Keys Fitness HT65T.1, HT65T.1-CE User Manual

Owner’s Manual

Health Trainer 65T Treadmill

Customer Service

(888) 340-0482

Keys Fitness Products

4009 Distribution Drive Suite 250 Garland, TX 75041

www.keysfitness.com

Model Name : HT65T.1/HT65T.1-CE

Serial Number :

Write down for future reference

Serial Number Decal Location

415-00019 02/06 Rev B

CAUTION! Read all precautions and

instructions in this manual before using this equipment.

Table of Contents

Important Safety Information 3

Before You Start 4

Assembly 5-9

Moving Instructions 10

Power Requirements 11

Console Panel Functions 12

Program Operation 13-14

Program Profiles 15

Monitoring Your Heart Rate 16-17

Warm Up Exercises 18

Changing to MPH or KM 19

Calibration Sequence 20

Belt Adjustment 21

Maintenance Instructions 22

Error Messages 23

Troubleshooting 24

Parts List 25-26

Exploded View 27-28

Warranty Information 29

Important Safety Information

WARNING! Before using this treadmill or starting any exercise program, consult your physician. This is espe-

cially important for persons over the age of 35 and/or persons with pre-existing health problems. The man-

ufacturer or distributor assumes no responsibility for personal injury or property damage sustained by or

through the use of this product.

WARNING! To reduce the risk of electrical shock, burns, fire, or other possible injuries to the user, it is impor-

tant to review this manual and the following precautions before operation.

SAFETY PRECAUTIONS AND TIPS

1. It is the owner's responsibility to ensure that all users of this treadmill have read the Owner's Manual and

are familiar with warnings and safety precautions.

2. This treadmill has a user maximum capacity of 275 pounds.

3. The treadmill should only be used on a level surface and is intended for indoor use only. The treadmill

should not be placed in a garage, patio, or near water and should never be used while you are wet. Keys

Fitness recommends a treadmill mat be placed under the treadmill to protect floor or carpet and for easier

cleaning.

4. Follow safety information in regards to plugging in your treadmill. Keep the power cord away from the

incline wheels and do not run the power cord underneath your treadmill. Do not operate the treadmill with a

damaged or frayed power cord.

5. Wear comfortable, good-quality walking or running shoes and appropriate clothing. Do not use the treadmill

with bare feet, sandals, socks or stockings.

6. Always straddle the belt and allow it to start moving before stepping onto the belt.

7. Hold on to handrail when adjusting speed, incline, or other controls.

8. Always examine your treadmill before using to ensure all parts are in working order.

9. Allow the belt to fully stop before dismounting.

10. Pets should never be allowed near or on the treadmill.

11. Do not leave children unsupervised near or on the treadmill.

12. Never operate the treadmill where oxygen is being administered, or where aerosol products are being used.

13. Never insert any object or body parts into any opening.

14. For safety and to prevent damage to your treadmill, no more than one person should use the treadmill at a

time.

15. Always unplug the treadmill before cleaning and/or servicing. Service to your treadmill should only be

performed by an authorized service representative, unless authorized and/or instructed by the manufacturer.

16. Failure to follow these instructions will void the treadmill warranty.

17. Never leave the treadmill unattended while it is running.

Before You Start

Thank you for purchasing the Health Trainer 65T Treadmill! This quality product you have chosen was

designed to meet your needs for cardiovascular exercise. Before you start, please read the Owner's Manual and

become familiar with the operation of your new treadmill.

Remember to take the time to perform the stretching exercises provided to avoid injury.

Do not stand on the walking belt while pressing the Power button or Start/Stop button.

Always adjust the speed of the treadmill in small increments as this treadmill is capable of high speeds.

If you are taking medication, consult your physician to see if the medication will affect your exercise heart

rate.

If you have heart problems, you are not active, and/or are over the age of 35 years, do not use the pre-set

treadmill programs or start an exercise program without first contacting and receiving approval from your

physician.

To avoid the risk of electrical shock, always keep the console dry. Do not spill liquids on the console. Keys

Fitness recommends a sealed water bottle for beverages consumed while using the treadmill.

Please review the following drawing below to familiarize yourself with the listed parts. This manual

covers several treadmills, so the one pictured below may not be identical to your particular model.

CONSOLE

SAFETY SWITCH

LATCH

MOTOR COVER

LEFT UPRIGHT

RIGHT UPRIGHT

TRANSPORT WHEEL

RUNNING BELT

Assembly

The Health Trainer 65T Treadmill will require assembly before operating. After opening the box, remove any packing material from the treadmill.

Do not throw away any packing materials until the unit is working properly.

Place the base on a clean, level surface. Make sure the electrical cord will easily reach an electrical outlet.

Locate the hardware pack and identify the following parts required for assembly.

Parts List:

1. Owner’s Manual

2. Base Assembly

3. Console Assembly

4. Left and Right Upright

5. Safety Key (Reed Switch)

6. Left and Right Fender

7. Left and Right Outside Handle Covers

8. Left and Right Inside Handle Covers

9. Allen Wrench

10. Philip Screw M6x12 (Qty. 6)

11. Philip Screw ST4.2x13 (Qty. 8)

12. Allen Bolt M8x15 (Qty. 8)

13. Washer 9x22x2 mm (Qty. 8)

12 13

Assembly

Assembly requires the included allen wrench.

Do not plug in the power cord until all assembly

steps are completed.

Step 1:

Place the left and right fenders through the tube

of the left and right uprights as shown in Figure 1.

Figure 1

Figure 2

Step 2:

Slide the fenders up the upright assembly and pull

the console harness through the hole in bottom of

the left upright tube as shown in Figure 2.

CONSOLE HARNESS

FENDER

UPRIGHT

Assembly

Figure 3

Figure 4

Step 3:

Connect the console harness from inside the left

upright to the console harness from the base

assembly as shown in Figure 3.

Next, attach left upright and right upright to base

using allen bolts M8x15 (Qty. 8) and washer

9x22x2 mm (Qty. 8). Do not tighten bolts all the

way at this time.

Step 4:

Attach the console assembly by connecting the

console harness, incline harness, EKG harness, and

speed harness as shown in Figure 4.

Next, attach the console assembly to the left and

right uprights using phillip screw M6x12 (Qty. 4).

CONSOLE HARNESS

ALLEN BOLT

WASHER

PHILLIP SCREW

CONSOLE

WIRE HARNESS

UPRIGHTS

Assembly

Step 5:

Attach left inside handle cover and left outside

handle cover to left upright using philip screw

ST4.2x13 (Qty. 3) as shown in Figure 5.

Repeat assembly step for right side handle covers.

Figure 5

Figure 6

Step 6:

Tighten all allen bolts (Qty. 8) installed in Step

3. Note: Move the fenders up to access the allen

bolts.

Next, attach both left and right fenders to base

using philip screw ST4.2x13 (Qty. 2) and philip

screw M6x12 (Qty. 2).

Move the treadmill to its final location (see sec-

tion titled “Moving Instructions”). Adjust the

leveler feet so that treadmill does not wobble

while in use.

PHILLIP SCREW

FENDER

LEVELER

FOOT

Assembly

Congratulations!!

You have completed the assembly of your new Health Trainer 65T Treadmill.

+ 21 hidden pages