INSTRUCTION MANUAL
2002 jWIN® Electronics, Corp
JT-P540
FEATURE LIST:
• FSK System Caller ID Telephone.
• Store 99 Call Memories with Caller Name (15 bit number. 15 bit
name)
• Store 20 Speed Dialing Memories. (10 Two-touch & 10 Onetouch).
• Receiver Volume HIGH/NORM Selector.
• LCD Capable of Displaying Incoming Call Number, Date and
Time.
• Real Time/Date and Dialing Number / Talking Time Display.
• Tone/Pulse dialing mode selector.
• Flash and Last Number Redial Function.
• Review Caller ID List to Dial Back
• Setup Local Area Code.
• Adjustable Brightness 8-grade LCD
• English, French, Spanish 3 Language Select. (Optional).
• Dot Matrix LCD Display with 15 Digit Calls, New Calls, and Calls
Number
• Total Call\ New Call & Call Message Mailbox Display.
LOCATION OF CONTROLS:
1. Receiver 10. UP Button.
2. Receiver VOL Selector. 11. DOWN Button.
3. MIC. 12. DEL. Button.
4. Hook Switch. 13. MEMO Button.
5. STORE Button. 14. IN USE Indicator.
6. M1-M10 Button. 15. SPK Button.
7. Speakerphone. 16. REDIAL Button.
8. LCD Display. 17. FLASH Button.
9. DIAL Button.
- 1 -
INSTALLATION
1. Open the cover of the battery compartment install 3 “AA” 1.5v
batteries.
2. Connect the coiled cord to handset and the telephone base.
3. Connect the telephone wire to the telephone set and wall jack.
4. Connect AC adapter to the phone set and the AC socket.
BASIC PHONE FEATURES
Set language, local area code, date, time, LCD contrast
1. In the on-hook status, press “DOWN” AND “DEL”, and the LCD
will display “SET LANGUAGE”. Press “UP” and “DOWN” to
select the desired language, then press DEL. to confirm.
2. Next the LCD will display “SET AREA CODE”, press “UP” and
“DOWN” to set the value of the first digit and press “DEL”, to
confirm. Repeat the above operation to set the value of the second
and third digits.
3. Next the LCD will display “SET TIME/DATE”. Press “UP” and
“DOWN” to set the desired hour and press “DEL” to confirm.
Repeat the same operation to set minute and date.
4. Next LCD will display “LCD CONTRAST”, press “UP”
and”DOWN” to set the desired contrast level and press “DEL” to
confirm.
- 2 -