KERN & SOHN LB 500-2 User Manual
Sauter GmbH
Ziegelei 1
LB
D-72336 Balingen
E-Mail: info@sauter.eu
Instruction Manual
LB DIGITAL LENGTH METER
Dimensions:
Small window behind the battery = Data output for printer
Tel: +49-[0]7433- 9933-199
Fax: +49-[0]7433-9933-149
Internet: www.kern-sohn.com
6. Left button L: With REF the device is ready for the
PRESET. By pressing and holding button L, PRESET
appears. Then L has to be pressed and rapidly released to
select the desired box, go to button R to set the value and
L has to be pressed to exit from the selection.
7. Left button L: W ith REF 1, button L has to be pressed
once to go to REF 2 or vice versa for setting any two
values.
Maintenance:
a) The working faces have to be kept clean and dry.
Prevent liquids from getting into the frame lest, because
the electronics might be damaged. In case that liquids
have got in, the frame has to be taken apart and dried up
under 60°C.
b) The scale body has to be cleaned with a soft fabric or
liquid sink soap. Do not use petroleum based lacquer
thinner, industrial alcohol or petroleum spirits. Organic
solutions are not allowed.
c) Never apply power pressure on any part of the scale lest
it damages the housing.
Fixing Instructions
Check to see if there has been any damage to the scale
unit. If so, please contact our company immediately.
Battery: UCAR Mod. CR2032 3Volt- already inserted
Functions
2. Right Button R: press and release rapidly for zeroing the
Length Meter
3. Right Button R: press and hold to switch off
4. Left button L: press and release rapidly change of
units from mm to inch values and vice versa
5. Lef t button L: press and hold, then R EF 1 is ready to
HOLD. Measurement is locked by pressing and rapidly
releasing the R button. To return to norm al values, HOLD
has to be taken off by pressing R and exit from REF 1 by
pressing L.
LB-BA-e-1310 1
1. Right Button R: press to switch on
2.
Loading...