2. Check that your mains voltage corresponds to that stated on the
rating plate of the appliance before using the appliance.
3. To protect against electrical shock do not immerse cord, plug, or
the motor unit in water or other liquid.
4. Close supervision is necessary when the appliance is used by or
near children.
5. Unplug from outlet when not in use and before putting on or
taking off parts or before cleaning.
6. Do not operate any appliance with a damaged cord or plug or
after the appliance malfunctions or has been damaged in any
manner. Return appliance to the nearest authorized service
facility for examination, repair, or adjustment.
7. The use of accessory attachments, including the pouring jar, not
recommended by the appliance manufacturer may cause
injuries.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter or touch hot
surfaces.
10. Do not place on or near a hot gas or electric burner, or in a
heated oven.
11. Always attach plug to appliance first, then plug cord into the wall
outlet. To disconnect remove the plug from the wall outlet.
12. Do not use appliance for other than intended use.
13. This kind of appliance cannot function continuously, it is not a
professional type of appliance. It is necessary to make temporary
stops. Check the section "Important information" in the
instruction manual.
14. It is absolutely necessary to keep this appliance clean at all times
as it comes into direct contact with food.
15. The pouring jar should be assembled correctly on the motor base
before you plug it into the mains. The appliance is equipped with
a safety, which prevents the pouring jar from working if it is not
2
USK BL 2 - 051107
assembled correctly. Furthermore the pouring jar should be
locked so that the appliance can work.
16. The appliance is designed for the preparation of small quantities
of food, which have to be consumed rather quickly. It is not
designed for the preparation of large quantities at once.
17. Keep hands and utensils out of container while blending to
reduce the risk of severe personal injury and/or damage to
blender. A rubber spatula may be used but must be used only
when blender is not running.
18. Do not use a broken, chipped or cracked blender jar.
19. To reduce the risk of injury, never place the cutting unit blades on
base without jar properly attached.
Blades are sharp, handle with
care.
20. Always operate the blender with cover in place.
21. Always close the jar with the lid before starting mixing. When
mixing hot liquid, do not fill more than 2/3 of the jar and be very
careful in order to avoid splashing of hot liquid, otherwise you can
get burned. Do not forget to close the feeding hole of the
pouring jar with the cap.
22. Screw on blade assembly firmly. Injury can result if moving blades
accidentally become exposed.
23. Do not leave blender unattended while it is operating.
24. To disconnect cord, press the button "0" , then remove the plug
from wall outlet.
SAVE THESE INSTRUCTIONS
POLARIZED PLUG INSTRUCTIONS
This appliance has a polarized plug (one blade is wider than the
other). To reduce the risk of electric shock, this plug will fit into the
polarized outlet only one way. If the plug does not properly fit into
the outlet at first, reverse it. If it still does not fit, contact a competent
qualified electrician. Do not attempt to modify the plug in any way.
3
USK BL 2 - 051107
SHORT CORD INSTRUCTIONS
A short power supply cord is provided to reduce the hazards resulting
from becoming entangled in, or tripping over a longer cord.
Extension cords may be used if care is exercised in their use.
• The electrical rating of the extension cord should be at least
that of the appliance. If the electrical rating of the extension
cord is too low, it could overheat and burn.
• The resulting extended cord should be arranged so that it will
not drape over the counter top or tabletop where it can be
pulled on by children or tripped over.
PART DESCRIPTION
1. Stopper
2. Lid
3. Pouring jar
4. Seal
5. Blades support
6. Safety switch
7. Motor block
8. Pulse button (P)
9. Maximum Speed (H)
10. Medium Speed (2)
11. Minimum Speed (1)
12. Stop button (0)
4
USK BL 2 - 051107
IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the
requested breaks. Failure to follow this instruction carefully may result
in damage to the motor. The maximum continuous usage time is 3
minutes. After 3 minutes of continuous use, you should insert a break
of at least 10 minutes.
ASSEMBLY OF THE BLENDER AND USE
CAUTION!
Your appliance is fitted with a security device on the pouring jar
allowing the functioning of the appliance only when the jar and its
lid are correctly placed on the motor base. If those conditions are
met and the appliance does not start, call your after sales service.
• Assemble the pouring jar on the motor block by turning it from a
quarter run anticlockwise until it stops. To check if it has been
done correctly, it should be possible to raise the motor block with
de handle of the pouring jar.
• Fill the pouring jar with the chosen ingredients.
• Screw the lid until it stops.
• Plug in the appliance.
• Select the speed that is most suitable for the ingredients you want
to process.
• The button "P" (Pulse) allows a manual operation because you
have to keep pushing it when functioning. This position is
generally used to crush ice.
• Press button 1 (minimum speed) for mainly liquid ingredients.
• Press button 2 (medium speed) for combinations of liquid and
solid ingredients.
• Press button H (maximum speed) for mainly solid ingredients.
• It is also possible to add liquids or other ingredients anytime
without stopping the appliance. You only have to remove the
stopper, which closes the lid opening by turning and raising it
straight up.
• Once you have finished the preparation, press button "0" to stop
the appliance and unplug the appliance.
5
USK BL 2 - 051107
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.