K-Edge K13-550 User Manual

1

Gravity Cap GARMIN® Mount Installation Instructions
(K13-550-[color])

Description:

The K-EDGE Gravity Cap GARMIN Mount is designed for installation of a GARMIN Edge® or GARMIN Forerunner® computer onto
a 1-1/8” Steerer Tube in replacement of the original top cap, placing the computer directly over the steerer tube of the fork.

Compatibility:

The K13-550 Gravity Cap GARMIN Mount is compatible with all GARMIN Edge, Touring, Touring Plus, and Forerunner models

Warnings:

We strongly recommend installation of the Gravity Cap Stem Mount by a professional mechanic. These instructions are generalized
to accommodate a wide range of setups for a bike. If your setup doe s not match what i s being described, take ex tra care in the
process of your setup and contact K-EDGE Technical Support if you have any questions.

Improper installation of any K-EDGE product or use outside of its design intentions could lead not only to da maging the bike and
related components but could also cause personal injury to the rider.

Parts Included:

 K13-550

 1x K13-551 K-EDGE Gravity Cap GARMIN Mount
 1x K13-503 GARMIN insert
 1x M6 x 35 mm SHCS
 2x M3 x 6 mm (Blue Thread Lock pre-applied)

Tools/Items Required:

 Metric Allen Set (5/6 mm for the top cap bolt and 2 mm for the insert bolts)
 Torque wrench

WARNING: IT IS STRO NGL Y R EC O MMEN DED T HAT YOU PERIOD ICA LLY CHECK ALL BOLTS FOR PROPER TORQUE!!!

Mount Installation:

2

1. Ensure the stem and handlebars are installed, aligned, and torqued according to manufacturer’s recommendations.

2. Remove the original top cap and mounting bolt.

3. Install K13-551 on top of the stem.

4. Install, but do not fully tighten, M6 x 35mm FHCS.

5. Set the mount to your desired position (see above).

6. Carefully tighten the top cap bolt (M6 x 35mm FHCS) according to the manufacturer’s recommendations for the
headset.

7. Install K13-503 Garmin Insert.

8. Install the 2x M3 x 6mm FHCS and torque to 1 N-m MAX.

Caution: Do not over-torque the M3 x 6mm Flat Head screws.
Notes:

• A small amount of thread lock has been pre-applied to the M3 x 6mm bolt at the factory, it is

recommended that an additional amount be added if this bolt were t o be adjusted multiple times.

• Subsequent adj ust ment or tightening of the M6 x 35 mm headset bolt will require removal of t he two M3

x 6mm FHCS bolts.

WARNING: IT IS STRO NGL Y R EC O MMEN DED T HAT YOU PERIOD ICA LLY CHECK ALL BOLTS FOR PROPER TORQUE!!!