KitchenAid KEMI 377, KEMS 376, CMO-2743, KECO-376MCS, KECO-375MS User Manual

...

ELECTRIC BUILT-IN

MICROWAVE/SINGLE OVE

MODELS: KEMI 377

KEMS 375/376 KECO-375MS/376MCS CMO-2743

INSTALLATION

INSTRUCTIONS

INSTALLER: FINAL CHECK LIST

IMPORTANT:

LEAVE THESE INSTRUCTIONS FOR USE BY

THE LOCAL ELECTRICAL INSPECTOR

PLACEMENT

‘-1 1. Properly positioned - level, aligned and square with cabinet opening.

1 2. Anchored securely to cabinet.

3. Installation debris removed.

ELECTRICAL

7 1. Oven properly grounded.

2. Separate 120/240 volt or 120/208 volt, 60 Hz, single phase branch circuit of proper

’

protected by a time-delay fuse or circuit breaker of proper size.

3. All connections made in accordance with National Electrical Code, ANSliNFPA 70-latest local codes and ordinances.

OPERATIONAL

I 1. Oven racks installed and slide freely in all positions..

2. Knobs securely in place and rotate freely without rubbrng edges of control panel glass holes.

3. All lights function properly.

4 Refer to Use and Care Guide to set the electronic clock. 5 Door properly adjusted, opens and closes smoothly.

_ 6. Selector switch functions in all modes.

7. Unless instructed to leave for owner, remove all tags, labels and internal packing materials.

8. Oven has been wiped clean to remove fingermarks and other smudges.

9. Microwave oven operation checked according to procedure on back page of instructions.

ampacity,

THANK YOU INSTALLER:

edition and

1. Complete Installation Check Lrst

2. Leave all literature for customer.

3. Notify dealer that Installation is completed.

FOR DETAILED INSTRUCTIONS, FOLLOW METHODS DESCRIBED IN THIS FOLDER.

IMPORTANT Read Before Installing to Save Time, Work,

assure proper performance, and owner’s warranty protection.

Excessive Microwave Energy Exposure Hazard

- Do Not attempt to operate thls microwave oven with the door open.

- Do Not tamper with or defeat the safety interlocks.

- Do Not place objects between the microwave oven front face and the door.

- Do Not allow soil or cleaner residue to accumulate on sealing surface of microwave oven door.

- Do Not operate microwave oven if it is damaged.

- The microwave oven door must close properly to provlde safe operation. Do Not use microwave oven if door is bent; hinges and latches are broken or loose; or door seals, sealing surfaces or glass is broken.

- The microwave oven should only be adjusted and repalred by a qualified repair person.

- Have a qualified repair person check for microwave leakage if a repair is made. Failure to use microwave oven except as instructed may result in exposure to excessive microwave energy.

Note: Do Not use this microwave oven for commercial purposes. This microwave oven is designed for household use only.

INSTALLATION INSTRUCTIONS

OVEN LOCATION

The following recommendatrons are made to guide you In the locatron for the oven

Avoid placing oven where there

2 Place as far away as possible from TV> radto, etc , to prevent Interference

CABINET CONSTRUCTION

The oven must be enclosed by an appropriate cabinet or properly framed opening in the wall. See Figure 1 for dimensions.

The cabinet must have a solid bottom or two runners, 19-112 inches apart and centered within the cabinet. The bottom or runners must be able to support the weight of the unit (225 pounds for a double oven). The bottom or runners must be level and straight and flush with the cabinet cutout. The oven must be level for proper baking and

once installed the oven cannot be leveled.

Note: Clearances specified are for combustible walls and materials that have a density of 20 or more pounds per cubic foot. No evaluation of clearances has been made for installations adjacent to materials that are less than 20 pounds per cu. ft. or to plastic tiles and sheeting.

Do Not block the oven vent. Blocking the vent may cause cabinet damage and poor baking performance.

direct heat or splashing water.

Cabinet Damage

+ 4 hidden pages