KEPCO Kit 219-0407 User Manual

INSTRUCTION MANUAL

KEPCO

An ISO 9001 Company.

KIT

219-0407

CA 400 MOUNTING EARS KIT

1. DESCRIPTION

This kit provides instructions and the hardware components required to install mounting ears on the CA 400 rack adapter.

2. INSTALLATION

2.1 MATERIAL SUPPLIED (See Table 1.)

TABLE 1. MATERIAL SUPPLIED

ITEM

• Ear Bracket 128-1791 2

• Handle 139-0229 2

• Ferrule 170-0001 4

KEPCO

PART NU MBER

QUANTITY

• Screw (10-32 X 0.005, ST., FLPO)
Attaches handle to ear brackets

• Screw (6-32 X 0.187, ST., FLPO)
Attaches ear brackets to CA 400 rack adapter

2.2 PROCEDURE (Refer to Figure 1.)

1. Remove any MST modules from the CA 400 rack adapter.

2. Attach handle to one ear bracket using two (2) screws (P/N 101-0396) and ferrule (P/N 170-0001).

3. Position mounting ear (with handle assembled) inside the rack adapter cover at one side, aligning the four (4) threaded
holes of the tab with the corresponding countersunk holes on the cover side panel; attach using four (4) flat head screws
(Kepco P/N 101-0407) provided.

4. Repeat above procedure for the other mounting ear.

101-0396 4

101-0407 8

FIGURE 1. MOUNTING EAR INSTALLATION, RIGHT SIDE (TYPICAL)

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] "

http://www.kepcopower.com " email: [e-mail]

©2001, KEPCO, INC 031901
Data subject to change without notice 228-1418

FAX [phone]