Kenwood Smoothie Concert, Smoothie Concert SB250 series Instructions Manual

HEAD OFFICE: Kenwood Limited, 1-3 Kenwood Business Park, New Lane, Havant, Hampshire PO9 2NH
56180/4
instructions
SB250 series
Y
ou can use your Smoothie Blender for
aking delicious and nutritious cold drinks. It’s easy to use and the s
moothie drink can be dispensed
d
irectly into a cup or glass. We’ve also included a stirring device to assist with the blending.
A selection of recipes can be found at the back of the instructions, but the handy markings on the goblet allow you to mix ingredients of your choice. Combinations of fruit and yoghurt (both fresh and frozen), ice cream, ice cubes, juice and milk can be used.
safety
Switch off and unplug:
before fitting and removing parts
after use
before cleaning.
Never let the power unit, cord or plug get wet.
Keep hands and utensils, other than the stirrer out of the goblet when it’s on the power unit.
Don’t touch sharp blades.
Never use a damaged machine. Get it checked or repaired : see ‘service’.
Never use an unauthorised attachment.
Never leave the machine on unattended.
When removing the Smoothie Blender from the power unit, wait until the blades have completely stopped.
Only operate the Smoothie Blender with the lid in place.
Never use the stirrer unless the lid is fitted to the goblet.
The unit may also be used for making soups but only blend cold ingredients.
Misuse of your Smoothie Blender can result in injury.
T
his appliance is not intended for
u
se by persons (including children) with reduced physical, sensory or m
ental capabilities, or lack of
e
xperience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.
before plugging in
Make sure your electricity supply is the same as the one shown on the underside of the appliance.
Important - UK only
The wires in the cord are coloured as follows: Blue = Neutral Brown = Live.
The appliance must be protected by a 13A approved (BS1362) fuse.
Note:
For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).
If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet.
English
2
T
his appliance conforms to EC directive 2004/108/EC on E
lectromagnetic Compatibility and E
C regulation no. 1935/2004 of 27/10/2004 on materials intended f
or contact with food.
b
efore using for the first time
1
Remove all the packaging .
2 Wash the parts: see ‘cleaning’.
key
stirrercaplidhandlegobletsealing ringblade assemblypower unittap assembly
to use your smoothie blender
1 Fit the sealing ring over the blade
assembly.
2 Screw the goblet onto the blade
unit.
3 Screw the tap assembly onto the
goblet. Check that the dispensing tap lever is in the off position .
4 Place the assembled goblet on the
power unit.
5 Place the liquid ingredients into the
goblet.
This includes fruit (not frozen), fresh yoghurt, milk and fruit juices. These can be placed into the goblet to the level marked LIQUIDS for either 2 or 4 servings.
6 Add ice or frozen ingredients to the
goblet.
This includes frozen fruit, frozen yoghurt, ice cream or ice. These can be added up to the level marked FROZEN INGREDIENTS for the corresponding number of servings.
7 Screw the lid onto the goblet. 8 Either put the cap into the lid, then
turn. Or place the stirrer in the hole.
The stirrer can be used when blending thick mixtures or when large quantities of frozen items are used.
9
Press the MIX button for up to 30 seconds, this is to start the mixing p
rocess, then press the SMOOTH
b
utton. Allow the ingredients to
blend until smooth.
U
se the stirrer by moving it in an anti
c
lockwise direction.
10 Place a glass underneath the tap,
p
ress the MIX button and press
d
own on the dispensing tap lever.
Thinner drinks may dispense without having to switch on the power unit.
Use the stirrer to assist when dispensing thick smoothie drinks.
To help dispense the last amount of a thick smoothie drink, add a few tablespoons of liquid to increase the flow.
When the glass is full, switch off and release the lever. OR Switch off, remove the goblet and pour the drink.
hints
To make a thinner smoothie drink add more liquid.
To make a thicker smoothie drink add more frozen ingredients but do not exceed the frozen limit marked on the goblet.
Before fitting the lid, push the solid ingredients into the liquid using the stirrer.
Use the PULSE button to operate the power unit in a start stop action to control the texture of your drink. Take care as this automatically selects the higher speed and may cause the drink to be thrown up the sides and onto the lid of the goblet.
After blending, some drinks may not be completely smooth due to seeds or the fibrous nature of ingredients.
Some drinks may separate on standing, therefore it’s best to drink them straight away. Separated drinks should be stirred before drinking.
3
Loading...
+ 6 hidden pages