24”
Extension Model
G24
User
Guide
For Model
G60
-
ELONGATE
Use 1 optional 24” extension (Model G24)
when opening is between 5’ to 7’ wide.
Use 2 optional 24” extensions (Model G24)
when opening is 7’ to 9’ wide.
Use 3 optional 24” extensions (Model G24)
when opening is 9’ to 11’ wide.
Use 4 optional 24” extensions (Model G24)
11'
when opening is
to 13’ wide.
Maximum 4 extensions per gate
1
-
24” Extension
4 Expansion 4 Expansion
screw sockets screws
For Model G20 -
SAFEWAY
Use optional 24” extension (Model G24) for
openings 43 1/2" to 66” wide.
Only one extension recommended per gate,
2
Place extension between the two basic gate
sections.
Basic gate
.‘i.:k’ i1
i i
! :
j,
ti
I i
i’ i!
I
,’
/
:.
.-
Adjust gate sections, until gate is approxi-
I
mately right width and adjustment holes are
aligned on top and bottom. Sections should fit
without any distance between
When adding more than one extension
bars.
(G60
only) add in continuation of first extension.
IMPORTANT
Gate must NOT be extended any further
than 4 holes from spindle ends.
Place one set of expansion screws and screw
sockets in top and bottom set of overlapping
adjustment holes nearest hinge side of gate
and second set of expansion screws and
screw sockets in overlapping holes nearest
locking side of gate. Tighten with a screw-
driver.
3
Loading...