Kenwood NX-300, NX-200 User Manual

NX-200/300

NEXEDGE™VHF/UHF Digital & FM Portable Radios

GENERAL FEATURES

5 W (136-174 MHz) Models

• 5 W (400-470, 450-520 MHz) Models

•

• 512 CH-GID / 128 Zones

• 12-Key Keypad Models 14 Character Alphanumeric Aliases

•

• Backlit Dot Matrix LCD 3-Digit Sub-Display

•

• Function/Status LCD Icons RSSI Indicator

•

• Date & 12/24 Hour Time Clock

• Transmit/Busy/Call Alert/Warn LED

• On/Off Volume Knob

• 16-Position Mechanical Selector

• 6 Front PF & Menu Keys

• 2 Side PF Keys

• Emergency/AUX Key

• 500 mW Speaker Audio

• VOX Ready

• Emergency Call Features

• Emergency Man-Down Option

• Lone Worker

• Multi-Language Display

• Programmable TX/RX Indication (On/Off)

• Special Alert Tone Patterns

• Time Out Timer

• Busy Channel Lockout

• LCD Battery Status Indicator

• Low Battery Alert

• Battery Saver

• Weather-sealed ACC Connector

• MIL-Spec Speaker Mic Options

• KMC-38GPS Speaker Mic Option

• KPG-111D Windows

• Flash Firmware Upgrading

FPU

• Front Panel Test & Tune

• Cloning

• MIL-STD-810 C/D/E/F

• MIL-STD “Driven-Rain”

• IP-54/55 Water & Dust Intrusion

• Easy Option Port

• PC Serial Interface

• SDM Manual Input

• Transparent Data Mode

• Intrinsically Safe Option

• VGS-1 Voice Guide/ Voice & GPS Data

Storage Option

DIGITAL – COMMON

• NXDN®Digital Air Interface

• AMBE+2

• 6.25 & 12.5 kHz Channels

• Over-the- Air Alias

• Paging Call

• Emergency Call

• All Group Call

• Status Messaging

• Remote Stun/Kill

• Remote Check

™

VOCODER

• Short & Long Data Messages GPS Location with Voice

•

NXDN

•

crambler Included (Conventional: per CH)

DIGITAL – CONVENTIONAL MODE

64 Radio Access Numbers (RAN)

•

• DTMF (Encode/Decode)

Individual & Group Selective Call

•

• Mixed FM/Digital Operation

DIGITAL – TRUNKING MODE

• Individual Private Call

• Group Call

• Broadcast Call

• Transmission Trunked Mode

• Message Trunked Mode

• Call Queuing with Priority

• Call Queue Pre-emption

• Late Entry (UID & GID)

• 4 Priority Monitor ID’s

• Remote Group Add

• Failsoft Mode

• Multi-Site IP Network Compatible

SCAN

• Single Zone / Multi-Zone / List Scan

• Dual Priority Scan (Conventional)

FM MODES – GENERAL

• 25 & 12.5 kHz Channels

• FleetSync

• DTMF Encode / Decode

• Companded Audio

• Voice Inversion Scrambler

• Encryption/ANI Board Control

/II

FM CONVENTIONAL ZONES

• QT / DQT

• Two-Tone Decode

• Single/Two-Tone Encode

• Call Key 1-6

• Operator Selectable Tone

FM LTR®TRUNKED ZONES

• Kenwood LTR®Features

FleetSync®/II (FM)

• PTT ID Digital ANI

• Selective Call & Group Call

• Status Messaging

• Emergency Status

• Caller ID Display

• Short Text Messages

• Power On/Off Status Messages

• Send/Display GPS (KMC-38GPS)

• PTT ID & Emergency GPS Reporting

• Status Message Block GPS Reporting

http://nexedge.kenwood.com

Options

JQA-QMA1205

■ KNB-47L

i-Ion Battery

1950mAh)

(

■ KNB-48L

i-Ion Battery

L (2550mAh)

■ KNB-50NC

Ni-MH Battery (2000mAh) Intrinsically Safe

■ KSC-32

ri-Chemistry Rapid

ate Charger

■ KSC-326

Rapid Rate Six Unit Charger for Ni-Cd/Ni-MH/Li-ion

KNB-48L

■ KMC-41M

IL-STD & IP 54/55

peaker Microphone

■ KMC-38GPS

GPS Speaker Microphone

■ KHS-11

eavy Duty Earphone

■ KEP-1

Heavy Duty Earphone

Main Specifications

GENERAL

requency Range Type 1 136-174 MHz 450-520 MHz

Number of Channels 512 Zones 128

ax. Channels per Zone 250

M Channel Spacing Analog 12.5 / 15 / 25 / 30 kHz 12.5 / 25 kHz

perating Voltage 7.5V DC ± 20%

O Battery Life ( with KNB-48L) 5-5-90 Approx. 14.5 hours

perating Temperature Range

O Frequency Stability ± 2.0 ppm ± 1.0 ppm Antenna Impedance 50 Dimensions (W x H x D) Projections not included

