Kenwood KPA-H2H User Manual

Page 1
Page 2
Safety precautions
Caution
Take the following precautions to keep the unit in proper working order:
• Installation must be performed according to this installation manual. Kenwood is not responsible for issues arising from installations not performed according to the procedures in this manual.
• Use only the included power supply.
NOTE
Use of the included antenna inside a home requires placement at a North-, West-, or East-facing window (depending on where you live). If a proper window location is not available, the antenna must be placed outside the home, away from any overhead obstructions. See pg. 6, step 5 for details.
Box contents
Unpack your KPA-H2H kit carefully and make sure that everything listed here is present:
1 x Cradle 1 x Base 1 x Antenna
1 x Power Supply 1 x AC Cord 1 x Audio Cable 1 x Hardware Bag
If anything is missing or damaged, or if your KPA-H2H fails to operate, notify your dealer immediately. If your KPA-H2H was shipped to you directly, notify your shipper immediately. Kenwood recommends that you retain the original carton and packing materials in case you need to ship your KPA-H2H in the future.
KPA-H2H Installation GuideKPA-H2H Installation Guide
2 3
Page 3
Installation in a home (continued)
KPA-H2H Installation Guide
5
Installation in a home
Note: Do not put Here2Anywhere in the docking station until you have completed the installation.
KPA-H2H Installation Guide
4
1. Using the provided screw, assemble the docking station cradle to the base.
4. Plug the antenna into the back of the docking sta­tion until it is firmly seated, as shown.
2A. Plug the audio cable’s mini
connector into the back of the docking station, as shown.
2B. Plug the audio cable’s white
(L ch,) and red (R ch.) connec­tors into your audio system.
3. Plug the AC cord into the power supply, then plug the power supply into the back of the docking station, as shown. Don’t plug the AC cord into a wall outlet until the installation is completed.
Page 4
3. Due to the moving paths of the SIRIUS satellites, it is possible for the signal to change over time. In most cases, signal should be available continuously, however, it may be temporarily blocked in some antenna locations in home installations. Be sure to check the the Antenna Signal screen if there is a loss of signal or audio. Experimentation with antenna placement in the home or outside may be necessary to ensure continuous reception.
KPA-H2H Installation Guide
7
KPA-H2H Installation Guide
6
5. For best reception of the satellite signal, place the included antenna near a window. Use the map on page 7 as a general placement guideline—some experimentation may be needed to obtain the best results. Due to the paths of the SIRIUS satellites over the US, the best window for the antenna in your home depends on where you live. Locate the antenna based on which section of the country you live in according to the map on page 7.
Section 1: Place the antenna at an
EAST-FACING window
Section 2: Place the antenna
OUTSIDE, away from any over-
head obstructions
Section 3: Place the antenna at a
WEST-FACING window
Section 4: Place the antenna at a
NORTH- or EAST-FACING window
Section 5: Place the antenna at a
NORTH-FACING window
Section 6: Place the antenna at a
WEST- or NORTH-FACING
window
• In major US cities, you may also be able to receive the signal
from SIRIUS ground repeaters, which may allow you to place the antenna away from a window.
• No matter where you live, since the antenna is weather-proof
you can also locate it outside, clear of any overhead
obstructions. (This is especially important if your house has an extended roof or extended window frame structures.)
Using the Antenna Signal Screen
This screen shows the quality of the SIRIUS satellite signal that’s being received, to help you find the best location for the antenna.
1.Enter the Setup Mode by holding the POWER button for at least 1 second, then press the left or right arrow button until the Antenna Signal screen appears (
below
):
After a few seconds the signal quality bars will indicate how well the antenna is receiving the SIRIUS satellite signal.
2. Find a location for the antenna that illuminates the maxi-
mum number of bars.
• After moving the antenna, wait at least 2 seconds before moving it again, to enable the unit to process the signal.
4
Installation in a home: Placing the antenna
5 6
32
1
Page 5
Loading...