Karcher K5-68MD User Manual [en, es, fr]

K 5.68

OPERATOR MANUAL

High Pressure Washer . . . . . . . . . . . . . . . . . . 2

MANUAL DE USUARIO

Limpiador de alta presión . . . . . . . . . . . . . . . 18

MANUEL D‘UTILISATION

Nettoyeur haute pression . . . . . . . . . . . . . . . 34

59663110 (2014.03)

HIGH PRESSURE WASHER OPERATOR MANUAL

Model Overview 3 Important Safety Instructions 4 Assembly Instructions 6 Operating Instructions 6 Using the Accessories 8 Working with Detergents 9 Taking a Break 10 Shutting Down and Clean-Up 10 Winterizing and Long-Term Storage 11 Maintenance Instructions 11 Cleaning Tips 12 Optional Cleaning Accessories 14 Troubleshooting 16

Safety Alert Symbols

 DANGER

indicates “an imminently hazardous situation which, if not avoided, will result in death or serious injury.”

 WARNING

indicates “a potentially hazardous situation which, if not avoided, could result in death or injury.’’

몇 CAUTION

indicates “a potentially hazardous situation which, if not avoided, may result in minor or moderate injury or in property damage incidents.”

Owner/User Responsibility

The owner and/or user must have an understanding of the manufacturer’s operating instructions and warnings before using this pressure washer. Warning information should be emphasized and understood. If the operator is not fluent in English, the manufacturer’s instructions and warnings shall be read to and discussed with the operator in the operator’s native language by the purchaser/owner, making sure that the operator comprehends its contents. Owner and/or user must study and maintain for future reference the manufacturers’ instructions.

For household use only!

Customer Support

USA and Canada

In the U.S. or Canada, please call 1-800-537-4129 for warranty issues and visit www.karcher-help.com for technical support and product assistance. Please take a moment to register your pressure washer online at www.karcher-register.com. Be sure to save your purchase receipt, it will be required for repairs covered by warranty.

Customer Support Mexico

Specifications

Max. Pressure 2000 PSI Max. Water Flow 1.4 GPM Amp draw 13 AMPS Voltage 120 V Part No. 1.601-911.0 Serial no.

2 English

Call: 01-800-024-13-13 for help or visit our website: www.karcher.com.mx

MODEL OVERVIEW

1 Garden hose connector (female) 2 Water inlet connector 3 Water inlet with filter 4 ON/OFF switch 5 High pressure hose 6 High pressure hose drum 7 Trigger gun holder 8 Transport handle 9 Crank 10 Accessory storage

11 Power cord with power plug 12 Detergent siphon tube with filter 13 Wheels 14 Trigger gun 15 Trigger gun safety lock 16 Key to detach high pressure hose

from trigger gun 17 Detergent foamer 18 Dirtblaster ® (Rotary spray wand) 19 Vario Power Spray wand

English 3

IMPORTANT SAFETY INSTRUCTIONS

 WARNING

When using this product basic precautions should always be followed, including the following:

 Read all the instructions before using

the product.

 To reduce the risk of injury, close su-

pervision is necessary when a product is used near children.

 Know how to stop the product and

bleed pressures quickly. Be thoroughly familiar with the controls.

 Stay alert – watch what you are do-

ing.

 Do not operate the product when fa-

tigued or under the influence of alcohol or drugs.

 Keep operating area clear of all per-

sons.

 Do not overreach or stand on unsta-

ble support. Keep good footing and balance at all times.

 Follow the maintenance instructions

specified in the manual.

 WARNING

Risk of Injection or Injury – Do Not Direct Discharge Stream At Persons.

 High pressure jets can be dangerous

if misused. The jet must not be directed at persons, animals, electrical devices, or the unit itself.

 Wear safety goggles.

 WARNING

Risk Of Explosion – Do not spray flammable liquids.

 Do not use acids, alkaline, solvents,

or any flammable material in this product. These products can cause physical injuries to the operator and irreversible damage to the machine.

 CAUTION

Gun Kicks Back – Hold with both hands.

 The Spray Gun Safety Lock prevents

the spray from accidentally being en-

gaged. This safety feature DOES

NOT lock spray in the ON position.

 WARNING – Risk of Electrocu-

tion

 Inspect cord before using – Do not

use if cord is damaged.

 Keep all connections dry and off the

ground.

 Do not touch plug with wet hands.  Do not use extension cord with this

product.

 Connect to individual branch circuit

only.

