Kidde KN-COPE-D Brochure
Battery Operated Combination
Carbon Monoxide & Photoelectric Smoke Alarm
– Alarm/Voice message warning system
– Front loading battery
Part Number CP9000 Model KN-COPE-D
Voice Warning
Warns of hazard by announcing “Fire, Fire” or “Warning, Carbon Monoxide”
Peak Level Memory
Alerts user when the unit has detected CO concentrations of 100ppm or higher
Two LED’s
• Red – Alarm mode
• Green – Indicates power is present
Smart Hush
Silences the unit during nuisance alarm situations
(Smoke must be present before hush is activated)
Front Load Battery Door
™
Description
The Kidde Front-Loading Smoke and Carbon Monoxide alarm (part#
CP9000) offers protection from two hazards – fire and CO – in
one unit. This 9-volt battey powered alarm emits a beeping tone
followed by a voice warning that clearly announces the danger by
saying, “Fire! Fire!” or “Warning! Carbon Monoxide!” The uniquely
designed front-loading battery compartment makes battery replacement quick and easy, and ensures proper installation. Manufactured
with a photoelectric sensor for detecting smoke and fire, this alarm
also includes the world’s most accurate CO sensing technology
based on claims by major manufacturers.
Alarm Warnings
Fire: The red LED will flash and be accompanied by three long alarm
beeps followed by a verbal warning message “FIRE! FIRE!” The alarm
will repeat pattern until unit is reset or smoke is eliminated.
Carbon Monoxide: Four short alarm beeps followed by a verbal
warning “WARNING! CARBON MONOXIDE!” After four minutes the
alarm/voice pattern will sound once every minute until the unit is
reset, or the CO is eliminated.
Low Battery: One chirp followed by warning “LOW BATTERY.” The
red LED light will flash. This pattern will continue every minute for
the first hour. After the first hour the red LED light will flash once
every minute accompanied by the chirp sound. The “LOW BATTERY”
warning will only sound once every fifteen minutes. This cycle will
continue for at least 7 days.
Voice Hush Indication: “HUSH MODE ACTIVATED” and “HUSH
MODE CANCELLED” voice announcement
Alarm Memory: The green LED will blink once every 16 seconds to
alert a user when the unit has alarmed for smoke or has detected a
hazardous concentration of CO. If the alarm has detected a CO level
of 100ppm or greater, when the Test/Reset button is pressed the
unit will announce “CO PREVIOUSLY DETECTED.” If the alarm has
detected abnormal levels of smoke since its last test, it will produce
three rapid beeps.
Features and Benefits
• Front-Loading Battery – Speeds up replacement by eliminating the
need to remove the unit from the ceiling or wall.
• Unique Battery Door Design – Will not close if battery is not
installed properly.
• Voice Warning – Supplements warning from the traditional 85-decibel
alarm by clearly stating the danger present, fire or carbon monoxide.
• Photoelectric smoke sensor – May detect visible fire particles associated
with slow smoldering fires sooner than an ionization sensor.
• Electrochemical CO sensor – Provides accurate and continual CO
protection during the product’s life, remains stable during temperature
and humidity changes and resists reactions to household gases that may
cause false readings or reduce sensitivity.
• Smart Touch Button – One button performs the following functions:
– Activates the Hush® feature to temporarily silence nuisance alarms
(will announce “Hush mode activated,” or “Hush mode cancelled.”)
– Simultaneously tests the unit’s electronics and verifies proper operation
– Activates the peak level memory feature (will announce “CO previously
detected” if unit has detected levels of 100 ppm or higher)
– Resets the unit during a CO alarm (Unit will re-enter alarm within
6 minutes of reset if 70ppm or more of CO is present).
– Silences end of life chirp for two days at a time, up to 30 days maximum.
• Tamper Resistant – Unit will lock to mounting bracket and battery
door will lock to deter theft or tampering.
• Green LED – Will flash every 30 seconds to indicate proper operation.
• Red LED – Flashes in conjunction with the alarm sounding.
• End of Life Signal – Ten years after initial power, the unit will “chirp” twice
every 30 seconds to indicate the need to immediately replace the alarm.
• Low Battery Signal – Will chirp
every minute and red LED will flash
to indicate low battery condition.
Battery Operated Combination Carbon
Monoxide & Photoelectric Smoke Alarm
Part Number CP9000
Model KN-COPE-D
This alarm uses photoelectric sensing technology. Leading authorities recommend
that both ionization and photoelectric smoke alarms be installed to help insure
maximum detection of the various types of fires that can occur within the home.
