Jwin JT-P430 User Manual

Vintage Design Telephone with Caller ID

Instruction Manual

JT-P430

Please read this manual carefully before operating and save it for future reference.

Have a question? Please visit http://www.jWIN.com

Vintage Design Telephone with Caller ID V10M10_IM_EN_09072007

- 1 -

www.jWIN.com

Vintage Design Telephone with Caller ID V10M10_IM_EN_09072007

USER SAFETY GUIDE

INSTRUCTIONS ON ENVIRONMENT PROTECTION

Do not dispose of this product in the usual household garbage at the
end of its life cycle; bring it to a collection point for the recycling of
electrical and electronic appliances. This symbol on the product means
the instructions for use or the packaging will inform about the methods
of disposal. The materials are recyclable as mentioned in its marking. By recycling,
material recycling, and other forms of re-utilization of old appliances, you make an
important contribution to the protection of the environment. Please inquire at your
local community administration for an authorized disposal location.

Important Safety Instructions

When used as directed, this unit has been designed and manufactured to ensure
your personal safety. However, improper use may result in electric shock, fire
hazards or other dangers. Please read all safety and operating instructions carefully
before installation and use. Remember to keep this instruction manual handy for
future reference. Take special note of all warnings contained in these instructions
and on the unit itself.

• Read and follow all instructions in this manual.

• Unplug this telephone from wall jack before cleaning with a damp cloth.

• Do not use liquid or aerosol cleansers to clean this product.

• Do not use this telephone in or near water (e.g. a bath tub, a sink, or a pool).

• To reduce the risk of electric shock, do not push objects through any slots of the

phone or disassemble the telephone. Pushing objects into the telephone or
opening (or removing) covers exposes wires and poses serious risks.

• Do not disassemble and/or reassemble this telephone yourself. Contact technical
support when service is required.

• Do not place this telephone on a bed, rug, or on any similar surface or near a
heat source. Openings for ventilation must not be blocked or covered.

• Do not place this telephone on an unstable cart, stand, or table as it may fall,
resulting in damage.

• Avoid using this telephone during electrical storms to prevent the risk of electric
shock from lightning.

• Unplug this telephone from the phone jack and contact Customer Support if the
following conditions occur:

o When it is exposed to rain or water
o When it fails to operate normally
o When it is dropped or its case is damaged
o When it exhibits a distinct change in performance

• Do not use this telephone to report a gas leak in the vicinity of the leak.

• Follow all safety instructions and use this telephone with caution when installing

or modifying telephone lines.

o Do not install telephone wire during a lightning storm.
o Only install telephone jacks in dry locations unless the jack is specifically

designed for wet locations.

• Avoid touching un-insulated telephone wires or terminals unless the telephone
line is disconnected at the network interface.

- 2 -

www.jWIN.com

Vintage Design Telephone with Caller ID V10M10_IM_EN_09072007

USER SAFETY GUIDE

Compliance (USA and Canada)

This product complies with the standards in Part 68 of the FCC Rules in the USA
and CS-03 in Canada.

1. This product must be connected to the public switched telephone network
through a modular telephone outlet or jack.

2. Upon the request of the local telephone service provider, the user of this product
must provide the following information:

• The “line” to which this telephone equipment will be connected (telephone

number)

• The telephone equipment’s FCC registration number and ringer equivalence

number. This information is printed on the back or bottom of the unit.

3. If it is determined that this equipment is malfunctioning, the FCC requires that it
not be used and that it must be unplugged from the modular outlet until the
problem has been corrected.

4. If the product causes harm to the telephone network, the telephone company
may temporarily discontinue telephone service. Whenever possible, the
telephone company will contact a customer prior to a service interruption. If
advanced notice is not possible, the customer will be notifies as soon as possible.
The customer will be given the opportunity to correct the problem.

- 3 -

www.jWIN.com

Vintage Design Telephone with Caller ID V10M10_IM_EN_09072007

- 4 -

www.jWIN.com