Kenwood KDC-U7053BT, KDC-U7053BTL User Manual

Kenwood KDC-U7053BT, KDC-U7053BTL User Manual

KDC-U7053BT KDC-U7053BTL

CD-RECEIVER

Quick Start Guide

© 2011 JVC KENWOOD Corporation

B59-2129-10/01 (MW)

Contents

Before use

Before use..............................................................

2

Preparations..........................................................

4

Basic operations..................................................

6

Playing music (CD/USB/iPod).........................

7

Listening to the radio........................................

8

Hands-free phoning...........................................

9

Installation accessories...................................

10

Before installation.............................................

10

Connecting wires to terminals.....................

12

Installation/Removal of the unit.................

14

Installing the Microphone Unit ..................

15

Appendix ............................................................

15

2 | Quick Start Guide

2 WARNING

To prevent injuries or a fire, take the following precautions:

Stop the car before operating the unit.

To prevent a short circuit, never put or leave any metallic objects (such as coins or metal tools) inside the unit.

¤ CAUTION

Adjust the volume so that you can hear sound outside the car. Driving with the volume adjusted to a too high level may cause an accident.

Wipe off the dirt on the panel with a dry silicon or soft cloth.

Failure to observe this precaution may result in damage to the monitor or unit.

Cleaning the connector

The unit may not function properly if the connector between the unit and faceplate are dirty. Detach the faceplate and clean the connector with a cotton swab gently, being careful not to damage the connector.

Connector

Condensation

When the car is air-conditioned, moisture may collect on the laser lens.This may cause disc read errors. In this case, remove the disc and wait for the moisture to evaporate.

Notes

If you experience problems during installation, consult your Kenwood dealer.

When you purchase optional accessories, check with your Kenwood dealer to make sure that they can work with your model and in your area.

Characters that conform to ISO 8859-1 can be displayed.

To display characters in the following language, additional setting is required.

 KDC-U7053BT 

- Chinese

Refer to“Chinese”of <Initial settings> (page 21).

 KDC-U7053BTL 

-Arabic

-Persian

-Thai

Refer to“TAG Language”of <Initial settings> (page 21).

About the discs used with this unit

play the CDs with

.

The following discs cannot be used: -- A disc that is not round

-- A disc with coloring on the recording surface or a disc that is dirty

-- A recordable/rewritable disc that has not been finalized (For the finalization process, refer to the instruction manual that came with your disc writing software or your disc recorder.)

-- An 8 cm (3 inch) disc (An attempt to insert using an adapter can cause malfunction.)

Handling discs

Do not touch the recording surface of the disc.

Do not stick tape etc. on the disc, or use a disc with tape stuck on it.

Do not use any accessories for the disc.

Do not use any solvents to clean discs. Use a dry silicon or soft cloth.

Clean the disk by moving the cloth outward from the center of the disc.

When removing a disc from this unit, pull it out horizontally.

If the center hole or outside rim of a disc has burrs, remove them before inserting a disc.

How to reset your unit

If the unit fails to operate properly, press the Reset button.The unit returns to the factory settings when the Reset button is pressed.

Reset button

The illustrations of the display and panel appearing in this manual are examples used to explain more clearly how the controls are used. Therefore, what appears on the display in the illustrations may differ from what appears on the display on the actual equipment, and some of the images on the display may be inapplicable.

¤CAUTION

Keep battery out of reach of children and in original package until ready to use. Dispose of used batteries promptly. If swallowed, contact a physician immediately.

Do not leave the battery near fire or under direct sunlight. A fire, explosion or excessive heat generation may result.

Do not set the remote control in hot places such as on the dashboard.

The Lithium battery is in danger of explosion if replaced incorrectly. Replace it only with the same or equivalent type.

English | 3

Preparations

Release

Control knob (Volume knob)

 

 

 

 

 

 

 

 

 

 

[DISP]

 

 

Before using this unit for the first

20) of Instruction manual

time

 

 

When this unit is first turned on, the interactive menu appears for setting the interface language and demonstration mode. This menu disappears when no action is taken for 15 seconds.

1KDC-U7053BTL only:

Select the interface language to display the menu items of the Function setting, from English and Persian.

Turn the Control knob to select the language, and then press the Control knob.

2KDC-U7053BTL only:

If you selected English in step 1, select the language to display the audio file information, from English, Arabic and Thai. (Persian is automatically selected if you selected Persian in step 1.)

3Press the Control knob when the message“To cancel DEMO Press the volume knob”is displayed.

4Turn the Control knob to select“YES”, and then press the Control knob.

The interface language and demonstration mode can also be set with the Function setting. Refer to <Initial settings> (page 21) and

<Demonstration mode setting> (page

4 | Quick Start Guide

Adjusting the clock

1Press the [DISP] button several times to display the clock.

2Press and hold [DISP] button.

3Turn the Control knob to adjust the hour, and then press the Control knob.

4Turn the Control knob to adjust the minute, and then press the Control knob.

Detaching/ Reattaching the faceplate

Press the Release button.

¤

Remove the faceplate at once after pressing the Release button; otherwise it can fall down due to vibration.

The faceplate is a precision component of the unit and can be damaged by shocks or jolts.

Keep the faceplate in its case while detached.

Do not place the faceplate (and case) in areas exposed to direct sunlight, excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing.

English | 5

Loading...
+ 11 hidden pages