30" (76 cm) Freestanding Electric Range
PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS
KFEG500E KFES530E
Electrical: If codes permit and a separate ground wire is used, it is
recommended that a qualified electrical installer determine that the
ground path and wire gauge are in accordance with local codes.
Do not use an extension cord.
To properly install your range, you must determine the type of electrical
connection you will be using and follow the instructions provided for it
here.
• Range must be connected to the proper electrical voltage and
frequency as specified on the model/serial/rating plate. The model/
serial/rating plate is located on the frame behind a top corner of the
door or on either side of the drawer. Refer to the figures in “Product
Dimensions” in the “Location Requirements” section
• This range is manufactured with the neural terminal connected
to the cabinet. Use a 3-wire, UL listed, 40- or 50-amp power supply
cord (pigtail) (see the following Range Rating chart). If local codes
do not permit ground throught the neutral, use a 4-wire power
supply cord rated at 250 volts, 40- or 50-amps and investigated
for use with ranges.
Range Rating* Specified Rating of
Power Supply Cord Kit
and Circuit Protection
120/240 Volts 120/208 Volts Amps
8.8 – 16.5 KW 7.8 – 12.5 KW 40 or 50**
16.6 – 22.5 KW 12.6 – 18.5 KW 50
* The NEC calculated load is less than the total connected load listed
on the model/serial/rating plate.
** If connecting to a 50-amp circuit, use a 50-amp rated cord with kit.
For 50-amp rated cord kits, use kits that specify use with a nominal
13/8" (34.9 mm) diameter connection opening.
• A circuit breaker is recommended.
A. 273/4" (70.5 cm) max. depth with handle
1
B. 47
/8" (119.7 cm) overall height (max.)
with leveling legs screwed in all the way*
C. 36" (91.4 cm) cooktop height (max.)
with leveling legs screwed in all the way*
D. 297/8" (75.9 cm) width
5
E. 25
/16" (64.3 cm) depth – back of range to front of cooktop**
F. Model/serial/rating plate (located on the frame behind
a top corner of the door or on either side of the drawer)
IMPORTANT: Range must be level after installation. Follow the
instructions in the “Level Range” section. Using the cooktop as a
reference for leveling is not recommended.
* Range can be raised approximately 1" (2.5 cm) by adjusting the
leveling legs.
** Front of door and drawer may extend further forward depending on
styling.
A
F
E
B
C
D
Because Whirlpool Corporation includes a continues commitment to improve our products,
we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details,
see Installation Instructions packed with product. Specifications subject
to change without notice.
Page 1 of 2
Ref. W10694026A
02/10/15
CABINET OPENING DIMENSIONS
Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop height.
IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination
installation instructions for dimensional clearances above the cooktop surface.
NOTE: A freestanding range may be installed next to combustible walls with zero clearance
A. 13" (33.0 cm) max. upper cabinet depth
1
B. 30
/8" (76.5 cm) min. opening width
C. For minimum clearance to top of cooktop, see NOTE*.
D. 30" (76.2 cm) min. opening width
E. Outlet - 8" to 22" (20.3 cm to 55.9 cm) from either cabinet,
7" (17.8 cm) max. from floor
F. Cabinet door or hinges should not extend into the cutout.
*NOTE: 24" (61.0 cm) minimum when bottome of wood or metal cabinet is shielded by not less than 1/4" (0.64 cm) flame retardant millboard covered
with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an uncovered wood or metal cabinet.
Because Whirlpool Corporation includes a continues commitment to improve our products,
we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details,
see Installation Instructions packed with product. Specifications subject
to change without notice.
Page 2 of 2
Ref. W10694026A
02/10/15