GAS-FIRED INFRARED
OUTDOOR PATIO HEATER
INSTALLATION, OPERATION
MAINTENANCE INSTRUCTIONS
®
FOR MODEL PTH106SS-3G
TABLE OF CONTENTS |
PAGE |
IMPORTANT …………………………………………………………………… |
1 |
TOOLS & PARTS ……………………………………………………………….. |
2 |
PRECAUTIONS………………………………………………………………….. |
3 |
ASSEMBLY INSTRUCTIONS …………………………………………………. |
4 |
GAS REQUIREMENTS & LEAK TESTING ………………………………….. |
7 |
SAFETY CHECKS ………………………………………………………………. |
8 |
LOCATING HEATER FOR USE ………………………………………………. |
9 |
LIGHTING / SHUTDOWN ………………………………………………………. |
10 |
STORAGE / BURNER REMOVAL………………………………..……………. |
12 |
BURNER INSTALLATION / PILOT CLEANING ……………………………… |
13 |
BURNER REMOVAL ……………………………………………………………. |
14 |
TROUBLE SHOOTING .………………………………………………………… |
15 |
PARTS LIST ……………………………………………………………………… |
16 |
WARRANTY ……………………………………………………………………… |
17 |
READ THE FOLLOWING INSTRUCTIONS CAREFULLY AND BE SURE YOUR PATIO HEATER IS PROPERLY INSTALLED, ASSEMBLIED AND CARED FOR. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN SERIOUS BODILY INJURY AND/OR PROPERTY DAMAGE. IF YOU HAVE QUESTIONS CONCERNING ASSEMBLY OR OPERATION, CONSULT YOUR DEALER, GAS APPLIANCE SERVICE REPRESENTATIVE OR YOUR GAS COMPANY.
NOTE TO INSTALLER:
LEAVE THESE INSTRUCTIONS WITH THE CONSUMER AFTER INSTALLATION.
NOTE TO THE CONSUMER:
RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
STOP
PLEASE CONTACT 1-800-913-8999 FOR ASSISTANCE DO NOT RETURN TO PLACE OF PURCHASE
IMPORTANT NOTICE:
DO NOT return to place of purchase!!!
Please contact Customer Service hotline at 800-913-8999 for help.
IMPORTANT
* * * WARNING * * *
For outdoor use only (outside any enclosure)
Improper operation, installation, adjustment, alteration, servicing or maintenance can cause severe property damage or serious injury or death. Please read the installation, operation & maintenance instructions thoroughly before installing or servicing this equipment.
* * * FOR YOUR SAFETY * * *
If you smell gas:
zShut off gas to appliance.
zExtinguish any open flame.
zIf odor continues, immediately call your gas supplier.
For your safety:
Do not store or use gasoline or other flammable vapor and liquids in the vicinity of this or any other appliance.
Page1
TOOLS AND PARTS NEEDED FOR ASSEMBLY
NOTE: 20 pound (7.87kgs), 5 Gallon ( 18.9 litres ) LPG Tank is not supplied
Tools Needed:
Phillips Head Screwdriver
Adjustable Opening Wrench
Spray Bottle of Soapy Water (To check for leaks)
Parts Supplied:
Reflector (3)
Dome Cap (1)
Reflector Plate (1)
Square Table (1)
Table Leg (4)
Heater Head With PVC Hose Assembly (1)
Post Assembly (1)
Gas Tank Enclosure Assembly (1)
LPG Gas regulator with Hose (1)
Tank Hook(1)
Hardware Bag
Post Socket 1/4” Acorn-cap (4) |
|
Post Socket |
1/4” Flat Washer (4) |
Table Leg 5/32”×22mm Truss Head Screw (4) |
|
Table Flat 5/32”×8mm Truss Head Screw (8) |
|
Reflector 5/32”×8mm Truss Head Screw (3) |
|
Reflector Plate 1/4”×10mm Truss Head Screw (3) |
|
Heater Head 3/16”×12mm Truss Head Screw (4) |
|
1/4” X 2-1/4” (1/4” X 57mm) Long Thread Ends Stud (1) |
|
Reflector Nut (1) |
|
For Service Questions Replacement parts or other assistance, Please call Nexgrill Customer Service Hotline at:
Nexgrill Industries, Inc
145 Brea Canyon Road
Walnut, CA 91789
(800) 913-8999
Page2
IMPORTANT NOTICE:
DO NOT return to place of purchase!!!
Please contact Customer Service hotline at 800-913-8999 for help.
PRECAUTIONS
NOTE: PLEASE READ THE FOLLOWING SAFETY
zDo not use this space heater in an explosive atmosphere. Keep heater away from areas where gasoline or other flammable liquids or vapors are stored.
zPrior to use, check for damaged parts such as hoses regulators, pilot or burner.
zDo not attempt to alter unit in any manner. EXAMPLE: using the heater without the top canopy reflector or radiant screen. Do not shorten the burner post assembly.
zHeater must always be placed on a solid and level surface.
2.The heater does not reach temperature.
3.The burner makes a popping noise during use (a slight popping noise is normal when the burner is extinguished).
zThe LP regulator/hose assembly should be located out of pathways where people may trip over it or in area where the hose will not be subject to accidental damage.
zChildren and adults should be aware of hazards of high surface temperature and should stay away to avoid burns of clothing ignition.
zAlways maintain proper clearance to z Young children should be carefully
combustible materials. Top 36" (91cm) Side 36" (91cm).
zAlways assure there is ample fresh air ventilation for outdoors use ONLY.
zNever replace or substitute the regulator with any regulator other than the factory suggested replacement.
zDo not clean heater with cleaners that are combustible or corrosive.
zDo not paint radiant screen, control panel or top canopy reflector.
zAll leak tests should be done with a soapy solution. NEVER USE AN OPEN FLAME TO CHECK FOR LEAKS.
zThe LP tank should be turned off when the heater is not in use.
zAt least once a year, the unit should be inspected for the presence of spiders, spider webs or other insects. The burner area is a common spider haven and can damage the heater and render it unsafe for use, Check the heater immediately if
any of the following exists:
1.The smell of gas in conjunction with extreme yellow tipping of the burner flames.
supervised when they are in the area of the heater.
zClothing or other flammable material should not be hung from the heater, or placed on or near the heater.
zAny guard or other protective device removed for servicing the heater must be replaced prior to operating the heater.
zInstallation and repair should be done by a qualified service person. The heater must be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required as necessary. It is imperative that the control compartment, burner and circulating air passageways of the heater be kept clean.
zKeep the appliance area clear and away from combustible material, gasoline and other flammable vapors and liquids.
zDo not obstruct the flow of combustion and ventilation air.
zKeep the ventilation opening of the cylinder enclosure free and clear of debris.
Page 3
IMPORTANT NOTICE:
DO NOT return to place of purchase!!!
Please contact Customer Service hotline at 800-913-8999 for help.
ASSEMBLY INSTRUCTIONS
STEP 1. Attach Table Legs
z Attach the post socket to the top of the tank enclosure using four 1/4” flat washers and four 1/4” acorn-caps.
z Secure the four table legs with four of 5/32” x 22mm truss head screws.
STEP 2. Secure The Table
z Put the square table onto the legs and secure with eight of 5/32” x 8mm truss head screws.
Page4
Loading...