Keri Systems EntraGuard Titanium Installation Guide

EntraGuard® Titanium Telephone Entry Controller
Installation Guide
This installation guide provides basic installation information, drawings, and controller setup instructions to use when installing the EntraGuard Titanium Telephone Entry controller. The EntraGuard Titanium controller may be used alone or may be connected to an access control network using PXL-500 or PXL-250 family controllers. For instructions on how to install a postal lock, see the EntraGuard Titanium Postal Lock Installation Application Note (P/N 01964-001).
NOTE: It is the responsibility of the installation organization to have only technically qualified personnel performing the installation.
Section 1 - Drawings Section 2 - RS-232 Serial Port Section 3 - Setup Controller Section 4 - Contact Keri Systems

1.0 Drawings

Figure 1: The EntraGuard Titanium Telephone Entry Enclosure
Page 1 of 6 P/N: 01551-001 Rev. B
EntraGuard® Titanium Telephone Entry Controller
Installation Guide
Figure 2: The Titanium Telephone Entry Controller
NOTE: Y ou must power down the unit before attempting to make or r emove any connections. Failure to do so will damage the controller.
NOTE: You must set Jumper 11 if you intend to use the Titanium controller’s internal modem.
Page 2 of 6 P/N: 01551-001 Rev. B
Loading...
+ 4 hidden pages