K-Edge K13-440 User Manual

GO Big Mount Installation Instructions
(K13-440, 450, 460)

Description:

The K-Edge GO BIG ¼”-20 Mount series is designed for installation of a camera with a ¼”-20 universal mount to virtually any
surface.

Compatibility:

The K13-440 GO BIG ¼”-20 Pro Handlebar series is designed to attach any camera with the standard universal mount in front of
bicycle handlebars, out of the way of your hands and your vision.

The K13-450 GO BIG ¼”-20 Adapter mount is designed to attach any camera with the standard universal mount directly to our
original GO BIG Mounts (K13-400, 410, 420, 430) allowing mounting to virtually any surface*.

The K13-460 GO BIG ¼”-20 Saddle Rail is designed to attach any camera with the standard universal mount OR GoPro / GARMIN
VIRB (with GARMIN supplied adapter) mounting system to rails underneath a bicycle saddle.

* Use K13-450 adapter in combination with K13-400 (the K13-400 is also equipped on K13-420, 430, and 460) to mount on flat
surfaces (i.e. walls, skis, snowboards, cars, etc.) using either industrial double sided adhesive or screws/bolts (hardware not
included). In certain situations, caution is strongly advised to ensure proper mounting and safety.

Warnings:

These instructions are generalized to accommodate a wide ranges of setups for a bike. If your setup does not match what is being
described, take extra care in the process of your setup and contact K-Edge Support if you have any questions.

Improper installation of any K-Edge product or use outside of its design intentions could lead not only to damaging the bike but could
also cause personal injury to the rider.

Parts Included:

 K13-440

 1x GO BIG ¼”-20 Pro Handlebar mount
 1x ¼”-20 Thumbscrew w/ head Keyed to 5mm Hex
 1x Silicone O-Ring (Orange) Dash #107
 1x M2.5 x 0.45 x 5mm SHCS ‘Alignment Bolt’
 2x M4 x 12mm SHCS ‘Clamp Bolts’

 K13-450: (Adapter Only – GO BIG Mounts Required)

 1x GO BIG ¼”-20 Adapter mount
 1x ¼”-20 Thumbscrew w/ head Keyed to 5mm Hex
 1x Silicone O-Ring (Orange) Dash #107
 1x M2.5 x 0.45 x 5mm SHCS ‘Alignment Bolt’

 K13-460

 1x GO BIG Pro Saddle Rail mount
 1x GO BIG ¼”-20 Adapter mount
 1x ¼”-20 Thumbscrew w/ head Keyed to 5mm Hex
 1x Silicone O-Ring (Orange) Dash #107
 1x M2.5 x 0.45 x 5mm SHCS ‘Alignment Bolt’
 2x M4 x 8mm FHCS
 2x M5 x 16mm FHCS

Tools/Items Required:

 Metric Allen Set (3mm for clamp bolts, 4mm for mounting bolts, and 5mm for Thumbscrews)
 Torque wrench

Note: (Applies to: K13-400/410/420/430/460) Prior to installation please ensure that the camera mounting bolt is installed
correctly.