K-Edge K13-520 User Manual

1

Default Insert Position

for Garmin Edge®

Insert Position for Garmin

Forerunner® 310XT and 910XT

GARMIN® Mount Installation Instructions
(K13-520-[color])

Description:

The K-EDGE GARMIN Fixed Stem Mount is designed for installation of a GARMIN Edge® or GARMIN Forerunner® computer onto
a 1-1/8” Steerer Tube stacked above the stem.

Compatibility:

The K13-520 GARMIN Fixed Stem Mount is compatible with all GARMIN Edge® 200, 500, 510, 800, and 810 computers. It is also
compatible with the GARMIN Forerunner® 310XT and 910XT (with 'quick-release kit' purchased separately from GARMIN)
computers utilizing the same mounting system. NOTE: The GARMIN Forerunner® 910XT prevents the addition of a spacer on top
of the K13-520 due to interference issues – it is recommended that spacer be installed below the K13-520.

STEM RECOMMENDATIONS:
Stem Angle: 0 to Negative-Degree

Warnings:

These instructions are generalized to accommodate a wide range of setups for a bike. If your setup does not match what is being
described, take extra care in the process of your setup and contact K-EDGE Technical Support if you have any questions.

Improper installation of any K-EDGE product or use outside of its design intentions could lead not only to damaging the bike and
related components but could also cause personal injury to the rider.

Parts Included:

 K13-520

 1x K-EDGE GARMIN Fixed Stem Mount
 2x M3 x 6 mm (Blue Thread Lock applied)

WARNING: IT IS STRONGLY RECOMMENDED THAT YOU PERIODICALLY CHECK ALL BOLTS FOR PROPER TORQUE!!!

Tools/Items Required:

 Metric Allen Set (5/6 mm for the top cap bolt and 2 mm for the insert bolts)
 Torque wrench
 **GARMIN Forerunner® Quick Release Kit (required for Forerunner® 310XT and 910XT owners)**

Mount Installation:

2

1. Ensure the stem and handlebars are installed, aligned, and torqued according to manufacturer’s recommendations
for the headset.

2. Remove the top cap:

 IF A SPACER IS PRESENT ABOVE THE STEM, replace the spacer with the K13-520.
 IF NO SPACER IS PRESENT ABOVE THE STEM, visually confirm adequate bolt thread length for the

addition of a 5mm thickness of the mount.

3. Install the mount on top of the stem.

4. Install, but do not fully tighten, the top cap.

5. Set the mount to your desired position

6. Carefully tighten the top cap bolt according to manufacturer’s recommendations for the headset.

7. IF you will be using a GARMIN Forerunner® 310XT and 910XT please proceed to "Insert Adjustment", otherwise
installation is complete.

WARNING: IT IS STRONGLY RECOMMENDED THAT YOU PERIODICALLY CHECK ALL BOLTS FOR PROPER TORQUE!!!