Kenmore 66517749K014, 66517749K015, 66517749K016, 66517742K015, 66517742K016 Installation Guide

...

iNSTALLATiON iNSTRUCTiONS

PORTABLEDISHWASHER

PLASTICGIANT TUB MODELS

INSTRUCCIONES DE INSTALACION

LAVAVAJ1LLAS PORTATIL

MODELOS CON TINA GIGANTE DE PLASTICO

iNSTRUCTiONS D'INSTALLATION

LAVE-VAISSELLEENCASTRE

MODELES A TRESGRANDE CUVE EN PLASTIQUE

Table of Contents ................................................ 2

{ndice ........................................................... 6

Table des mati_res .............................................. 11

W10275511A

Table of Contents

Dishwasher Safety ............................................2

InstallationRequirements .....................................3

Toolsand Parts...............................................3

Location Requirements .......................................3

Water Supply Requirements ..................................3

ElectricalRequirements ......................................3

Caster Installation.............................................3

Prepare the Dishwasher .......................................4

Connecting Dishwasher ....................................... 4

Connecting faucet adapter ................................... 4

Connecting to water and electrical supply ..................... 5

Using the faucet .............................................. 5

Disconnecting the dishwasher ................................ 5

Storing ........................................................ 5

Storing for the summer ....................................... 5

Winterizing your dishwasher .................................. 5

DISHWASHERSAFETY

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.

This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING." These words mean:

You can be killed or seriously injured if you don't immediately follow instructions•

You can be killed or seriously injured if you don't follow

instructions•

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.

You Need fo:

• Slowly open dishwasher door while someone grasps the rear of the dishwasher. Remove shipping materials, drain hose and lower

rack. Close dishwasher door until latched.

• Observe all governing codes and ordinances.

• Prepare dishwasher and faucet for use as specified in these instructions.

Tip Over Hazard

Do not use dishwasher unti_ completely installed• Do not push down on open door•

Doing so can result in serious injury or cuts•

• Have everything you need to properly install dishwasher. The dishwasher must be installed to meet all electrical and plumbing

national and local codes and ordinances.

iNSTALLATiON REQUIREMENTS CASTERiNSTALLATiON

Tools and Parts

Gather the recommended tools and parts before starting installation. Read and follow the instructions provided with any tools

listed here.

All installations

Tools needed:

,,ers

Parts supplied:

! Part Numbe[ 3374592 J cas,es 1 Literature I

Faucet adapter kit, i ]

Make sure all these parts were included in the parts bag. Close and latch dishwasher door. See parts list for accessories available for your

dishwasher.

NOTE: Parts are available for purchase in plumbing supply stores. Check local codes. Check existing electrical supply. See "Electrical Requirements" section. It is recommended that electrical connections be made by a licensed electrical installer.

Use two or more people to move and install

dishwasher•

Failure to do so can result in back or other injury.

Excessive Weight Hazard

Location Requirements

• Grounded electrical supply is required.

• Sink or laundry tub that can drain water at a minimum carry-away capacity of 7 gal. (26 L) per minute.

• Top of sink or laundry tub that is at least 27" (68.6 cm) high and not higher than 48" (122 cm) from the bottom of dishwasher.

• Floor support for dishwasher weight of 180 Ibs (81.6 kg).

• Grounded electrical outlet.

• Hot water faucet or hot and cold single-spout water faucet

within 30" (76.2 cm) of the back of dishwasher.

• 20-120 psi ( 103-827 kPa) water pressure.

Water Supply Requirements

• A hot water line with 20-120 psi (138-862 kPa) water pressure can be verified by a licensed plumber.

• 120°F (49°C) water at dishwasher.

Electrical Requirements

Be sure that the electrical connection and wire size are adequate and in conformance with the National Electrical Code, ANSl/NFPA

70 - latest edition and all local codes and ordinances. A copy of the above code standards can be obtained from:

National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02269 You must have:

• 120-volt, 60 Hz, AC-only, 15- or 20- amp, fused electrical supply.

• mating grounded electrical outlet.

We recommend:

• a time-delay fuse or circuit breaker.

• a separate circuit.

Using two or more people, grasp sides of dishwasher door frame and put dishwasher on its back.

Firmly push casters into holes at corners of dishwasher as shown. Pull on each caster to check that casters are snug.

Helpful Tip: It may be helpful to place a piece of wood between

the caster wheels and then lightly tap the wood with a hammer.

PREPARETHEDISHWASHER

Tip Over Hazard

Do not use dishwasher until completely installed• Do not push down on open door•

Doing so can result in serious injury or cuts•

1.Remove the screen holder or aerator, screen, and washer from the end of the faucet.

2. Use the faucet adapter kit that came with your portable dishwasher to modify the faucet where the dishwasher will be

used.

NOTE: Remove and save the washer, screen, and screen holder or aerator for future use.

Excessive Weight Hazard

Use two or more people to move and install

dishwasher•

Failure to do so can result in back or other injury•

Stand dishwasher upright. Open door and remove shipping foam, cardboard tower and any other shipping materials. Close

dishwasher door. Latch dishwasher door shut.

CONNECTING THE

DISHWASHER

Connecting the faucet adapter to faucets with external threads

Insert the 2 screens and then the thin washer from the faucet adapter kit into the faucet adapter. Attach the adapter onto the

end of the faucet. NOTE: Do not use the thick washer.

Connecting the faucet adapter to faucets with internal threads

Connecting the Faucet Adapter

NOTES:

• A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has a spray

hose, it is recommended that the hose be disconnected and the hole plugged.

• A special adapter must be installed on the faucet before the

dishwasher can be connected. Complete the instructions below

using the provided adapter.

When moving your dishwasher, make sure the door is latched.

Hold the dishwasher at the top front corners.

Insert the 2 screens, the thin washer, and then the thick washer from the faucet adapter kit into the faucet adapter. Attach the adapter onto the end of the faucet.

NOTE: Use both washers.

Connecting to Water and Electrical Supply

1.Run water at the faucet until it is hot. Turn off the water.

2. Pull the hoses out of their storage compartment on the back of the dishwasher.

NOTE: Make sure the hoses are not kinked or twisted. Kinked

hoses reduce washing performance.

3. Pull down on the locking collar while lifting the hose connector onto the faucet adapter.

Using the Faucet

You can draw water from the faucet while the dishwasher is

connected. NOTE: Do not draw water while the dishwasher is filling or while

water is being pumped out. (This helps avoid a low fill when

dishwasher is filling or keeping drain water from mixing with fresh

water when dishwasher is draining.)

Press the red button on the hose connector to draw water from

the faucet. (The faucet is set on hot. Adjust the faucet for the water temperature you want.)

NOTE: Turn the hot water back on after you draw water from the

faucet. Turn off the cold water.

4. When the connector snaps into place, release the locking

collar.

5. Turn the hot water on slowly until it is all the way on.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong. Do not use an adapter.

Do not use an extension cord. Failure to follow these instructions can result

in death, fire, or electrical shock.

Disconnecting the Dishwasher

1.Turn off the hot water. (This can be done after the last rinse.}

2. Press the red button on the connector to release the water pressure.

Disconnect hose from faucet

%ucet ada

Lockingc

Redbutton

3. Lift slightly on the hose connector while pulling down the

locking collar. Pull down on the connector.

4. Empty any remaining water from the connector by turning the

connector upside down.

5. Unplug the power supply cord and return it to the storage

compartment.

6. Return the hoses to the storage compartment.

STORING

Storing for the Summer

Turn off the water supply and power supply to the

dishwasher during the summer to avoid damage to your dishwasher.

6. Plug into a grounded 3 prong outlet.

Winterizing your Dishwasher

Avoid water damage to your dishwasher and home due to freezing water lines. If your dishwasher is left in a seasonal dwelling or could be exposed to near freezing temperatures, have your dishwasher winterized by authorized service personnel.

+ 11 hidden pages