Nighthawk Carbon Monoxide Alarm
40% LONGER LIFE THAN
OTHER CO ALARMS
NEW
LONGLIFE:
U
L
SIGNALING
LISTED
NIGHTHAWK
TECHNOLOGY
Worldís Most Accurate
Carbon Monoxide Alarm
*
TM
Battery Operated with Digital Display
• Part Number 900-0230 • Model KN-COPP-B-LS
Digital Display
Displays the level of carbon monoxide the unit is sensing.
The unit updates this reading every 15 seconds.
Peak Level Button
Displays the peak CO level recorded since
its last reset or power up.
Battery Operated (3AA’s included)
Provides protection during power outage.
Two LED’s
Red – Illuminates when in alarm mode.
Green – DC power is present, normal operation.
Test/Reset Button
Tests CO alarm circuit operation and allows
you to immediately silence the alarm.
End of Life Alarm
Alerts user to replace CO alarm after 7-years of operation.
Description
The Nighthawk 900-0230 battery operated carbon
monoxide alarm is an easy to install unit that provides
reliable protection against the dangers of carbon
monoxide. Digital display feature adds an advanced
level of protection showing CO levels in PPM allowing
you to see if levels change. Written information and
instruction make this unit’s operation easy for anyone
to understand. The Nighthawk DC Digital alarm has a
small, sleek design that is suitable for all living areas and
has a 7-year limited warranty.
Consumer Benets
The Nighthawk 900-0230 provides you and your family
a loud warning signal against the dangers of elevated
carbon monoxide levels in your home. The battery
operated CO alarm provides continuous monitoring of
CO levels, even during power outages when AC-only
units are not providing protection. The Nighthawk CO
alarm has a 7-year product life, providing 40% longer
protection than other CO alarms. The battery operated
CO alarm includes multiple mounting options allowing
installation on a wall or tabletop.
*Based on accuracy claims of major manufacturers
Features and Benets
• Digital Display – Shows CO level in PPM (parts
per million). Updates digital reading every 15 seconds
allowing you to see if levels change.
• Backlit Display – To help see the displayed reading
in the dark, a backlight appears during the peak level
cycle. The light will turn on when the peak level button is pressed.
• Peak Level Memory – Displays the highest CO
concentration measured since the last reset.
• Battery Operated (3AA’s included) – Provides
protection during power outages.
• Battery Lockout System – Deters covering battery
compartment without installation of batteries.
• Test/Reset Button – Tests the unit for proper
operation. Resets the Carbon Monoxide alarm.
• 7-Year End of Life Warning – Alerts user
to replace CO alarm after 7-years of operation.
(40% longer than other CO alarms)
• UL Listed – Lifelong Warranty
Nighthawk Carbon Monoxide Alarm
Battery Operated with Digital Display
Part Number 900-0230
Model KN-COPP-B-LS
Architectural and Engineering
Specications
The carbon monoxide alarm shall be Kidde Model KN-COPP-BLS (part number 900-0230) or approved equal. It shall be powered
by three (3) AA batteries (included). The temperature operating
range shall be between 40°F and 100°F (4°C and 38°C) and the
humidity operating range shall be 10% - 95% relative humidity.
The CO sensor shall be of a fuel cell design and shall meet the
sensitivity requirements of Under writers Laboratories UL2034
Single and Multiple Station Carbon Monoxide Alarms.
The alarm can be installed on the surface of any wall or table
top following the UL/Manufacturer’s recommended placement
guidelines. The alarm shall include a battery lockout system that
deters closure of battery door without batteries being installed.
The unit shall incorporate a digital display that meets the sensitivity requirements of UL 2034. The display will identif y the levels
of CO in parts per million (ppm) once that level reaches 30ppm
(i.e.: “abnormal” levels).
The alarm shall include a test button that will electronically
simulate the presence of CO and cause the unit to go into alarm.
This sequence tests the unit’s electronics to ensure proper operation. Per UL 2034 requirements, the CO sensor will not alarm to
levels of CO below 30 ppm and will alarm in the following time
range when exposed to the corresponding levels of CO.
70 ppm CO concentration 60 – 240 minutes
150 ppm CO concentration 10 – 50 minutes
400 ppm CO concentration 4 – 15 minutes
The unit shall incorporate 2 LED’s. A green LED will flash once
every 30 seconds to indicate the alarm is operating properly when
power is present. A red LED will pulse to indicate carbon monoxide
has been detected until the device is reset or CO is eliminated.
Technical Specications
Part Number: 900-0230
Model: KN-COPP-B-LS
Power Source: 3 AA BATTERIES
Sensor: Electrochemical
Audio Alarm: 85dB at 10ft
Temperature Range: 40˚F (4.4˚C) to 100˚ F (37.8˚C)
Humidity Range: 10%-95% relative humidity (RH)
Size: 3.0” x 5.0” x 1.5”
Weight: .44 lbs with battery
Interconnects: No
Warranty: 7 year limited
*Based on accuracy claims of major manufacturers
Ordering Information
Clamshell UPC: 0 -47871-07267-5
Part Dimensions Case/ Skid
Number I 2 of 5 Pack Quantity (w x d x h inches) Weight Skid Weight
900-0230** N/A Individual (Clam) 7.5 x 2 x 11 1.25 lbs. N/A N/A
21007267 100-47871-07267-2 Cutcase (4 units) Clam 7.94 x 11.5 x 11.25 5 lbs. 60 300
21007333 200- 47871-07267-9 Cutcase (8 units) Clam 7.94 x 21.63 x 11.5 10 lbs. 36 360
**Not for sale by individual unit
1016 Corporate Park Drive, Mebane NC 27302
1-800-880-6788
www.kidde.com
Distributed by:
Loading...