One Touch
Pop-Up Lid
Profile
Kettle
KSK210
KSK210_KETTLE_IB_FA.indd 1 20/5/09 1:50:07 PM
2
Carefully read all instructions before operating
the Kambrook Stainless Steel Kettle for the first
time and save for future reference.
Remove and safely discard any packaging material
and promotional labels before using the kettle for
the first time.
To eliminate a choking hazard for young children,
remove and safely discard the protective cover
fitted to the power plug of this appliance.
This kettle has been designed specifically for the
purpose of boiling drinking quality water only.
Under no circumstances should this product be
used to boil any other liquids or foodstuffs.
Do not place the kettle near the edge of a bench
or table during operation. Ensure that the surface
is level, clean and free of water and other
substances.
Do not operate the kettle on a sink drain board.
Do not place the kettle on or near a hot gas
burner, electric element or where it could touch
a heated oven.
Keep the kettle clear of walls, curtains and other
heat or steam sensitive materials. Minimum
20cm distance.
Always ensure the kettle is properly assembled
before use. Follow the instructions provided in
this book.
The kettle must be used only with the power base
supplied.
The kettle is not intended to be operated by
means of an external timer or separate remote
control system.
Do not touch hot surfaces. Use the handle for
lifting and carrying the kettle.
•
•
•
•
•
•
•
•
•
•
•
•
Do not place anything on top of the lid.
Always switch the power off at the power outlet
and remove the power plug from the power outlet
before attempting to move the appliance, when
the appliance is not in use and before cleaning
and storing.
Use caution when pouring water from the kettle,
as boiling water and steam will scald. Do not pour
the water too quickly.
To protect against electric shock, do not immerse
the kettle base, power base, power cord or
power plug in water and any other liquid or allow
moisture to come in contact with these parts.
Do not remove the kettle from the power base
during operation. Ensure the kettle has switched
off after the water has boiled or reached the
selected temperature, before removing the kettle
from the power base.
Do not move the kettle while it is switched on.
Do not open the lid during operation.
Keep the kettle clean. Follow the cleaning
instructions provided in this book (page 6)
•
•
•
•
•
•
•
•
KAMBROOK RECOMMENDS SAFETY FIRST
At Kambrook, we believe that safe performance is the first priority in any consumer product,
so that you, our valued customer can confidently use and trust our products. We ask that any
electrical appliance that you use be operated in a sensible fashion with due care and attention
placed on the following important operating instructions.
IMPORTANT SAFEGUARDS FOR YOUR KAMBROOK STAINLESS STEEL 1.7L KETTLE
KSK210_KETTLE_IB_FA.indd 2 20/5/09 1:50:07 PM
3
Fully unwind the power cord before use.
Do not let the power cord hang over the edge of
a bench or table, touch hot surfaces or become
knotted.
The appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of
the appliance by a person responsible for their
safety.
Children should be supervised to ensure that they
do not play with the appliance.
It is recommended to regularly inspect the
appliance. To avoid a hazard do not use the
appliance if power cord, power plug or appliance
becomes damaged in any way. Return the entire
appliance to the nearest authorised Kambrook
Service Centre for examination and/or repair.
•
•
•
•
•
Any maintenance other than cleaning should be
performed at an authorised Kambrook Service
Centre.
This appliance is for household use only. Do not
use this appliance for anything other than its
intended use. Do not use in moving vehicles or
boats. Do not use outdoors. Misuse may cause
injury.
The installation of a residual current device (safety
switch is recommended to provide additional
safety protection when using electrical appliances.
It is advisable that a safety switch with a rated
residual operating current not exceeding 30mA
be installed in the electrical circuit supplying the
appliance. See your electrician for professional
advice.
•
•
•
IMPORTANT SAFEGUARDS FOR ALL ELECTRICAL APPLIANCES
KSK210_KETTLE_IB_FA.indd 3 20/5/09 1:50:08 PM
4
KNOW YOUR KAMBROOK STAINLESS STEEL 1.7L KETTLE
1
2200 Watt concealed element
2
1.7Litre capacity
3
Removable filter
4
Water window
5
Locking hinged lid
6
Multi-directional cordfree power base
7
Power on switch and light
8
Lid release button
2
3
6
5
4
1
7
8
KSK210_KETTLE_IB_FA.indd 4 20/5/09 1:50:16 PM
5
OPERATING INSTRUCTIONS
OPERATING YOUR KAMBROOK
STAINLESS STEEL 1.7L KETTLE
BEFORE FIRST USE
Remove any packaging material and promotional
labels before using your kettle for the first time.
