Kitchenaid KFID500ESS Dimension Guide

30" (76 cm) Electric Induction Range

B**

PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS

KFID500E

Electrical Connection:

• This range is equipped with a CSA International Certified Power Cord intended to be plugged into a standard 14-50R wall receptacle. Be sure the wall receptacle is within reach of range's final location.

Range Rating* Specified Rating of Power

Supply Cord Kit and Circuit Protection

120/240 Volts 120/208 Volts Amp

8.8 - 16.5 KW 7.8 - 12.5 KW 40 or 50**

16.6 - 22.5 KW 12.6 - 18.5 KW 50

* The NEC calculated load is less than the total connected load listed

on the model/serial/rating plate.

** If connecting to a 50-amp circuit, use a 50-amp rated cord with kit.

For 50-amp rated cord kits, use kits that specify use with a nominal

/8" (3.5 cm) diameter connection opening.

• A circuit breaker is recommended.

• Do not use an extension cord.

CABINET OPENING DIMENSIONS

Cabinet opening dimensions shown are for:

25" (63.5 cm) countertop depth, 24" (61 cm) base cabinet depth, 36" (91.4 cm) countertop height

A. 18" (45.7 cm) upper cabinet to countertop B. 13" (33.0 cm) upper cabinet depth C. 30" (76.2 cm) min. opening width. D. For minimum clearance to the top of the

cooktop, see NOTE. E. U.S.A.: 30" (76.2 cm) min. opening width F. Cabinet door or hinge should not extend

into cutout* G. 1" (3.8 cm) min. from right side cabinet H. 2" (5.1 cm) min. from floor I. 7" (17.8 cm) min. from floor J. 8" (20.3 cm) width K. 3" (8.9 cm) min. from floor

A. 353⁄4" ± 1⁄8" (90.8 cm ± 0.3 cm) cooktop height (minimum) with leveling legs

B. Model/serial/rating plates (located behind the control panel)** C. 47

D. 28 E. 26 F. 29

* Range can be raised approximately 1" (2.5 cm) by adjusting

** Model/serial/rating plates may be rotated up from behind the

*** Excludes handle. Dimension given is from wall to front of oven

Proper positioning of outlet shown at left.

* Nothing located in shaded areas can extend more than 11⁄2" (3.8 cm)

NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet is covered by not less than 1⁄4" (0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.

30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an uncovered wood or metal cabinet.

screwed all the way in*

⁄8" ± 1⁄8" (120.3 cm ± 0.3 cm) overall height (minimum) with leveling legs

screwed all the way in*

⁄2" ± 1⁄4" (72.4 cm ± 0.6 cm) depth with handle

⁄8" ± 1⁄8" (66.4 cm ± 0.3 cm)***

⁄16" ± 1⁄16" (76.0 cm ± 0.2 cm) width

the leveling legs.

control panel for viewing from the front of the range.

door and will vary based on electric outlet receptacle installation.

from wall or range will not slide all the way back.

E***

Because Whirlpool Corporation includes a continues commitment to improve our

products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.

Ref. W10694066A

2/10/15