KEPCO ERD-150L User Manual

INSTRUCTION MANUAL

KEPCO

An ISO 9001 Company.

KIT

DIN ERD

-150L

DIN-RAIL MOUNTING KIT

FOR SERIES ERD 150W

DESCRIPTION. Kepco KIT, Model DIN ERD-150L, contains two preassembled mounting clips and associated hard-

ware used to install ERD 150 Watt Series power supplies on a DIN rail. The “L” suffix is for mounting along the long
dimension (length) as shown in Figure 1. Outline dimensions are shown in Figure 4.

FIGURE 1. L SUFFIX ORIENTATION

INSTALLING KIT. Attach the preassembled mounting clips to the power supply using the hardware supplied (see Fig-

ure 3). The clips may be mounted with the release lever on either side to facilitate removal.

INSTALLING POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both clamps
under one edge of the rail, then snap the other end of the two clips into place (see Figure 2A).

REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, use a screwdriver to
apply leverage towards the left as shown in Figure 2B to disengage each clip from the rail. Where mounting clips are
close together, it may be necessary to apply leverage with two screwdrivers simultaneously.

A — INSTALLATION

B — REMOVAL

FIGURE 2. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] " FAX [phone]

©1998, KEPCO, INC 1
Data subject to change without notice 228-1315

http://www.kepcopower.com " email: [e-mail]

FIGURE 3. INSTALLATION OF KIT ON ERD 150W POWER SUPPLY

FIGURE 4. ERD 150W POWER SUPPLY WITH KIT INSTALLED, OUTLINE DIMENSIONS

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] " FAX [phone]

http://www.kepcopower.com " email: [e-mail]

2 228-1315 062105