KEPCO CA 27 User Manual

INSTRUCTION MANUAL

KEPCO

An ISO 9001 Company.

CA 27

ENCLOSURES AND

HARDWARE SYSTEMS

I — DESCRIPTION

The Kepco Model CA 27 cover is supplied for use with the Kepco FAW 100Watt Series of switching power supplies. The easily installed once­piece steel cover is a separate option designed for shielding and protection. The cover is attached with one screw from the FAW 100W PCB
mounting.

II — INSTALLATION

1. Remove PCB mounting screw (A, Figure 1) along with lockwasher and flat washer, and set aside.

2. Attach cover: Engage the cut-out (B) on the cover with tab (B) on the FAW 100W chassis, apply a slight downward pressure at this inter­lock point and push the cover forward. When the CA 27 cover is properly installed, the PC board will fit into slit (D) (positioned between
the two dimple-like hinges) and slit (C) (positioned between two tab-like cut-outs). The mounting hole (A) in the cover will then line up with
the mounting hole (A) in the FAW PC Card.

3. Fasten cover with screw (A).

COVER

FIGURE 1. COVER INSTALLATION

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] " FAX [phone]

©2005, KEPCO, INC
Data subject to change without notice 228-1127 REV 1

http://www.kepcopower.com " email: [e-mail]

1

FIGURE 2. CA 27 COVER, MECHANICAL OUTLINE DIAGRAM

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL [phone] "

http://www.kepcopower.com " email: [e-mail]

2

228-1127 REV 1 030305

FAX [phone]