Kenwood CH580 series Instruction Manual

English 2 - 7
HEAD OFFICE: Kenwood Limited, 1-3 Kenwood Business Park, New Lane, Havant, Hampshire PO9 2NH
40238/4
instructions
CH580 series TYPE CH58
´¸∂w
safety
Read these instructions carefully and retain for future reference.
The blades are very sharp, handle with care.
Always hold by the finger grip at the top, away from the cutting edge, both when handling and cleaning.
Switch off and unplug:
before fitting or removing parts
after use
before cleaning.
Always wait for the blades to completely stop before removing the power unit from the bowl.
Always remove the knife blade(s) before emptying or pouring contents from the bowl.
Never use a damaged appliance. Get it checked or repaired: see ‘service and customer care’.
Never let the power unit, cord or plug get wet.
Don’t let excess cord hang over the edge of a table or worktop or touch hot surfaces.
Never leave the appliance on unattended.
Misuse of your food chopper can result in injury.
Never use an unauthorised attachment.
Children should be supervised to ensure that they do not play with the appliance.
English
2
Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved.
This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.
Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.
3
before plugging in
Make sure your electricity supply is the same as the one shown on the underside of the appliance.
Important - UK only
The wires in the cord are coloured as follows: Blue = Neutral Brown = Live.
The appliance must be protected by a 3A approved (BS1362) fuse.
Note:
For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).
If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet.
This appliance conforms to EC directive 2004/108/EC on Electromagnetic Compatibility and EC regulation no. 1935/2004 of 27/10/2004 on materials intended for contact with food.
before using for the first time
Remove all packaging and any labels including the plastic blade covers from the knife blade. Take
care the blades are very sharp. These covers should be
discarded as they are to protect the blade during manufacture and transit only.
Wash the parts: see ‘cleaning’.
key
speed selectorpower unitcord gripcoverupper knife bladefinger griplower knife bladebowllocating pinbowl basemayonnaise dripper (if supplied)
to use your food chopper
The knife blade unit comes in 2 p
arts, a lower and an upper blade.
For coarser chopping use the lower blade on its own.
F
or finer chopping or pureeing use both blades together. This will also give a faster result. To use both blades fit the upper blade onto the lower blade and turn anti-clockwise to locate in place . Take care as the blades are sharp. Note: After processing food, the upper blade may disengage from the lower blade. This is normal as the blade assembly is designed to be loose fitting to ease separation after use.
1 Put the bowl base on the bottom of
the bowl. (This stops the bowl sliding on the work top).
2 Place the unit on a clean, flat
surface.
3 Fit the desired knife blade assembly
into the bowl over the locating pin .
4 Cut the food into suitably sized
pieces and place in the bowl. Larger pieces of food should be cut into approximately 1 to 2 cm pieces.
5 Fit the cover and turn clockwise to
lock into place .
6 Place the power unit onto the cover. 7 Connect to the power supply and
press down on the speed selector to select the desired speed. When operating the power unit, hold it firmly on the cover and bowl.
Press the speed selector lightly to obtain speed 1.
Press the speed selector firmly to obtain speed 2.
Alternatively the speed selector may be pressed down for short periods of time to produce a pulsing action. This can be used to avoid over processing food.
8 Operate the food chopper until the
desired result is achieved.
9 Switch off and unplug after use. 10 Reverse the above procedure to
dismantle the unit.
i
mportant
If preparing food for babies or young c
hildren, always check that the
i
ngredients are thoroughly blended
before feeding.
D
o not run the food chopper
c
ontinuously for longer than 10 seconds. Leave to cool for 1 minute i
n between each 10 second
o
peration.
Do not operate the food chopper if the bowl is empty.
Never operate the food chopper with the bowl filled with liquid.
Always allow hot food to cool before processing.
hints
If the chopper labours, remove some of the mixture and continue processing in several batches, otherwise you may strain the motor.
Remember that chopping hard foods such as coffee beans, spices, chocolate or ice will wear the knife blades faster.
Beware of over processing some ingredients. Stop and check the consistency frequently.
Various spices such as cloves, dill and cumin seeds can have an adverse effect on the plastic of your food chopper.
To ensure even processing, stop and scrape down any food from the side of the bowl with a plastic spatula.
The best results are obtained by chopping small quantities at one time.
Cut larger pieces of food into 1-2cm pieces. A large load or large pieces may cause uneven results.
Before chopping nuts, herbs, breadcrumbs etc, ensure that both the food and the blade, bowl and cover are thoroughly dry.
to use the mayonnaise dripper
(if supplied)
Please refer to the mayonnaise recipe in the recipe section for information on how to assemble and use the mayonnaise dripper.
4
Loading...
+ 9 hidden pages