K-Edge K13-010-31.8 User Manual

Road Chain Catcher Installation Instructions
(K13-010-31.8 & K13-010-34.9)

Description:

The K-Edge Road Chain Catcher series is designed to eliminate chain drop on the lowest chainring due to hard shifts, cross-chain
shifting, and/or rough terrain while riding. Furthermore, allowing installation of a chain catcher on framesets with Non Braze-On
clamps.

Compatibility:

The K13-010-31.8 and K13-010-34.9 Road Clamp series is compatible with front derailleur’s with integrated clamps and are for
double specific crank set’s only.

Warnings:

All K-Edge products are to be installed by a professional bike mechanic.
These instructions are generalized to accommodate a wide ranges of setups for a bike. If your setup does not match what is being

described, take extra care in the process of your setup and contact K-Edge Support if you have any questions.
Improper installation of any K-Edge product or use outside of its design intentions could lead not only to damaging the bike but could

also cause personal injury to the rider.

Parts Included:

 K13-010-31.8

 1x Chain Catcher
 1x 31.8mm Diameter Clamp
 1x M4 x 8mm Stainless steel socket head screw
 1x M3 x 10mm Hex socket set screw

 K13-010-34.9

 1x Chain Catcher
 1x 34.9mm Diameter Clamp
 1x M4 x 8mm Stainless steel socket head screw
 1x M4 x 10mm Hex socket set screw

Tools/Items Required:

 Metric Allen Set (3mm for mounting bolt and 1.5mm for set screw)
 Torque wrench

Installation Steps:

1. Place K-Edge Clamp below front derailleur clamp and lightly tighten the clamp bolt. See image below: