Kenmore 14816154210, 14816154211, 14823683310 Installation Guide

FIREBOX BOTTOM PANEL REPLACEMENT INSTRUCTIONS

FOR GRILL 16154, 23683

If the firebox bottom panel is rusted out and needs replacement, please follow following steps

for replacement.

,

Place the grill on a flat, level surface. Open
the lid and remove warming rack, grids and

heat tents. Remove the doors from the
cabinet. (Fig.l)

,

Remove the ignition wires from the igniter
in the cabinet. Then, disassemble the
control panel. (Fig.2)(Fig.3)

Fig.1

3. Remove the rivets on the front and back of
the drip tray with a drill. (Fig.4)(Fig.5)

,

Remove the screws located at the right and
left side of the firebox which connect the

bottom panel to the firebox. Two screws at
each side. (Fig.6)

,

Slide out the old bottom panel from the fire .........

box, then replace it with a new one. Fasten
the new panel to the fire box by using the
screws provided. (Fig.7)

,

After all above steps complete, reassemble
the control box, re-connect the ignition
wires to the igniter. Return heat tents,

grates, warming rack to its original location,
then re-install the doors to the grill.