Kidde HD135F User Manual

Flashing Red LED

Flashes every 30-40 seconds to indicate proper operation

Test Button

Tests unit’s electronic circuitry, horn and battery function

9V Battery Back Up

Provides continuous protection even during power
outages

Description

The Kidde HD135F is a 120VAC Wire In Heat Alarm that
responds to temperature rather than smoke. The alarm
will sound if temperatures rise about the 135˚F. The Kidde
HD135F interconnects with up to 24 devices (of which 18
can be initiating) including smoke, CO and heat alarms.
This unit includes a 5-year limite4d warranty and is UL
Listed.

Benefits

The Kidde HD135F 120VAC wire in heat alarm gives you
and your family an early warning to dangerous tempera­tures of 135˚F or more. This unit can be used as a single
station unit or it can be interconnected to up to 24 Kidde
devices in a multiple station arrangement. The intercon­nect system should not exceed the NFPA interconnect
limit of 12 smoke alarms and/or 18 initiation alarms. The
HD135F includes a tamper resist pin to help deter tam­pering or theft.

Features and Benefits

• Interconnectable – Interconnects with up to 24 Kidde

devices.

•Test Button – Tests unit’s electronic circuitry, horn and

battery function.

• 9V Battery Back Up – Provides continuous protection

even during power outages.

• Red LED – Flashes every 30-40 seconds to indicate

proper operation.

• Low Battery Indicator – Alerts user in the event of a

low or missing battery.

• Quick Connect Power Harness – Makes installation

fast and easy.

120VAC Wire In with 9V Battery Back Up

Heat Detector

• HD135F

1394 South Third Street, Mebane NC 27302
1-800-880-6788 • www.kiddeus.com

Architectural and Engineering
Specifications

The heat detector shall be Kidde Unit HD135F or approved
equal. It shall be powered by a 120VAC, 60Hz source along
with a 9V battery backup. The temperature operation range
shall be between 40°F and 100°F (4°C and 38°C) and the
humidity operation range shall be 5% - 95% relative humidity.

The heat detector can be installed on any standard single
gang electrical box, up to a 4” octagon junction box. The
electrical connection (to the alarm) shall be made with a
plug-in connector. A maximum of 24 Kidde devices can be
interconnected in a multiple station arrangement. The inte
connect system must not exceed the NFPA (National Fire
Protection Association) limit of 18 initiating devices (Smoke,
heat, CO, etc) interconnected, it is still possible to intercon­nect 6 strobe lights and or relay modules. The alarm shall
provide optional tamper resistance that deters removal of the
unit from the wall or ceiling.

The unit shall include a piezoelectric horn that is rated at
85dB at 10ft. The unit shall incorporate a LED. A red LED will
be constantly “ON” when AC power is present and will flash
once approximately every 30-40 seconds to indicate that the
smoke alarm is operating properly and will flash rapidly
when the unit is alarming and will remain so until the air is
cleared.

The unit shall incorporate a test button. The test button
shall test all the electronic circuitry, horn, and battery.

The unit shall at a minimum meet the requirements of
UL217, NFPA72, (chapter 10 & 11 2002 edition) The State of
California Fire Marshall, NFPA101 (One and two family
dwellings, Federal Housing Authority (FHA), Housing and
Urban Development (HUD).

Installation of Heat Detector

The heat detector should be installed to comply with all local
codes having jurisdiction in your area, Article 760 of the
National Electric Code, and NFPA 72. Make certain all alarms are
wired to a single, continuous (non-switched) power line, which
is not protected by a ground fault interrupter. A maximum of
1000 ft. of wire can be used in the interconnect system.

120VAC Wire In with 9V Battery Back Up
Heat Detector

Unit Number HD135F

Technical Specifications

Unit Number: HD135F
UPC: 0-25417-84135-0
Power Source: 120VAC, 60HZ, 9V battery backup
Sensor: Heat
Audio Alarm: 85dB at 10ft
Temperature Range: 40˚F to 100˚F (4˚C to 38˚C)
Humidity Range: 5%-95% relative humidity (RH)
Size: 5” in diameter x 2” depth
Weight: .75lbs
Interconnects: Up to 24 Kidde devices
LED: Red, AC power present,

alarm mode

Warranty: 5 year limited warranty

Distributed by:

Ordering Information

Gift Box UPC: 0-25417-84135-0

Part Dimensions Case/ Layers/ Skid
Number I 2 of 5 Pack Quantity (w x d x h inches) Weight Skid Skid Weight

HD135F N/A Individual 4.75 x 2.45 x 5.65 .75lbs N/A N/A N/A
HD135F 200 25417 84135 4 Master Pack (6 units) 6.5 x 10.5 x 6.5 4.5lbs 60 5 270lbs

MASTER PACK

6

1

UNIT

5" 2"