It is recommended that before the first use to fill
the kettle to the maximum level with cold tap
water, bring to the boil and then discard the water.
Your kettle will only operate when positioned on
the power base with the ON/OFF switch in the ON
position. The kettle will automatically switch off
once the water has boiled.
OPERATION OF YOUR KETTLE
To fill the kettle with water, remove it from the
power base and open the lid by pressing the
button on the top lid of the kettle and lifting
the lid upwards. Fill with the desired amount of
water. Do not operate the kettle without water.
Always fill the kettle between the minimum and
the maximum marks on the water window. Too
little water will result in the kettle switching off.
Ensure that the lid is closed and locked firmly
into place before placing the kettle on the
power base.
Place the kettle firmly onto the power base. Plug
the power cord into 230/240V power outlet and
switch ‘ON’.
Press the ON/OFF switch to the ‘ON’ position.
The power ‘ON’ light will illuminate.
NOTE: Never operate the kettle dry - too little water
will result in the kettle switching “OFF”.
Do not overfill the kettle - filling above the maximum
mark on the water window may result in boiling
water splashing from the kettle.
NOTE: This kettle must only be used with the power
base supplied. Use caution when pouring water
from your kettle, as boiling water will scald. Do not
pour the water too quickly.
NOTE: Do not remove the kettle from the power
base during operation. Ensure the kettle has
switched to ‘OFF’ position after the water has
boiled before removing the kettle from the power
base.
1.
2.
3.
4.
The kettle will automatically switch ‘OFF’ once
the water has boiled. Lift the kettle from the
power base and pour the water. Take care to
hold the kettle level, especially when filled
to the maximum level. To re-boil it may be
necessary to wait for a few seconds to allow
the control to reset.
The kettle should be stored on its power base when
not in use. The power outlet should be switched
off and the power cord unplugged from the power
outlet when not in use.
Caution: th
is applianCe is designed for the boiling
of drinking quality water only, never use it to heat
or boil any other liquids or foodstuffs. the lid
should always be firmly in plaCe and loCked Closed
before use.
Caution: do
not release the lid while the water is
boiling. ensure the lid is Closed whilst boiling.
SAFETY BOIL DRY PROTECTION
The kettle is fitted with a safety device, which
protects against overheating should the appliance
be operated with insufficient water. If this occurs
the kettle will stop heating and automatically
switch off.
Should this occur, switch off at the power outlet
and unplug. Allow kettle to cool before refilling.
When the kettle has cooled down, the safety
device can be reset by removing and then replacing
the kettle on its base.
5.
KSK210_KETTLE_IB_FA.indd 5 20/5/09 1:50:16 PM
6
CARE AND CLEANING
Always switch off at the power outlet, and then
unplug the appliance from the power outlet before
cleaning.
CLEANING THE KETTLE EXTERIOR
The outside stainless steel surface of the kettle
may be wiped over with a damp cloth and polished
with a soft, clean dry cloth.
Note: Do not use chemical, steel wool, or abrasive
cleaners to clean the inside or outside of the kettle.
Caution: to prevent damage to the applianCe do
not use alkaline Cleaning agents when Cleaning, use
a soft Cloth and mild detergents.
warning: n
ever immerse the kettle base, switCh
area, power base or power supply Cord in water, or
allow moisture to Come in ContaCt with these parts.
CLEANING THE REMOVABLE FILTER
The Kambrook Stainless Steel 1.7L Kettle features
a removable mesh filter to filter out scale deposits
for cleaner water. To remove the scale deposits,
remove the filter by opening the lid of the kettle.
Pull the filter firmly to remove.
The filter can be cleaned by running under hot
water and rubbing with a soft cleaning cloth or
brush. To replace the filter, simply press the filter
down firmly into the slot behind the spout of the
kettle.
