K-Edge K13-201 User Manual

Dirt 3 Chain Catcher Installation Instructions
(K13-201)

Description:

The K-Edge Dirt Chain Catcher series is designed to eliminate chain drop on the low est chainring due to hard shifts, cro ss-chain
shifting and or rough terrain while riding.

Compatibility:

The K-Edge Dirt 3 series can be used with triple MTB cranksets compatible with an 'E-Type' or 'Bottom Bracket Mount' front
derailleur utilizing external bottom bracket cups or NON-GXP bottom brackets. This device cannot be used in conjunction with an 'E­Type' front derailleur as it is mounted in the same location.

Warnings:

All K-Edge products are to be installed by a professional bike mechanic.
These instructions are generalized to accommodate a wide ranges of setups for a bike. If your setup doe s not match what i s being

described, take extra care in the process of your setup and contact K-Edge Support if you have any questions.
Improper installation of any K-Edge product or use outside of its design intentions could lead not only to damaging the bike but could

also cause personal injury to the rider.

Parts Included:

 K13-201:

 1x Dirt 3 Chain Catcher

Tools/Items Required:

 Manufacturer's Instructions with torque specs for Crankset and Bottom Bracket
 Bottom Bracket Tool
 Torque Wrench

Installation Ste ps:

1. Remove crankset per manufacturer's recommendations.

2. Remove driveside (right side) bottom bracket cup.

3. Replace 2.5mm spacer (normally reserved for an 'E-Type' front derailleur) with the Dirt 3. Install components
in accordance to the image below:

4. Reinstall driveside (right side) bottom bracket cup and hand-tighten only.