

instructions.

o _f you cannot reach your

gas supplier, call the fire
department.

_nstaHation and service

must be performed by a
quamified installer, service
agency or the gas

supplier.

Note: This cooktop is manufactured for
use with Natural gas. To convert to
LR/Propane gas, see instructions in the
Gas Conversion Kit provided in literature
package.

Proper gas suppJy connection must be
available. See "Gas supply requirements,"

Page 4.

Proper installation is your responsibility.
Have a qualified technician install this
cooktop.

Make sure you have everything
necessary for correct installation. It is the
responsibility of the installer to comply

with the installation clearances specified

on the model/serial rating plate. The
model/serial rating plate can be found on
the underside of the cooktop burner box.

Check location where cooktop will be
installed. The location should be away

from strong draft areas, such as windows,

doors and strong heating vents or fans.
Do not obstruct flow of combustion and

ventilation air.

All openings in the wall or floor where the

cooktop is to be installed must be sealed.
When installing a cooktop under existing

cabinets and the installation does not
meet the minimum cabinet clearances,
install a range hood above the cooktop to

avoid burn hazards.
Electdcat ground is required. See

"Electrical Requirements," Pages 4-5.
It is the customer's responsibility:

To contact a qualified electrical

instaJJer.

To assure that emectrical installation is
adequate and in conformance with

Nationam EJectrical Code, ANSJ/NFPA

70 -- latest edition*, or Canadian

Electrical Code, C22.1 -1982 and C22.2
No. 01982 (or Jatest edition)** and aH

local codes and ordinances.

Copies of the standards listed may be obtained

from:

*National Fire Protection Association

One Batterymarch Park
Quincy, Massachusetts 02269

** CSA Bntemational

6501 East Pmeasant Valley Rd.
C_eveJand, OH 44131-8575

neededfer

pencil

Countertop opening dimensions that
are shown must be used. Given

dimensions provide required clearances.
Mobite home installation: The

installation of this cooktop must conform
to the Manufactured Home Construction

and Safety Standards, Title 24 CFR, Part
3280 (formerly the Federal Standard for
Mobile Home Construction and Safety;
Title 24 HUD part 280); or when such
standard is not applicable, the Standard

for Manufactured Home Installations

(Manufactured Home Sites, Communities
and Setups), ANSI A225.1 -- latest

edition*, or with local codes.
in Canada, the installation of this cooktop

must conform with the current standards
CAN/CSA-Z240 -- latest edition**, or with
local codes.

1" (2.5 sin} min,
space between
adjacent cooktops

25" (63.5 crn) min,=
deep caantertop Us
required

*NOTE: 24" (61 cm) min. clearance if bottom
of wood or metal cabinet is protected by not tess

than 1/4" (0.6 cm) flame retardant mittboard
covered with not tess than No. 28 MSG sheet

steel, 0.015" (0.04 cm) stainless steel, or 0.024"
(0.06 cm) aluminum or 0.020"

(0.05 cm) copper.
30" (76.2 cm) min. clearance between top of

cooking platform and bottom of an unprotected
wood or metal cabinet.

Gas Hne apenUeg--
Walh anywhere 5""(12.7 crn)

below endersUdnof
couetertep, Cabinet floor:
anywhere within 6" (15,2 cm)

of rear wall is recommended,

,°

Do eat seal

Grounded
outlet--

Locatewithin

24"(61crn)

of right rear

career

of cutout,

e o @ @

15"

(38.1era)

38"

(76.2era)

Base cabinet size:

CooktopSize Min. BaseCabinetReqnired

15" (38.1 cm) 15" (38.1 crn)
30" (76.9 cm) 30" (78.2 crn)
36" (91.4 cm) 36" (91.4 crn)
43" (109.2 cm) 44" (111.8 crn)

If cabinet has a drawer, a 4" (10.2 cm)
depth clearance from the countertop to
the top of the drawer (or other obstruction)
in base cabinet is required. The drawer
depth may need to be shortened to avoid
interfering with the regulator.

13-3/4" 19" 15" 2-1/8"

(34.9crn) (48.3crn) (38.1crn) (5.4crn)

29"

(73.7crn}

35-1/4"

(89.5crn)

42-3/4"

(108.6crn)

19 _

(48.3cm)

19 _

(48.3crn)

19 _

(48.3cm)

30 '_

(78.2cm)

38 _

(91.4crn)

42"

(108.7cm)

2-1/8"

(5.4crn)

2-1/8"

(5.4crn)

2-1/8"

(5.4crn)

2-7/8" 5-5/8"

(7,3cm) (14,3cm)

5-5/8"

(7:3 cm) (14,3crn)

(7:3cm) (14,3cm)

1iq/2"

,7:3cm) (2&4cm)