TIP: The filter could become damaged with time,
please check regularly and replace if found
damaged.
Note: Ensure the kettle and water have cooled
down before attempting to clean the filter.
MINERAL DEPOSITS AND
DISCOLOURATION
Due to the large surface area of the concealed
element interior base, discolouration due to mineral
deposits from tap water may appear more obvious by
leaving a brown stain on the base. THIS IS NOT RUST.
To remove the discolouration, follow the
instructions “Removing mineral deposits”.
REMOVING MINERAL DEPOSITS
Mineral deposits in tap water may cause the kettle
interior and water window to discolour over time. This
may be removed by using a proprietary kettle descaler
which is available from most leading supermarkets,
department stores and hardware stores.
ALTERNATIVELY:
Fill the kettle until 2⁄3 full with 1 part vinegar (or
a few slices of lemon) and 2 parts water, bring
to the boil and allow to stand overnight.
Empty the solution from the kettle. Fill the kettle
with clean water, bring to boil and discard the
water. Repeat and the kettle will be ready
for use.
STORAGE
Ensure the kettle is switched off, cleaned and
dried before storing. Ensure that the lid is closed
and locked firmly into place. Wrap the power cord
around the cord storage under the power base.
Stand the kettle upright on the power base. Do not
store anything on top.
1.
2.
KSK210_KETTLE_IB_FA.indd 6 20/5/09 1:50:16 PM
7
NOTES
KSK210_KETTLE_IB_FA.indd 7 20/5/09 1:50:17 PM
12
Kambrook warrants the purchaser against defects in workmanship and material for a period of 12 months
from the date of purchase (3 months commercial use).
Guarantee and purchase receipt for this product are to be retained as proof of purchase and must be
presented if making a claim under the Kambrook guarantee.
Kambrook reserves the right to replace or repair the appliance within the warranty period.
Warranty does not apply to any defect, deterioration, loss, injury or damage occasioned by, or as a result
of the misuse or abuse, negligent handling or if the product has not been used in accordance with the
instructions. The guarantee excludes breakages and consumable items such as kneading blades.
This warranty is void if there is evidence of the product being tampered with by unauthorised persons.
If the product includes one or a number of accessories only the defective accessor y or product will be
replaced. In the event of Kambrook choosing to replace the appliance, the guarantee will expire at the
original date, i.e. 12 months from the original date of purchase.
In Australia, this KAMBROOK Guarantee is additional to the conditions and guarantees which are mandatory
as implied by the Trade Practises Act 1974 and State and Territory legislation.
For service, spare parts or product information in Australia, please call KAMBROOK on the Customer
Service Line; 1300 139 798.
For service, spare parts or product information in New Zealand, please call KAMBROOK on the New Zealand;
0800 273 845 or 09 271 398 0.
If claiming this guarantee the product must be returned freight prepaid.
KAMBROOK 12 MONTH REPLACEMENT WARRANTY
YOUR PURCHASE RECORD (Please complete)
DATE OF PURCHASE .......................................................
MODEL NUMBER .............................................................
SERIAL NUMBER .............................................................
PURCHASED FROM .........................................................
Attach a copy of the purchase receipt here.
(Please don’t return purchase record
until you are making a claim)
Due t o cont inual im prove ment in design o r othe rwis e, the p roduct you pur chase ma y diff er slig htly f rom th e illus trat ion in t his boo k. Iss ue 1/0 9
KAMBROOK 12 MONTH REPLACEMENT WARRANTY
Register your warranty at www.kambrook.com.au/service.asp
Kambrook - Australia
Building 2, Port Air Industrial Estate
1A Hale Street
Botany NSW 2019
Australia
Customer Service Line 1300 139 798
Customer Service Fax 1800 621 337
Kambrook - New Zealand
Private Bag 94411
Greenmount, Manukau
Auckland 2141
New Zealand
Customer Service Line/Spare Parts 0800 273 845
or 09 271 3980
Customer Service Fax 0800 288 513
KSK210_KETTLE_IB_FA.indd 12 20/5/09 1:50:04 PM
Loading...