Kitchenaid KFED500EBS Dimension Guide

30" (76 cm) Freestanding Electric Range

B**

E***

PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS

KFED500E

Electrical Connection:

• This range is manufactured with the neural terminal connected to the cabinet. Use a 3-wire, UL listed, 40- or 50-amp power supply cord (pigtail) (see the following Range Rating chart). If local codes do not permit ground throught the neutral, use a 4-wire power supply cord rated at 250 volts, 40- or 50-amps and investigated for use with ranges.

Range Rating* Specified Rating of

Power Supply Cord Kit and Circuit Protection

120/240 Volts 120/208 Volts Amps

8.8 – 16.5 KW 7.8 – 12.5 KW 40 or 50**

16.6 – 22.5 KW 12.6 – 18.5 KW 50

* The NEC calculated load is less than the total connected load listed

on the model/serial/rating plate.

** If connecting to a 50-amp circuit, use a 50-amp rated cord with kit.

For 50-amp rated cord kits, use kits that specify use with a nominal 13/8" (39.9 mm) diameter connection opening.

• A circuit breaker is recommended.

• The range can be connected directly to the circuit breaker box (or fuse disconnect) through flexible or nonmetallic sheathed, copper or aluminum cable. See the “Electrical Connection – U.S.A. Only” section.

CABINET OPENING DIMENSIONS

Cabinet opening dimensions shown are for:

25" (63.5 cm) countertop depth,

24" (61 cm) base cabinet depth,

36" (91.4 cm) countertop height

/4" ± 1/8" (90.8 ± 0.3 cm) cooktop height (minimum)

A. 35

with leveling legs screwed all the way in* B. Model/serial/rating plates (located behind the control panel)** C. 473/8" ± 1/8" (120.3 ± 0.3 cm) overall height (minimum)

with leveling legs screwed all the way in* D. 281/2" ± 1/4" (72.4 ± 0.6 cm) depth with handle E. 261/8" ± 1/8" (66.4 ± 0.3 cm)*** F. 2915/16" ± 1/16" (76.0 ± 0.2 cm) width

* Range can be raised approximately 1" (2.5 cm) by adjusting

the leveling legs.

** Model/serial/rating plates may be roated up from behind the control

panel for viewing from the front of the range.

*** Excludes handle. Dimension given is from wall to front of oven door

and will vary based on electronic outlet receptacle installation.

Because Whirlpool Corporation includes a continues commitment to improve our products,

we reserve the right to change materials and specifications without notice.

A. 18" (45.7 cm) upper cabinet

to countertop

B. 13" (33.0 cm) upper cabinet depth

C. 30" (76.2 cm) min. opening width

D. For minimum clearance to the top

of the cooktop, see NOTE.

E. U.S.A.: 30" (76.2 cm) min.

opening width Canada: 31" (78.7 cm) min. opening width

F. Cabinet door or hinge should

not extend into cutout*

G. 11/2" (3.8 cm) min.

from right side of cabinet

H. 2" (5.1 cm) min. from floor

I. 7" (17.8 cm) min. from floor

J. 8" (20.3 cm) width

K. 3

/2" (8.9 cm) min. from floor

Proper positioning of outlet shown above.

* Nothing located in shaded areas can extend more than 11/2"

(3.8 cm) from wall or range will not slide all the way back.

NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet is covered by not less than 1/4" (0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.

30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an uncovered wood or metal cabinet.

Dimensions are for planning purposes only. For complete details,

see Installation Instructions packed with product. Specifications subject

to change without notice.

Ref. W10694065A

02/10/15