Kicker 11KMT60, 10ZXM4502 User Manual

KMT60

Long-Range Tower System

LIVIN’ LOUD

English Version

Versión Español

Torre de Largo Alcance Sistema

Deutsche Version

Long-Range Turm System

Version Francaise

Long-Range Tour Système

KMT60 Long-Range Tower System
Owner’s Manual

MODEL: KMT60

Authorized KICKER Dealer:

Purchase Date:

Serial Number:

The KICKER KMT60 Long-Range Tower System is specifi cally designed for mounting in the open-air, using an
exponential-horn-loaded 20mm titanium tweeter and dual 6.5 inch (165mm) woofers to produce clean and crisp
sound over a long distance. The injection-molded ABS enclosure and speakers are UV treated, splash resistant,
and weather resilient. The woofers utilize a sealed cone and motor assembly, and an open-cell foam protects the
tweeter. Mount the KMT60 in your boat or get creative with a pair of them in the garage, on your 4x4 or Polaris
Ranger’s roll bars, or in any other bar-mounted application.

Model: KMT60

Speaker Design 2-Way

Woofer Size | inches [mm] 6 1/2” [165]

Woofer Surround Material Butyl Rubber

Tweeter Size | inches [mm] 3/4” [20]

Tweeter Dome Material Titanium

Exponential Horn | inches [mm] 3 1/4” x 6” [83 x 151]

Rated Impedance | ohm 4

DC Resistance | ohm 3

Power Range | Watts RMS 25–150

Peak Power Handling | Watts 300

Sensitivity [SPLo], dB @ 1W, 1m 93

Effective Frequency Range | Hz 50–21k

Height | inches [mm] 9” [229]

Width | inches [mm] 19 1/16” [484]

Depth | inches [mm] 11” [280]

INSTALLATION

Mounting: The sound produced by the KMT60 long-range tower system is directional. The enclosure may
be mounted vertically or horizontally; the billet-aluminum mounting brackets can accommodate any angle for
the optimum fi ring direction. Find the best location for stereophonic sound and, If necessary, add more KMT60
systems to the installation to help distribute and balance the sound. After determining the best mounting
locations, carefully check the areas where the mounting hardware and speaker cable will be placed. The KMT60
long-range tower system’s billet-aluminum mounting brackets use seven sets of ABS plastic inserts to fi t most
wakeboarding tower and roll bar diameters.

The mounting hardware design provides versatility in angular positioning to direct the speaker’s output to the
ideal listening position; however, it is not recommended to reposition the speakers excessively after they are
mounted. Custom mounting locations will require more preparation, work, and possibly customized hardware. If
the mounting location requires you to cut metal, avoid structural metal and braces. In either case, make sure the
speaker will not interfere with the vehicle’s mechanisms or the party you are throwing out on your pontoon boat.

2

stainless steel socket­head cap screws
(1/4” Allen wrench)

1

plastic mounting inserts

supported diameters:

1.625” [42.3mm]

1.75” [44.4mm]

1.875 [47.6mm]
2” [50.8mm]

2.25” [57.2mm]

2.375” [60.3mm]

2.5” [63.5mm]

place and screw
the mounting
bracket bottom
to the top of the
KMT60 enclosure

stainless steel socket­head cap screws
(1/4” Allen wrench)

4

2

place mounting
inserts

mounting bracket bottom

plastic mounting inserts

mounting
bracket top

place and screw
the mounting
bracket top to
the mounting
bracket bottom

mounting bracket top

3

place remaining
mounting inserts

3