Kenmore 15818130, 15818034, 15818033, 15818032, 15818031 Owner’s Manual

Straisht Sttlch Attachr._ent Zigzag Bite Foot Control

Positlon Dimlnslon _

I

Left, Super Htgh Bar 7.0 , _|lq

• Left Needle POs t|on |s also referred to as "S'; p I|t3i _tlr_..

Pw l_ot

M_tk_k Sw_

SET THE SELECTORDZAL M S AND STITCH .IDTH CONTROL

.m4..I_ NEEOLETOT_LUSTP_m_.L_EH

sETs.._(1)SLI,_rL_.]NSE.T,EECCE.R,CT_

l;t l,TOTHE_E(" _ SLIOETHEZ,,Z_C,,__.LMR

IN THE D,RECT,ON INDICATED BY THE ARROWBY TUNIING

THE ECCENTRICTOOL UNTIL YOU CAK OBTAIN EQUALCLEARANCE
BETHEENTHE NEEDLE AND THE EDGE OF THE NEEDLE SLOT AT

BOTHLEFT N!O RIGHT NEEDLE POSITIONS. TIGHTEN THE SCREWS

SECURELYAFTER ADJUSTMENT.

DROP FEED DOG. PRESSO0_N PRESSUREREGULATORTO THE HAXIHUMPRESSURE. Lr_ER
PRESSERFOOT LEVER. LOOSENTHUN8 SCREWANDBE SURE PRESSERFOOT ZS SEATED

PROPERLY. TZGHTENTHUMBSCREW.

;F ADJUSTMENT1S NECESSARY,RAISE PRESSERFOOTLEVER AND LOOSENSCRZWSON

PRESSERBARHOL_R. A_UST THE HEZGHTOF PRESSERFOOT FROMNEEDLEPLATE AS
SREC;FZED. CONFIRMTHE HEIGHT OF PRESSERFOOTBY A COMPLETETURNOF THE HAND-

WHEEL. TZGHTENTHE SCRI_S SECURELYAFTER ADJUSTMENT.

db

FIGURE C-7

ONe"

LOM BAR

HIGH BAR

SZDE FACING

SHUTTLE

m A.!

HIGH BAR

SUPERHIGH BAR

IN.fen

o,o N,w t

FOR FRONT FACING SHUTTLE HODELS, PLACE GAUGE AT POSITION AS ILLUSTRATED
WITH THE NO-GO-SIgE OF THE GAUGE FACI_ THE IIEEOLEPLATE. L_ER PRESSER
FOOT. WHILE TJRNING THE HANOWhEEL SLOWLY BY HAND, THE _AUGE SHOULD BE

MOVED BY THE FEEDD_ TEETH. IF NOT, FEEDDOG TEETH ARE TOO LOW. THEN

PLACE THE GAUGE UP-SIDE-DOWN WITH THE GO-SIDE FACING THE NEEDLE PLATE.

REPEATTHE S_4E PROCEOURE.THE GAUGESHOULONOT BE MOVED. IF THE GAUGE

IS MOVEO, THE FEEDD(]GTEETH ARETOO HIGH.

IN CHART FORM IT LOOKS LIKE TH!S:

i jle,

leeeddol Heishc

_4Ufe

Co_wec_

Low

HLsh

IF ADJUSTMENTS ARE NECESSARY, LOOSEN SCREW (I) ON DROP FEED CENTER BLOCK

A_IDADJUST THE FEEDOUGHEIGHT AS SPECIFIED, TIGHTEN THE SCREWSECURELY
AFTER N)JUSI}IENT.

CAUTION: FOR SIDE FACING SHUTTLEMODELBE SURETHE GAUGE

IS PLACEDON THE SURFACEOF NEEDLEPLATE. DE

SURE ONE END IS NOT RESTING ON THE HANDHOLE
COVERPLATE.

_)-Slde (Fac'in8 - No,._o-Slde (FacLn&
Needle Plate) _eedLe Place)

_ot Hovin$ Hovtn8

Hot _ovtn8 Hov_ns
MovLas Hovtn$

mUIt,E D-!

_.___ _" ".. V_{_.:.__

L____..J I

\

f

, ,t#

YIGUP._ E-L