 CAUTION

This unit has been designed for use with cleaning detergents recommended by the manufacturer. The use of other cleaning detergents may affect the operation of the machine and void the warranty.

 WARNING

 DO NOT SPRAY ELECTRICAL APPA-

RATUS AND WIRING.

 DO NOT USE WITH FLAMMABLE LIQ-

UIDS AND TOXIC CHEMICALS.

 HIGH PRESSURE. KEEP CLEAR OF

NOZZLE.

 INJECTION HAZARD: EQUIPMENT

CAN CAUSE SERIOUS INJURY IF

THE SPRAY PENETRATES THE

SKIN. DO NOT POINT THE GUN AT

ANYONE OR ANY PART OF THE

BODY. IN CASE OF PENETRATION

SEEK MEDICAL AID IMMEDIATELY.

 THIS SYSTEM IS CAPABLE OF PRO-

DUCING 2000 PSI (13800 KPA) TO

AVOID RUPTURE AND INJURY, DO

NOT OPERATE THIS PUMP WITH

COMPONENTS RATED LESS THAN

2000 PSI (13800 KPA) WORKING

PRESSURE (INCLUDING BUT NOT

4 English

LIMITED TO SPRAY GUNS, HOSE AND HOSE CONNECTIONS).

 BEFORE SERVICING, CLEANING OR

REMOVING ANY PARTS, SHUT OFF POWER AND RELIEVE PRESSURE.

 IF CONNECTION IS MADE TO A PO-

TABLE WATER SYSTEM, THE SYSTEM SHALL BE PROTECTED AGAINST BACKFLOW.

GROUNDING INSTRUCTIONS

This product must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.

 DANGER

Improper connection of the equipmentgrounding conductor can result in a risk of electrocution. Check with a qualified electrician or service personnel if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the product - if it will not fit the outlet, have a proper outlet installed by a qualified electrician. Do not use any type of adapter with this product.

WATER SUPPLY

(Cold Water Only)

몇 CAUTION

When connecting the water inlet to the water supply mains, local regulations of your water company must be observed. In some areas the unit must not be connected directly to the public drinking water supply. This is to ensure that there is no feedback of chemicals into the water supply. Direct connection via a receiver tank or backflow preventer, for example, is permitted. Dirt in the feed water will damage the unit. To avoid this risk, we recommend fitting a water filter.

 Garden hose must be at least 13 mm

or 16 mm (1/2 inch or 5/8) inch in di-

ameter.

 Flow rate of water supply must not

fall below 7.6 L/min. (2 GPM/gallons

per minute).

 Flow rate can be determined by run-

ning the water for one minute into an

empty 20 litre (5-gallon) container.

 The water supply temperature must

not exceed 40°C/104°F.

 Never use the pressure washer to

draw in water contaminated with sol-

vents, e.g. paint thinners, gasoline,

oil, etc.

 Always prevent debris from being

drawn into the unit by using a clean

water source.

English 5

ASSEMBLY INSTRUCTIONS

 STEP 1:

Insert wheels into the body of the unit.

 STEP 2:

Push the high pressure hose into the trigger gun until it locks audibly. Note: Make sure the connection nipple is aligned correctly.

OPERATING INSTRUCTIONS

 STEP 1:

Insert the spray wand of your choice into the trigger gun. Press in against the spring tension and twist into locked position.

Check the secure connection by pull-

ing on the high pressure hose.

Disconnect:

 Press the disconnect key on the trig-

ger gun and remove the high pres-

sure hose from the trigger gun.

 STEP 3:

Screw the supplied garden hose con-

nector on to the end of your garden

hose.

 STEP 2:

Install the supplied connector to the unit’s water inlet.

6 English

 STEP 4:

Push the garden hose connector on

to the water inlet connector and

make sure you hear it click into place

before proceeding.



STEP 5:

Connect garden hose to the cold water source and turn water on completely.

 STEP 6:

Insert the power plug into a working outlet.

 STEP 7:

Unlock the trigger gun safety lock. Trigger the gun to eliminate trapped air, wait for a steady flow of water to emerge from the spray nozzle.

 STEP 8:

Turn on the high pressure washer (I/ ON).

The motor starts only if the trigger of the gun is pulled and shuts off when the trigger is released.

English 7

USING THE ACCESSORIES

 WARNING

To avoid serious injury never point spray nozzle at yourself, other persons or animals. Always test an inconspicuous area before cleaning with high pressure.

