Keys Fitness HT95 User Manual

Owner's Manual F
Health Trainer 95t Treadmill
Customer Service
(888) 340-0482
Keys Fitness Products
4009 Distribution Drive Suite 250
Garland, TX 75041
CAUTION! Read all precautions and instructions in this manual before
using this equipment.
Model Name : HT95T/HT95T-CE Serial Number :
415-00015
07/05 Rev A
Write down for future reference
Serial Number Decal Location
Table of Contents
Important Safety Information Before You Start
Assembly Moving Instructions Power Requirements
Console Panel Functions Program Operation
Program Profiles Monitoring Your Heart Rate Warm Up Exercises
3
4
5-9
10 11 12
13-14
15
16-17
18
Changing to MPH or KM Calibration Sequence Belt Adjustment
Maintenance Instructions
Error Messages Troubleshooting
Parts List Exploded View
Warranty Information
19 20 21 22 23 24
25-26 27-28
29
Important Safety Information
WARNING! Before using this treadmill or starting any exercise program, consult your physician. This is espe-
cially important for persons over the age of 35 and/or persons with pre-existing health problems. The man- ufacturer or distributor assumes no responsibility for personal injury or property damage sustained by or through the use of this product.
WARNING! To reduce the risk of electrical shock, burns, fire, or other possible injuries to the user, it is impor-
tant to review this manual and the following precautions before operation.
SAFETY PRECAUTIONS AND TIPS
1. It is the owner's responsibility to ensure that all users of this treadmill have read the Owner's Manual and
are familiar with warnings and safety precautions.
2. This treadmill has a user maximum capacity of 325 pounds.
3. The treadmill should only be used on a level surface and is intended for indoor use only. The treadmill should not be placed in a garage, patio, or near water and should never be used while you are wet. Keys Fitness recommends a treadmill mat be placed under the treadmill to protect floor or carpet and for easier cleaning.
4. Follow safety information in regards to plugging in your treadmill. Keep the power cord away from the incline wheels and do not run the power cord underneath your treadmill. Do not operate the treadmill with a damaged or frayed power cord.
5. Wear comfortable, good-quality walking or running shoes and appropriate clothing. Do not use the treadmill with bare feet, sandals, socks or stockings.
6. Always straddle the belt and allow it to start moving before stepping onto the belt.
7. Hold on to handrail when adjusting speed, incline, or other controls.
8. Always examine your treadmill before using to ensure all parts are in working order.
9. Allow the belt to fully stop before dismounting.
10. Pets should never be allowed near or on the treadmill.
11. Do not leave children unsupervised near or on the treadmill.
12. Never operate the treadmill where oxygen is being administered, or where aerosol products are being used.
13. Never insert any object or body parts into any opening.
14. For safety and to prevent damage to your treadmill, no more than one person should use the treadmill at a
time.
15. Always unplug the treadmill before cleaning and/or servicing. Service to your treadmill should only be
performed by an authorized service representative, unless authorized and/or instructed by the manufacturer.
16. Failure to follow these instructions will void the treadmill warranty.
17. Never leave the treadmill unattended while it is running.
Before You Start
Thank you for purchasing the Health Trainer 95t Treadmill! This quality product you have chosen was designed to meet your needs for cardiovascular exercise. Before you start, please read the Owner's Manual and become _amiliar with the operation of your new treadmill. Remember to take the time to perform the stretching exercises provided to avoid injury.
Do not stand on the walking belt while pressing the Power button or Start/Stop button. Always adjust the speed of the treadmill in small increments as this treadmill is capable of high speeds. If you are taking medication, consult your physician to see if the medication will affect your exercise heart
rate. If you have heart problems, you are not active, and/or are over the age of 35 years, do not use the pre-set
treadmill programs or start an exercise program without first contacting and receiving approval from your physician. To avoid the risk of electrical shock, always keep the console dry. Do not spill liquids on the console. Keys Fitness recommends a sealed water bottle for beverages consumed while using the treadmill.
