Kenmore 15819142, 15819141 Owner’s Manual
Ilm#mkmd mmdbk*,e
TIT I AT R
Straight Stitch Attachment Zigzag Bite I_t Control
Position Dimension
i i II III
Left Super High Bar 7.0 6817
' *Left Needle Pos ttonts _t]so referl:ed to as "S" pos ;ton.
pmoeh,t.,
DROP FEED ODG. PRESS DOMNPRESSUREREGtft.ATORTO THE _XINUtl PRESSURE. LOWER
PRESSERFOOTLEVER. LOOSENTHLIHBSCRENAND BE SURE PRESSERFOOT IS S:'ATED
PROPERLY. TIGHTEN THUMBSCREW.
IF ADJUSTMENTIS NECESSARY,RAISE PRESSERFOOT LETr_ AND LOOSENSCREWSON
PRESSERBARHOL_R. ADJUST THE HEIGHT OF PRESSERFOOT FROMNEEOLEPLATEAS
SPECIFIED. CONFIRMTHE HEIGHT OF PRESSERFOOT BY A COMPLETETURNOF THE HAND-
WHEEL. TIGHTEN THE SCRE'_SSECURELYAFTER N_IUSIMENT.
LOOSENSET SCRENS(i) SLIGHTLY. INSERT THE ECCENTRIC
TOOL (3) INTO THE HOLE (4). SLIDE THE ZlGZkG WIDTH
BRACKET(2) IN EITHER DIRECTION, BY TURNING THE ECCENTRIC
TOOL UNTIL YOU OBTAIN EQUAL CLEARANCEBETMEENTHE NEEDLE
AND THE EDGEOF NEEDLESLOT AT BOTH LEFT AND RIGHT NEEDLE
POSITIONS. TIGHTEN THE SCREMSSECURELYAFTERADJUS1MENT.
IqGUI_ X:.ls
NeedleP_thm
LON BAR
HIGH BAR
SIDE FACING
SHUTTLE
HIGH BAR SUPERHIGH BAR
o.o
FOR FRONTFACING SHUTTLEMODELS, PLACE GAUGEAT POSITION AS ILLUSTRATED
'AITH THE NO-GO-SIDE OF THE GAUGEFACING THE NEEDLE PLATE. LOWERPRESSER
FOOT. HHILE TURNING THE HANOWHEELSLOWLYBY HAND, THE GAUGESHOULDBE
MOVEDBY THE FEEl)DOGTEETH. IF NOT, FEEDOOGTEETH ARE TOOLOH. THEN
PLACE THE GAUGEUP-SIDE-OOHN '_ITH THE GO-S[DE FACING THE NEEDLEPLATE.
REPEATTHE SAMEPROCEDURE.THE GAUGESHOULDNOTBE HOVEO. IF THE GAUGE
IS qOVED, THE FEEDOOGTEETH ARE TOO HIGH.
IN CHART FOI_4 IT LOOKSLIKE THIS:
[Feeddo$ Ikelsht Go-Side (Fecins No-Go-Side (Faclnl_
Gsu2e NHdle Plste_ _eedle,,Place)
Lov
RtEh
IF AOJUSTHENTSARE NECESSARY,LOOSENSCREH (1) ON DROPFEEO CENTERBLOCK
AN0 ADJUST THE FEEDDGOHEIGHT AS SPECIFIE0. TIGHTEN THE SCREHSECURELY
AFTER AOJUSTHENT.
CAUTIO_____N:FOR SIDE FACING SHUTTLEMODELBE SURETHE GAUGE
[S PLACE0 ON THE SURFACEOF NEEDLEPLATE. BE
SURE ONEENU IS HO_T.TRESTING ON THE HAHOHOLE
COVERPLATE.
Hot Novtn$
Mot Hovtn$
Movtn8
._ovtnS
HoVLnll Go_H
lk_ _t_ lenlPh_"a_-d at "0". l_rni_ hancheheeL
'-'hockMd He ff thefNd dol_movu IsorisoetaHy.At
"O"Poiltk_ tla fe_l dot shouldad laove, if it d_a,
Iomm aerme (k) add imert the eeeoaSrletool _)
Imo II_ hol_ (C) •Turn U_ o¢._nlrle I_I Mtbo_way
toelJminaUimovementof the feeddoll Tlshtm the
screw (A) after _lJussmem.
FIGURE F.IS
.o
• ':_L-'__ _/,,--_'.
_ __-r-
B-
-r..
' "" 'II
,...o.,
_ | .
0.01SO-} 04_l
e
.. . .£_ .
! ,".
._)
\
FIGURE E-I
Loading...