Weight (net) Radio only 8.82 oz (250 g)

FCC ID Type 1 ALH378400 ALH378500

IC Certification Type 1 282D-378400 282D-378500

ype 2 400-470 MHz

Digital 6.25 / 12.5 kHz 6.25 / 12.5 kHz

10-10-80 Approx. 9.0 hours

adio only

R with KNB-47L with KNB-48L

with KNB-47L 13.23 oz (375 g) with KNB-48L 14.29 oz (405 g)

Type 2 ALH378501

Type 2 282D-378501

NX-200 NX-300

30˚ C to +60˚ C

22˚ F to +140˚ F (

Ω

.28 x 5.02 x 1.63 in (58 x 127.5 x 41.3 mm)

2.28 x 5.02 x 1.63 in (58 x 127.5 x 41.3 mm)

2.28 x 5.02 x 1.91 in (58 x 127.5 x 48.5 mm)

■ KRA-22/23

HF/UHF Helical Antenna

■ KRA-26/27

HF/UHF Whip Antenna

RA-16/17

■ K

HF/UHF Stubby Antenna

■ KRA-25

HF High Gain Antenna

ontact an authorized Kenwood dealer for details and complete list of all accessories and options.

■ KRA-28

HF Broad

and Antenna

■ VGS-1

oice Guide

Storage Unit

■ KBH-11

elt Clip (2.5")

All accessories and options may not be available in all markets.

NX-200 NX-300

RECEIVER

Sensitivity Digital @ 6.25kHz (3% BER) 0.20 µV

Selectivity Analog @ 25 kHz 72 dB

Intermodulation Distortion Spurious Response Analog 70 dB

udio Distortion Less than 3%

A Audio Output 500 mW / 8 Ω TRANSMITTER

)

RF Power Output 5 W / 1 W Spurious Response 70 dB

M Hum & Noise Analog @ 25 kHz 45 dB

Audio Distortion Less than 3% Modulation 16K0F3E, 11K0F3E, 8K30F1E,

Analog meas urements made per TIA/E IA 603 and specifi cations shown are typical. Kenwood reserves the right to change specifications without prior notice or obligation.

FleetSync®is a registered trademark of Kenwood Corporation.

LTR

is a registered trademark of Transcrypt International.

AMBE+2

is a trademark of Digital Voice Systems Inc.

Windows

is a registered trademark of Microsoft Corporation.

is a trademark of Kenwood Corporation and Icom Inc.

NXDN

NEXEDGE

is a trademark of Kenwood Corporation.

igital @ 12.5kHz (3% BER) 0.25 µV

D Analog (12 dB SINAD) 0.25 µV

nalog @ 12.5 kHz 65 dB

A Analog 70 dB (±50,100 kHz)

nalog @ 12.5 kHz 40 dB

8K30F1D, 8K30F7W, 4K00F1E, 4K00F1D, 4K00F7W, 4K00F2D

Applicable MIL-STD & IP

MIL Standard MIL 810C MIL 810D MIL 810E MIL 810F

Low Pressure 500.1/Procedure I 500.2/Procedure I, II 500.3/Procedure I, II 500.4/Procedure I, II High Temperature 501.1/Procedure I, II 501.2/Procedure I, II 501.3/Procedure I, II 501.4/Procedure I, II Low Temperature 502.1/Procedure I 502.2/Procedure I, II 502.3/Procedure I, II 502.4/Procedure I, II Temperature Shock 503.1/Procedure I 503.2/Procedure I 503.3/Procedure I 503.4/Procedure I, II Solar Radiation 505.1/Procedure I 505.2/Procedure I 505.3/Procedure I 505.4/Procedure I Rain 506.1/Procedure I, II 506.2/Procedure I, II 506.3/Procedure I, II 506.4/Procedure I, III Humidity 507.1/Procedure I, II 507.2/Procedure II, III 507.3/Procedure II, III 507.4 Salt Fog 509.1/Procedure I 509.2/Procedure I 509.3/Procedure I 509.4 Dust 510.1/Procedure I 510.2/Procedure I 510.3/Procedure I 510.4/Procedure I, III Vibration 514.2/Procedure VIII, X 514.3/Procedure I 514.4/Procedure I 514.5/Procedure I Shock 516.2/Procedure I, II, V 516.3/Procedure I, IV 516.4/Procedure I, IV 516.5/Procedure I, IV

International Protection Standard

Dust & Water Protection IP54/55

Methods/Procedures Methods/Procedures Methods/Procedures Methods/Procedures

Kenwood has always connected with people through sound. Now we want to expand the world of sound in ways that only Kenwood can, listening to our customers and to the pulse of the coming age as we head toward a future of shared discovery, inspiration and enjoyment.

footnotes from Front:

Requires NX subscriber unit PC Serial Interface compatible software application (e.g Kenwood AVL & Dispatch Messaging software) or hardware (e.g. console).

These trunked features are primarily system programming and operational dependent. Priority Monitor also requires NX subscriber settings.

ADS#11309 Printed in USA