K-Edge K13-505 User Manual

1

Default Insert Position

for Garmin Edge®

Insert Position for Garmin Edge®

Forerunner® 310XT and 910XT

GARMIN® Mount XL Installation Instructions
(K13-505-[color])

1000 (Landscape Mode) or

Description:

The K-EDGE GARMIN Mount XL is identical in design to the K13-500 GARMIN Mount with the ex ception that it has been extended
7mm to allow fitment of the GARMIN Edge® 1000 computer.

Compatibility:

The K13-505 GARMIN Mount XL is compatible with all GAR MIN Edge® 200, 500, 510, 800, 810, and 1000 computers. It is also
compatible with the GARMIN Forerunner® 310XT (with 'quick-release kit' purchased separately from GARMIN) computers utilizing
the same mounting system. NOTE: The GARMIN Forerunner® 910XT requires a spacer to properly clear the K13-505, please
contact us for further information.

Warnings:

These instructions are generalized to accommodate a wide range of setups for a bi ke. If your setup does not m atch what is being
described, take extra care in the process of your setup and contact K-EDGE Technical Support if you have an y questions.

Improper installation of any K-EDGE product or use outside of its design intentions could lead not only to da maging the bike and
related components but could also cause personal injury to the rider.

!! TETHER ATTACHMENT!! – BOTH THE GAR MIN 510 AN D 1 00 0 CO ME SU PPL IED WITH TE TH ER S; H O WEV ER ,

THE OTHER MODELS DO NOT. IF YOU DO NOT HAVE A TETHER, ONE CAN BE PURCHASED DIRECTLY FROM GARMIN
(PART # 010-11251-16). THE AT TAC HMEN T OF A TE THER IS STRONGLY RECOMMENDED FOR ANY GARMIN
COMPUTER! SEE SECTION TITLED ‘TETHER INSTALLATION’ IN THESE INSTRUCTIONS.

Parts Included:

 K13-505

 1x K-EDGE GARMIN Mount XL
 2x M4 x 12 mm bolts
 2x M3 x 6 mm (Blue Thread Lock applied)

WARNING: IT IS STRONGLY RECOMMENDED THAT YOU PERIODICALLY CHECK ALL BOLTS FOR PROPER TORQUE!!!

Tools/Items Required:

 Metric Allen Set (3 mm for clamp bolts and 2 mm for the insert bolts)
 Torque wrench
 **GARMIN Forerunner® Quick Release Kit (required for Forerunner® 310XT and 910X T owners)**

Mount Installation:

2

1. Separate the upper clamp half (K13-502) from the lower clamp half (K13-506) by removing the 2x M4 x 12 bolts.

2. Install the mount onto the right side (driveside) of the stem on the handlebar.

3. Install the upper clamp half (K13-502) back onto the lower clamp half (K13-506).

4. Install, but do not tighten, the 2x M4 x 12mm bolts back into the clamp assembly.

5. Position the mount to your desired position and 'lightly' tighten the 2x M4 x 12mm bolt s to hold that po sition.

6. Carefully torque both bolts equally to 2 N-m using an alternating pattern back and forth between the bolts.

7. IF you will be using a GARMIN Edge® 1000 (Landscape Mode) or Forerunner® 310XT and 910XT please proceed
to "Insert Adjustment", otherwise installation is complete.

WARNING: IT IS STRONGLY RECOMMENDED THAT YOU PERIODICALLY CHECK ALL BOLTS FOR PROPER TORQUE!!!