KEPCO CA 39 User Manual

INSTRUCTION SHEET

KEPCO

An ISO 9001 Company.

CA 39

ENCLOSURES AND

HARDWARE SYSTEMS

DESCRIPTION. The Kepco Model CA 39 Cover (see Figure 1 below) is supplied for use with Kepco MTW 15W

Series Power Supplies. The easily installed, two-part steel cover is an option designed for shielding and protection.
Required installation hardware is provided. Refer to Figure 2 for outline dimensions.

1 Remove top cover from bottom cover by removing tape (not shown), disengaging tabs marked (A), and sliding

cover forward. Remove and retain hardware from poly bag (not shown) taped to bottom cover.

2 Position MTW 15W Power Supply over the four threaded spacers on the bottom cover marked (B), as indicated,

with input connector positioned towards cutout marked (E).

3 Fasten MTW 15W Power Supply to bottom cover with four 6-32 x 3/8 in. Phillips screws (PN 101-0156) marked

(C), and four #6 lockwashers (PN 103-0015).

4 Drop cover in place by engaging tabs marked (A) and sliding cover backward. Secure bottom cover to top cover

with two M3 x 5 screws (PN 101-0435) marked (D).

5 Connections to input and output connectors are via cutouts on top cover.

COVER

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] " FAX [phone]

©2006, KEPCO, INC
Data subject to change without notice

FIGURE 1. COVER INSTALLATION

http://www.kepcopower.com " email: [e-mail]

228-1566 REV 1

FIGURE 2. MECHANICAL OUTLINE DRAWING

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] " FAX [phone] " email: kepco-

041907 228-1566 REV 1 2