5019_718_02001_UK 14-06-2007 14:43 Pagina 1
KCPT 9010/I KCPT 1210/I
Instructions for use
5019_718_02001_UK 14-06-2007 14:43 Pagina 2
5019_718_02001_UK 14-06-2007 14:43 Pagina 3
Warnings |
4 |
Safeguarding the environment |
5 |
Instructions for installation and use |
6 |
Extraction Mode |
6 |
Installation |
6 |
Functioning |
11 |
Maintenance |
11 |
After-Sales Service |
13 |
5019_718_02001_UK 14-06-2007 14:43 Pagina 4
Warnings
•This appliance should not be used by children or people with limited physical or mental abilities and with no experience or knowledge of its use, unless they are supervised by someone in charge of their safety or who has taught them how to use the appliance.
•Children should not play with the appliance.
1.
Do not connect the appliance to the mains supply until the installation is completely finished. Before carrying out any cleaning or maintenance work, always disconnect the hood from the mains supply by pulling out the plug or turning off the mains switch in the house.
2.Do not flambé food under the hood since the flames generated could cause a fire.
3.Do not leave a frying pan unattended when frying food as the cooking oil could catch fire.
4.Constant cleaning and maintenance of your hood will ensure it works properly. Regularly remove all the ingrained food from dirty surfaces. Regularly remove and clean or change the filter. Do not use inflammable material to convey exhaust air.
5.If the hood is used in conjunction with other appliances that run on gas or other fuels, the negative pressure of the room should be no greater than 4Pa (4 x 10-5 bar). This is why you should make sure the room is well aired.
6.Exhaust air from the hood should not be eliminated through the heating system chimney or appliances that run on gas or other fuels.
7.The room should be sufficiently ventilated when the hood is used together with other appliances that run on gas or other fuels.
8.Before touching the light bulbs, make sure they have cooled down.
Note: always use gloves when installing or carrying out maintenance work.
Electrical connection
The mains voltage should correspond with the voltage shown on the specifications label found inside the hood. If there is no plug, connect the hood to a socket that complies with current legislation and is in an easily accessible location. If there is no plug (direct connection to the mains supply) or the plug is not in an easily accessible location, fit a legally complying bi-polar switch that ensures the complete disconnection of the mains in the event of a category III line surge, in compliance with the installation regulations.
IMPORTANT: before reconnecting the hood circuit to the power supply, check that it is working properly, that the mains cable has been properly fitted and that it has NOT been crushed in its holder during installation.
Cleaning the hood
Warning! Failure to remove oil/grease (at least once a month) could lead to a fire breaking out. Use a soft cloth and mild cleaning product. Never use harsh substances or alcohol.
Before using the hood
To get best performance from the hood, please read these user instructions carefully and keep them for future reference.
Keep the packaging material (plastic bags, pieces of polystyrene, etc.) out of children’s reach as they can be dangerous.
Make sure the hood has not been damaged during transportation.
The installation and the electrical connections, replacement of power cables with plug or flexible cable should be carried out by a qualified technician in compliance with current legislation in force.
This appliance was designed to be used by adults.
4
5019_718_02001_UK 14-06-2007 14:43 Pagina 5
Warnings
Declaration of conformity 
This product has been designed, manufactured and marketed according to the following:
-safety objectives of the “Low Voltage” Directive 2006/95/CE (wich replaces 73/23/CEE and subsequent amendments).
-protection requirements of “EMC” Directive 89/336/EEC amended by Directive 93/68/EEC.
Troubleshooting guide
Hood does not work:
•Is the electrical power supply switched on?
•Is there a power failure?
Insufficient suction power:
•Did you set the right speed?
•Do the filters need to be cleaned or replaced?
•Are the air outlets blocked?
Light does not work:
•Does the bulb need to be replaced?
•Is the bulb correctly fitted?
Safeguarding the environment
1. Packing
The packaging material is entirely recyclable and marked with the recycling symbol 
. Follow local regulations for scrapping. Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous.
2. Product
This appliance is marked according to the European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE).
By ensuring that this product is disposed of correctly, you will help prevent potentially negative consequences for the environment and human health.
The symbol 
on the product or on the documents accompanying the product indicates that this appliance may not be treated as household waste. Instead, it should be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information on treatment, recovery and recycling of this product, contact your local authority, the household waste disposal service or the shop where you purchased the product.
5
Loading...