Vario Power Spray Wand

The Vario Power Spray Wand allows you to adjust the cleaning pressure.

 To clean at maximum pressure, the

wand must be positioned to the high pressure setting (Max).

 For lower pressure turn the wand col-

lar in the minus (Min) direction.

 To apply detergent, the wand must

be positioned to the lower pressure setting (Mix).

Dirtblaster

 This nozzle features a 0º pencil jet

which rotates 360º for maximum dirt

cutting action, effectively increasing

cleaning performance up to 50%.

This nozzle combines the cleaning

performance of a 0º pencil jet with

the surface coverage of a wide angle

nozzle.

Not recommended for soft materi-

als, siding, painted surfaces,

decks or autos.

 Always test an inconspicuous area

before cleaning with the Dirtblaster ®.

Detergent Foamer Attachment

 Ideal for applications which require a

thick foam. Simply fill the resevoir

cup with liquid pressure washer de-

tergent to generate a foam spray.

Connects directly to the trigger gun.

8 English

WORKING WITH DETERGENTS

Detergents can only be applied at low pressure setting (Mix).

 STEP 1:

Install the Vario Power Spray Wand. Set the spray wand to the low pressure setting (Mix).

 STEP 2:

Fill a container with Kärcher detergent. Place the filter end of detergent siphon tube into the container.

 STEP 3:

Turn on the pressure washer (I). Pull trigger to operate unit. Liquid detergent is drawn into the unit and mixed with water. Apply detergent to work area. Do not allow detergent to dry on surface.

 STEP 4:

To rinse, move the VPS out of "Mix"

position and pull trigger to operate

unit.

 STEP 5:

Cleaning up: Always draw fresh wa-

ter through the detergent tank or si-

phon tube when done to flush any

remaining detergents from the injec-

tion system.

For best results see Cleaning Tips for specific information on how to clean different surfaces.

Always Use Kärcher ® Detergent for Best Results

Kärcher ® biodegradable detergents are specially formulated to protect the environment and your pressure washer. The special formula won’t clog the suction tube filter and will protect the internal parts of the pressure washer for a longer life. For Kärcher ® detergents, check your retailer or visit our website:

www.buykarcher.com

 CAUTION

Never use:

– Bleach, Chlorine products and other

corrosive chemicals

– Liquids containing solvents (i.e.,

paint thinners, gasoline, oils)

– Tri-sodium phosphate products – Ammonia products – Acid-based products

These chemicals will harm the unit and will damage the surface being cleaned.

Use of these items will void the warranty.

English 9

TAKING A BREAK ... five minutes or more

 STEP 1:

Release trigger and engage gun safety lock.

SHUTTING DOWN AND CLEAN-UP

 STEP 1:

Turn the switch to OFF (0) position and unplug cord from outlet.

 STEP 2:

Turn off the water source.

 STEP 3:

Press trigger to release water pressure.

 STEP 2:

Turn pressure washer to OFF (0) po-

sition.

 STEP 4:

Release trigger and engage gun

safety lock.

10 English

 STEP 5:

Disconnect the garden hose from the

water inlet on the unit.

WINTERIZING AND LONG-TERM STORAGE

 1: Disconnect all water connections.  2: Turn on the machine for a few sec-

onds, until the water which had remained in the pump exits, turn off immediately.

 3: Do not allow high pressure hose to

become kinked.

 4: Store the machine and accesso-

ries in a room which does not reach freezing temperatures. DO NOT store near furnace or other sources of heat as it may dry out the pump seals.

CARE AND MAINTENANCE INSTRUCTIONS

Cleaning the water inlet filter

 STEP 1:

Pull out water inlet filter with flat-nose pliers.

 CAUTION

Failure to follow the above directions will result in damage to the pump assembly and accessories and will void the warranty. Kärcher® also recommends the regular practice of using a pump protector like “Kärcher® Pump Guard” to prevent cold weather damage during storage in the winter months.

 STEP 3:

Reinsert water inlet filter.

 STEP 2:

Rinse out water inlet filter in warm water.

Maintenance

The unit is maintenance-free.

English 11

CLEANING TIPS

몇 CAUTION

 Before cleaning any surface an in-

conspicuous area should be cleaned to test spray pattern and distance for maximum cleaning results.

 If painted surfaces are peeling or

chipping, use extreme caution as pressure washer may remove the loose paint from the surface.

 When using on surfaces which might

come in contact with food, flush surfaces with plenty of drinking water.

 For additional cleaning tips and a com-

plete video library, visit our website: