Kenmore 26-49182, 26-89182 User Manual

See reverse side for additional information

FEATURES

Because of our continuous program of product improvement, Sears reserves the right to change models and specifications without notice. Consult installation instructions packed with the product for final dimensional data.

414/LCR/00

White on White – 26-49182 White on White – 26-89182

24" STACKABLE LAUNDRY PAIR

Listed by Underwriters Laboratories

Color Selection 24" Washer

White on White 26-49182

Washer Features

Basket Volume (Cu. Ft.) 2.0 Number of Speeds 2 Top Load { Agitator Type Straight Vane Bleach Dispenser {

Cycle Selections 7

Soak { Heavy Duty { Regular { Permanent Press { Delicate { Hand Wash { Drain & Spin Only { Temperature Selections 4 Water Levels 4

General Features

Sound Insulation Quiet Pak

™

1/4 H.P. Motor { Cabinet Finish Acrylic Lid Finish DynaGuard

White Porcelain Enamel Basket Finish { Volts/Hz/Amps 120/60/3.6 Adjustable Leveling Legs 4 Manual Inlet Hose (Length) 52" Drain Hose (Length) 48" Power Cord Included {

Shipping Weight (Approx. Lbs.) 110 Note: Washer model 26-49182 has an approximate 5 minute delay for draining before start of spin cycle.

Washer

26-49182 – White on White

{ 2.0 cu. ft. capacity { Straight Vane agitator { 7 cycles, 2-speed { 4 water temperatures { Quiet Pak

™

sound insulation

Dryer

26-89182 – White on White

{ Space saver…only 24" wide { 3.4 cu. ft. capacity { 4 cycles plus Air Only { Auto Dry { Wrinkle Guard

Color Selection 24" Dryer

White on White 26-89182

Dryer Features

Capacity (Cu. Ft.) 3.4

Cycle Selections 4

Timed 70 Minutes Touch-Up { Air Only { Auto Dry { Wrinkle Guard®I {

General Features

Number of Temperatures 4 End-of-Cycle Signal { Push-To-Start Button { Lint Screen Internal 180 Degrees Side Swing Door { 1/4 H.P. Motor { Volts/Hz/Amps 240/60/17 Wattage/Heater Element 3,000 @ 240V Electric Dryer Circuit Requirement (60Hz.) 30 Amp Power cord Not Included White Epoxy-Coated Drum Interior { Top/Cabinet Finish Acrylic Shipping Weight (Approx. Lbs.) 100

Warranty

Full 1-Year Warranty –

Mechanical and Electrical Parts In Home Wrinkle Guard I = 30 minutes of tumbling without heat at end of cycle.

See written warranty or your Account Manager for details

WASHER

DRYER

22"

4" Dia.

16"

/8"

24"

Cold Hot

16"

Drain

29" Min. Depth for installation

with

Stack Stand

26" Min. Depth for installation

without

Stack Stand

OPTIONAL STACK ASSEMBLIES*

Stationary

26-89182

Stack Stand White 26-49971 Dryer Wall Mount Kit 26-46131 Door Latch Kit 26-347746

*Total height of stackable laundry pair when

using stack stand is 75 5/16".

UIET PAK

™

Shown with optional Stack Stand

SMALL LOAD

PUSH TO START

WATER TEMPERATURE

WATER LEVEL

WARM

COLD

LARGE LOAD

COLD

Compact

FABRIC

TEMPERATURE

PERMANENT PRESS

MEDIUM

DELICATE

LOW

COTTON

Heavy Duty

HIGH

HOT

COLD

WARM

WASHING

RINSING

SPINNING

Quiet Pak

CYCLE RESET

OFF

PERMANENT

HEAVY DUTY

PRESS

REGULAR

DELICATE

SOAK

DRAIN &

SPIN ONLY

WASHABLES

Compact

PAUSE

START

HAND

Heavy Duty

LESS DRY

AUTO DRY I

NORMAL DRY

MORE DRY

WRINKLE GUARD I

AIR DRY

✱

8 8

0 4

OFF

TIMED

OFF

9 0

DRY

TOUCH

414/LCR/00

White on White – 26-49182 White on White – 26-89182

24" STACKABLE LAUNDRY PAIR

IMPORTANT NOTE ON DRYER VENTING

Do not use non-metal flexible duct. When installing the venting system, do not exceed the specified length for the vent duct. Venting systems which are longer than specified will accumulate lint, increase drying time and energy use and shorten the life of the dryer.

MINIMUM SPACING IN INCHES

RECESSED INSTALLATION A B C D F G H INSIDE VENT 4041 OUTSIDE VENT 1001

CLOSET INSTALLATION A B C D F G H OUTSIDE 60 60 VENT 1001

SQ. IN.1

SQ. IN.

When the Laundry Center is installed in other than the recessed and closet type of installation shown, minimum dimensions indicated must be observed.

To prevent large amounts of lint and moisture from accumulating and to maintain drying efficiency, this appliance must be vented outdoors.

G DBC

Closet

Door

SIDE VIEW FRONT VIEW

Dryer

Washer

Dryer

Washer

CLOSET INSTALLATION

26-2643, 26-2663

26-2644, 26-2664

OPTIONAL POWER CORDS

All Electric Dryers Require Cord Electric Dryer Cords

Order Wire Length

26-2643 3 4 ft. 26-2663 3 6 ft. 26-2644* 4 4 ft. 26-2664* 4 6 ft.

*Complies with 1/1/96 NEC

code revision for new construction and remodeling

VENT HOOD TYPE

NUMBER

OF 90°

TURNS

0 43 ft. 41 ft. 36 ft. MAXIMUM LENGTH 1 33 ft. 31 ft. 26 ft. OF 4" DIAMETER RIGID 2 23 ft. 21 ft. 16 ft. HEAVY METAL VENT 0 30 ft. 29 ft. 24 ft. MAXIMUM LENGTH 1 24 ft. 23 ft. 18 ft. OF 4" DIAMETER FLEXIBLE 2 16 ft. 15 ft. 10 ft. METAL VENT

DRYER VENTING RECOMMENDATIONS

4-WAY VENTING KIT

Available Through

Sears Parts & Service

1-800-225-2864

26-279818 – White, 26-279819 – Almond,

26-279820 – Black

26-98379 — VENT HOOD

Aluminum body and plastic molded hood with a 4" opening.

4" Clearance Behind the Dryer is Preferred for Best Airflow.

2" Clearance is Achieved With Periscopes.

Recommended wall vent hole location: top of hole 36" from floor, centered behind dryer.

26-49900 — Over-The-Top™Kit Universal solution, 8 foot length

4" Clearance Behind Dryer

26-49608 — Flexible Pipe

4" x 6' with snap-lock fittings 90˚ turn takes 1 foot length and 6" clearance

26-49609 — Close Elbow Turns 90˚ within 4" Rotating collars and snap-lock fittings

26-49908 — Periscope 0-18" For outlets which overlap or are very close

26-49904 — Periscope 18-29" Reaches side of most dryers

26-49905 — Periscope 29-50" Reaches top of most dryers

Use 26-49608 Flexible Pipe

Clamps are recommended for wall and dryer connections. Steel clamps designed to resist stretching, with phillips/hex head screw are included one each on elbows and periscopes.

2" Clearance Behind Dryer

Laundry Centers

Gas Dryer Connector – Stainless Steel

26-49589

/2" - 3/8" Flex, 5 ft.

26-49584*

/8" - 3/8" Flex, 5 ft.

*Los Angeles only