Please review the following drawing below to familiarize yourself with the listed parts. This manual covers several treadmills, so the one pictured below may not be identical to your particular model.
END CAP
RUNNING BELT
\
LATCP
POWER CABLE
{IGHT UPRIGHT
BASE
TRANSPORT WHEEL
Assembly
The Health Trainer 95t Treadmill will require assembly before operating. After opening the box, remove any
packing material from the treadmill.
Do not throw away any packing materials until the unit is working properly. Place the base on a clean, level surface. Make sure the electrical cord will easily reach an electrical outlet.
Locate the hardware pack and identify the following parts required for assembly.
Parts List:
1. Owner's Manual
2. Base Assembly
3. Console Assembly
4. Left and Right Upright
5. Left and Right Fender
6. Safety Key (Reed Switch)
7. Left and Right Inside Handle Covers
8. Left and Right Outside Handle Covers
9. Allen Wrench
10. Philip Screw M6x12 (Qty. 6)
11. Philip Screw ST4.2x13 (Qty. 8)
12. Allen Bolt M8x15 (Qty. 8)
13. Washer 9x22x2 mm (Qty. 8)
RIOHTINSI_E HANDLE COVER
RIGHT OUTIII_E HANDLE COMER
1 1 _ t '1 I _ n ÷ i
PHILIP SCREW uBXI_ PHILIP _CREW
6F_B 8T4.2X18
/
f
BPCS
d_,.i
LeFTmiOeH_Omaovm <.,
,_ ALLEN W_ENOH
LEFT OUTSIDE HANDLE COVER
D a !
R_l_2 HER
iX2
Assembly
Assembly requires the included allen wrench. Do not plug in the power cord until all assembly steps are completed.
1. Place the left and right fenders through the tube of the left and right uprights as shown in Figure 1. Figure 1
CONSOLE
HARNE;
LEFTFENE
RIGHT FENDER
2. Slide the fenders up the upright assembly and pull the console harness through the hole in bottom of the left
upright tube as shown in Figure 2.
Figure 2
LEFT FENDER
CONSOLE
Assembly
3. Attach the console harness together from inside the left upright and base assembly as shown in Figure 3.
Next, attach left upright and right upright to base using allen bolts M8x15 (Qty. 8) and washer 9x22x2 mm
(Qty. 8). Do not tighten bolts.
Figure 3
_RIGHT UPRIGHT
LEFT
LEFT FENDER
WASHER
,22X2
p_
q\
CONSC \_'ALLENBOLT
HARNESS MS=ls
4. Attach the console assembly by connecting the console harness, incline harness, EKG harness, and speed harness as shown in Figure 4.
Next, attach the console assembly to the left and right uprights using philip screw M6x12 (Qty. 4).
Figure 4
LEFT UPRIGHT "j
CONSOLE-.
;REW
CONSOLE
HARNESS
RIGHT UPRIGHT _'j
Assembly
5. Attach left inside handle cover and left outside handle cover to left upright using philip screw ST4.2x13 (Qty. 3) as shown in Figure 5. Repeat assembly step for right side handle covers.
Figure 5
LEFT OUTSIDE HANDLE COVER
PHILIP SCREW
LEFT INSIDE HANDLE COVER
RIGHT OUTSIDE
RIGHT INSIDE
HANDLE COVER
HANDLE COVER
LEFT UPRIGHT"
UPRIGHT
6. Tighten all allen bolts (Qty. 8) installed in Step 3. Note: Move the fenders up to access the allen bolts.
Next, attach both left and right fenders to base using philip screw ST4.2x13 (Qty. 2) and philip screw M6x12
(Qty. 2).
Figure 6
BASE
PHILIP SCREW M6"12
PHILIPSCREW RIGHT FENDER
ST4.2x13
Assembly
C ongr atulations !! You have completed the assembly of your new Health Trainer 95t Treadmill.
Loading...
+ 21 hidden pages