Ionization sensing alarms may detect invisible fire particles (associated with fast
flaming fires) sooner than photoelectric alarms. Photoelectric sensing alarms may
detect visible fire particles (associated with slow smoldering fires) sooner than
ionization alarms.
Architectural and Engineering
Specifications
The combination smoke and carbon monoxide alarm shall be Kidde Part Number
CP9000 (Model KN-COPE-D) or approved equal. It shall be powered by one 9V
battery. The temperature operating range shall be between 40°F and 100°F (4°C
and 38°C) and the humidity operating range shall be 10% - 95% relative humid
ity, non condensing.
The unit shall incorporate a photoelectric smoke sensor with nominal sensitivity of
2.5 +/- 0.95%/ft. The CO sensor shall be of a fuel cell design and shall meet the
sensitivity requirements of Underwriters Laboratories UL2034 Single and Multiple
Station Carbon Monoxide Detectors. The unit shall qualify for UL-approved word
ing on the package: “World’s Most Accurate Carbon Monoxide Alarm.”*
The combination alarm can be installed on the surface of any wall or ceiling fol
lowing the UL/NFPA/Manufacturer’s recommended placement guidelines. The unit
shall provide optional tamper resistance that deters removal of the unit from the
wall or ceiling. No additional pieces shall be required to activate this feature.
The alarm shall include a test button that will electronically simulate the pres
ence of smoke and CO and cause the unit to go into both modes of alarm. This
sequence tests the unit’s electronics to ensure proper operation. The CO sensor
will not alarm to levels of CO below 30 ppm and will alarm in the following time
range when exposed to the corresponding levels of CO.
70 ppm CO Concentration 60 – 240 minutes
150 ppm CO Concentration 10 – 50 minutes
400 ppm CO Concentration 4 – 15 minutes
The combination alarm shall have two methods of warning for danger: a piezo
electric horn that is rated at 85 decibels at 10 feet and a voice warning that identifies the danger. For a CO incident, the horn will sound in the repetitive manner
– four (4) fast beeps, a short pause, four (4) fast beeps, a short pause. In between,
the unit will announce “Warning Carbon Monoxide!” After four minutes the
alarm/voice pattern will sound once every minute until the unit is reset, or the
CO eliminated. In a Smoke incident, the horn will sound in the repetitive man
ner – three (3) beeps, a pause, three (3) beeps, a pause. In between, the unit will
announce “Fire! Fire!” The unit shall incorporate 2 LED’s. A green LED will flash
every 30 seconds when in standby condition, every 16 seconds to indicate alarm
memory, and every 2 seconds to indicate the Hush“ mode is active. A red LED will
flash in unison with the sounder pattern. The unit shall include the Smart Hush™
feature that silences the unit for approximately 8 minutes if a nuisance alarm condi
tion occurs. The Green LED on the alarm will flash every 2 seconds while in Smart
Hush™ and will automatically reset itself. Smart Hush™ Feature also provides voice
-
-
-
-
-
-
-
annunciation of “Hush Mode Activated” when Smart Hush™ is activated
and “Hush Mode Cancelled” when the Hush cycle ends.
The unit shall also indicate a low battery warning utilizing each of the
following methods: a brief alarm chirp, the voice announcement of
“Low Battery!” The unit shall at a minimum meet the requirements of UL
2034, UL217, NFPA72, (chapter 11 2002 edition) The State of California
Fire Marshall, NFPA101 (One and two family dwellings) Federal Housing
Authority (FHA), Housing and Urban Development (HUD). It shall also
include a 10-year manufacturer’s limited warranty.
*Claim approved by UL, based on manufacturer’s reported testing.
Technical Specifications
Part Number: CP9000
Model: KN-COPE-D
Power Source:
Smoke Sensor: Photoelectric
CO Sensor: Electrochemical
Audio Alarm: 85dB at 10ft
Temperature Range: 40˚F (4.4˚C) to 100˚F (37.8˚C)
Humidity Range: 10%-95% relative humidity,
non-condensing
Size: 5.79” in diameter x 1.85” depth
Weight: .7lb
Interconnects: No
Warranty: 10 year limited
9V battery
Ordering Information
Ordering Pack Pack Dimensions Cartons/
Number UPC I 2 of 5 Config Qty (w x d x h inches) Weight Pallet
21010031 0-47871-10031-6 100-47871-10031-6 CLAM Cut Case (4 Units) 7.9 x 13.2 x 11.7 1.8 54
Distributed by:
1016 Corporate Park Drive
Mebane NC 27302
1-800-880-6788 www.Kidde.com
KL-CP9000 sheet rev. 04-2014
Loading...