KEPCO ECMS User Manual

INSTRUCTION MANUAL

KEPCO

An ISO 9001 Company.

DIN-RAIL MOUNTING KIT

FOR SERIES ECM 16W

DESCRIPTION. Kepco KIT, Model DIN ECM-S contains

a cover, a mounting plate with left and right mounting
clips, and associated hardware (see Table 1) used to
install ECM Series 16W power supplies on a DIN rail.
The “S” suffix is for mounting along the short dimension
(width) as shown in Figure 1. Outline dimensions are
shown in Figure 5.

KIT

DIN ECM

-S

FIGURE 1. S SUFFIX ORIENTATION

TABLE 1. COMPONENTS SUPPLIED

KIT

MODEL NO.

DIN ECM-16S 108-0365 189-0692

INSTALLATION

1. INSTALL MOUNTING PLATE. Attach the mounting plate to the power supply using the hardware supplied
(see Figure 2). Install plate so that hole closest to edge is furthest from power supply terminals; and access
holes are not obstructed by power supply.

CLIP

(QTY 2)

PART NO.

MOUNTING PLATE

(QTY 1)

PART NO.

SCREW

(QTY 2)

PART NO.

101-0092

(4-40 X 0.312

BHPH)

WAS HER (QT Y

2)

PART NO.

103-0014

(NO. 4, INT.

TOOTH)

FIGURE 2. INSTALLING MOUNTING PLATE ON POWER SUPPLY

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] "

©1998, KEPCO, INC
Data subject to change without notice 228-1334 REV 1

http://www.kepcopower.com " email: [e-mail]

FAX [phone]

1

2. INSTALL CLIPS. Snap the two clips into the mounting plate holes (see Figure 3).

FIGURE 3. INSTALLING CLIPS ON MOUNTING PLATE

3. INSTALL POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both
clips under one edge of the rail, then snap the other end of the two clips into place (see Figure 4A).

REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, Insert a screw­driver into the access holes provided and apply leverage towards the left as shown in Figure 4B to disengage
each clip from the rail. Where mounting clips are close together, it may be necessary to apply leverage with two
screwdrivers simultaneously.

INSTALLATION

A

FIGURE 4. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL

B

REMOVAL

FIGURE 5. POWER SUPPLY WITH KIT INSTALLED, OUTLINE DIMENSIONS

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] "

2

http://www.kepcopower.com " email: [e-mail]

228-1334 REV 1 061801

FAX [phone]