MKICKER,
1350,1400,1402,1460,1410,
1525,1570,1600,1650,1690, & 16903
Coaxial & 3-Way Speaker Systems
Congratulations! You have just purchased one of the latest In a long line of
exceptional car audio from Stillwater Designs. Your KICKER Impulse was
deslgned and englneered by the same team which created many other
international award winning KICKER components like the Solo-Ban@, XPL@,
ResolutionTM drivers. It contains a number of cutting-edge features to give you
outstanding performance and dependability when installed in a properly
designed system.Thanks for buying KICKER. Enjoy.
*Titanium or Titanium-Deposit Dome Tweeter
with Neodvmlum Magnet for smooth high
frequency response
l
Directlonal Sound LensTM lets you tailor each driver’s high frequency dispersion pattern
to suit your Individual listening preferences; DSL not available on 1350 & 1402
*Felt Damping Plug behind dome for enhanced transient response
l
Ferro-FIuidTM Cooled Tweeter Voice Coil for extended life
l
2.5 inch midrange driver on 16903 3-way system
*Curvilinear Injection-Molded Polygraphite Woofer Cones for smooth extended
frequency response
l
Blackened Metal Parts and KaptonTM Voice Coil Formers in Woofers for exceptional
thermal power handling capability
Adjusting the DIrectIonal Sound lens
Most KICKER Impulse coaxlals and the 3-way 16903 have a feature which allows tuning
the high frequency response to your taste. The front of the tweeter incorporates KICKER’s
Directional Sound LensTM which can be rotated to shape the tweeter’s output. After
mounting and wiring your new speakers, and before securing the grills, you will want to Iisten to them with the DSL in different positions to determine which angle works best for
you. We suggest you start with the KICKER logo pointed toward the listener’s head, then
rotate until it sounds best to you. Have fun and experiment with a little work you’ll get
greatly superior Imaging can IS possible with conventional coaxial speakers.
AMiFKA ‘S MUSIC MACHMESL
Your KICKER drivers are specifically designed for mounting In free-air applications. While
the speakers don’t need a sealed box to work in, for optimum performance it IS important
to isolate the sound coming off the front of the driver from the sound radiant-g from the
back of the driver. This rsolatlon IS usually accomplished by using the correct size driver in a
factory speaker location.
Mounting
If custom door mounbng locations are desired for your drivers, be careful to avoid
interference from wtndow and door lock mechanisms. The first step IS to find a location on
the door panel that will accept the size of speaker chosen. Then remove the door panel
from the door, and check for the operation of the window all the way up and down.
If metal must be cut to mount the speakers, try to avoid structural metal and braces.
On models with grills included, mount as Indicated in the folIowIng diagram. There IS a supply of butyl rubber adhesive included to help hold the grill on the ring.
Factory
Door Panel
Speaker
Grill Ring G<,
w/Screws
If factory door speaker wiring
IS
not available to tie into, it
IS
necessary to run the supplied wire through the door Jamb. This wire should be kept away from sharp edges and the
possibility of getting pinched. An existing boot In the door Jamb IS the ideal place to run
the wires, but sometimes this does not exist or IS inaccessible. Drilling holes to run wires
through IS very tricky, and caution must be exercised not to drill into other wlnng or mechanisms. Any time a wire IS run through a bare hole, it IS necessary to insert a rubber grommet first to protect the wire.
Loading...