Bottom Mount Refrigerator
PRODUCT MODEL NUMBERS
OVERALL DIMENSIONS
LOCATION REQUIREMENTS
KBFS20ET KBFS25ET
Electrical: A 115 Volt, 60 Hz., AC only 15 or 20
amp fused, grounded electrical supply is required.
It is recommended that a separate circuit serving
only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use
an extension cord.
Water: Connect the ice maker to a cold water line
with water pressure between 35 and 100 psi
(241-689 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the system needs to be a minimum of
approximately 40 to 60 psi (276-414 kPa).
IMPORTANT: The pressure of the water coming
out of a reverse osmosis system going to the
water inlet valve of the refrigerator needs to be
between 35 and 100 psi (241-689 kPa).
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 12828154
05-04-07
D
overall
C
top of
cabinet
B
not incl.
handle
A
Depth Cab.Width Cab.Height Overall Height
Model # "A" "B" "C" "D"
KBFS20ET 26 7/8" 35 5/8" 68 1/2" 69 3/4"
KBFS25ET 31 3/4" 35 5/8" 68 1/2" 69 7/8"
To ensure proper ventilation for your refrigerator, allow for 1⁄2" (1.25 cm) space on
each side, at the top and behind the refrigerator. When installing your refrigerator
next to a fixed wall, leave 2 1/8" (5.4 cm) minimum on the hinge side to allow for
the door to swing open. If your refrigerator has an ice maker, allow extra space at
the back for the water line connections.
NOTE: Do not install the refrigerator near an oven, radiator, or other heat source, nor
in a location where the temperature will fall below 55°F (13°C).
1
4
¹⁄₂" (1.25 cm)
2¹⁄₈" (5.4 cm)