Kenwood FP250 User Manual

FP250 series
+

+
+
a
b
b
Read these instructions carefully and retain for future reference.
Remove all packaging and any labels.
safety
he blades and discs are very sharp, handle with care. Always
T
old the knife blade by the finger grip at the top,
h away from the cutting edge, both when handling and
leaning.
c
lways remove the knife blade before pouring contents from the
A bowl.
eep hands and utensils out of the processor bowl and liquidiser
K
ug whilst connected to the power supply.
j
Switch off and unplug:
efore fitting or removing parts
b
fter use
a
before cleaning
Never use your fingers to push food down the feed tube. Always use the pusher/s supplied.
Before removing the lid from the bowl or liquidiser from the power unit:-
switch off;
wait until the attachment/blades have completely stopped;
Be careful not to unscrew the liquidiser jug from the blade unit.
Liquids should be allowed to cool to room temperature before blending.
Do not use the lid to operate the processor, always use the on/off speed control.
This machine will be damaged and may cause injury if the interlock mechanism is subjected to excessive force.
Never use an unauthorised attachment.
Never leave the machine on unattended.
Never use a damaged machine. Get it checked or repaired: see ‘service’.
Never let the power unit, cord or plug get wet.
Don’t let excess cord hang over the edge of a table or worktop or touch hot surfaces.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.
Misuse of your processor/liquidiser can result in injury.
Refer to the relevant section under “using the attachments” for additional safety warnings for each individual attachment.
before plugging in
Make sure your electricity supply is the same as the one shown on the underside of your machine.
mportant – UK only
I
he wires in the cord are coloured as follows:
T Green and Yellow = Earth, Blue = Neutral,
rown = Live.
B
The appliance must be protected by a 13A approved (BS1362) fuse.
ARNING: THIS APPLIANCE MUST BE EARTHED.
W Note:
For non-rewireable plugs the fuse cover MUST be refitted when
eplacing the fuse. If the fuse cover is lost then the plug must not
r be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained
rom your Kenwood Authorised Repairer (see Service).
f
If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an
nwanted non-rewireable pug is inadvertently inserted into a 13A
u socket outlet.
This appliance conforms to EC directive 2004/108/EC on Electromagnetic Compatibility and EC regulation no. 1935/2004 of 27/10/2004 on materials intended for contact with food.
before using for the first time
1 Remove all packaging including the plastic blade covers from the
knife blade. Take care the blades are very sharp. These covers should be discarded as they are to protect the blade
during manufacture and transit only. 2 Wash the parts see ‘cleaning’ 3 Push excess cord into the back of the machine.
key
processor
pusherfeed tubelidbowldetachable drive shaftspeed + pulse controlpower unitsafety interlockcord storage
liquidiser
blade unitsealing ringjugfiller caplid
attachments
knife bladedough tooltwin beater geared whiskthick slicing/coarse shredding discthin slicing/fine shredding discrasping disc
geared citrus press (if supplied)
2
Loading...
+ 5 hidden pages