KEPCO ECMP User Manual

INSTRUCTION MANUAL

KEPCO

DIN-RAIL MOUNTING KIT

DESCRIPTION. Kepco KIT, Model

DIN ECM-P contains a mounting
bracket with left and right preassem­bled mounting clips and associated
hardware used to install ECM Series
power supplies on a DIN rail. The “P”
suffix is for mounting the power sup­ply perpendicular to the DIN rail as
shown in Figure . Outline Dimensions
are shown in Figure 5.

An ISO 9001 Company.

FOR SERIES ECM

FIGURE 1. P SUFFIX ORIENTATION

KIT

DIN ECM

-P

TABLE 1. COMPONENTS SUPPLIED

KIT

MODEL NO.

DIN ECM-P 128-2053

MOUNTING

BRACKET

PART NO.

SCREW
(QTY 3)

(Power Supply To

Mounting Bracket)

PART NO.

101-0092

(4-40 X 5/16 BHPH)

WASHER (QTY 3)

(Power Supply To

Mounting Bracket)

PAR T N O .

103-0014

(NO. 4, INT.

TOOTH)

CLIP

(QTY 2)

PART

NO.

108-0366 128-1971

CLIP

PLATE

(QTY 2)

PART NO.

SCREW

Thread-form

(QTY 4)

(Clip To Mounting

Bracket)

PART NO.

101-0443

(4-40 X 1/4 BHPH)

WAS HE R

(QTY 4)

(Clip To

Mounting

Bracket)

PART NO.

103-0014

(NO. 4, INT.

TOOTH)

INSTALLATION

1. INSTALL MOUNTING BRACKET. Attach the mounting bracket to the power supply using the hardware sup-
plied (see Figure 2).

FIGURE 2. INSTALLING MOUNTING BRACKET ON POWER SUPPLY

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] "

©1998, KEPCO, INC
Data subject to change without notice 228-1408

http://www.kepcopower.com " email: [e-mail]

FAX [phone]

1

2. INSTALL CLIPS. Attach preassembled mounting clips into the mounting bracket holes using hardware
supplied (see Figure 3).

FIGURE 3. INSTALLING CLIPS ON MOUNTING BRACKET

3. INSTALL POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both
mounting clips under one edge of the rail, then snap the other end of the two clips into place (see Figure
4A).

REMOVAL

INSTALLATION

A

FIGURE 4. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL

B

REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, Insert a screw-

driver into the access holes provided and apply leverage towards the left as shown in Figure 4B to disengage
each clip from the rail. Where mounting clips are close together, it may be necessary to apply leverage with two
screwdrivers simultaneously.

FIGURE 5. POWER SUPPLY WITH KIT INSTALLED, OUTLINE DIMENSIONS

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] "

2

http://www.kepcopower.com " email: [e-mail]

228-1408 061801

FAX [phone]