JVC XL-FZ158BKJ, XL-FZ258BKJ, XL-FZ158, XL-FZ258 User Manual
COMPACT COMPONENT SYSTEM
COMPACT DISC AUTOMATIC CHANGER
XL-FZ158BK / XL-FZ258BK
XL-FZ158BK
PROGRAM
CONTINUE
DISC
123
45
TRACK
12 43
56 87
910 + 10
REPEAT
RM-SXLFZ258JR REMOTE CONTROL
RANDOM
DISC SKIP
XL-FZ158 COMPACT DISC AUTOMATIC CHANGER
CALL
POWER
12345
PHONES LEVEL
MIN MAX
PHONES
5
PLAY & EXCHANGE SYSTEM
DISC
RANDOM
MEMORY
PLAY MODE REPEAT
DISC
1 BIT P E M D D CONVERTER
STANDBY
RECEIVED
DISC SKIP SEARCH
STOP/CANCEL
PLAY/PAUSE
/
OPEN/CLOSE
EXCHANGE
'
POWER
OPEN/
CLOSE
EXCHANGE
CALL
CANCEL
PHONES LEVEL
XL-FZ258BK
XL-FZ258 COMPACT DISC AUTOMATIC CHANGER
CALL
POWER
MIN MAX
PHONES
MEMORY
12345
DISC
5
PLAY & EXCHANGE SYSTEM
RANDOM
DISC
PLAY MODE REPEAT
1 BIT P E M D D CONVERTER
DISC SKIP SEARCH
STANDBY
RECEIVED
1 2 3 4 5
6 7 8 9 10 +10
STOP/CANCEL
PLAY/PAUSE
/
OPEN/CLOSE
EXCHANGE
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial
No. which are located either on the rear,
bottom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
LVT0234-001B
[J]
Warnings, Cautions and Others
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK.
DO NOT REMOVE COVER (OR BACK)
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol,
within an equilateral triangle is intended to
alert the user to the presence of uninsulated
"dangerous voltage" within the product's
enclosure that may be of sufficient
magnitude to constitute a risk of electric
shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
For U.S.A.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION
To reduce the risk of electrical shocks, fire, etc.:
Do not remove screws, covers or cabinet.
1.
Do not expose this appliance to rain or
2.
moisture.
IMPORTANT FOR LASER PRODUCTS
CLASS 1 LASER PRODUCT
1.
DANGER: Invisible laser radiation when
2.
open and interlock failed or defeated. Avoid
direct exposure to beam.
CAUTION: Do not open the top cover.
3.
There are no user serviceable parts inside
the unit; leave all servicing to qualified
service personnel.
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
Caution –– POWER switch!
Disconnect the mains plug to shut the power off completely.
The POWER switch in any position does not disconnect the
mains line. The power can be remote controlled for XL-FZ258BK.
G-1
We would like to thank you for purchasing one of our JVC
products.
Before connecting this unit to the wall outlet, please read
the instructions carefully to ensure that you obtain the
best possible performance.
If you have any questions, please consult your JVC
dealer.
Table of contents
INTRODUCTION ................................................ 1
Precautions .................................................................1
About this manual .......................................................1
Names of buttons ........................................................ 2
BEFORE USING FOR THE FIRST TIME .......... 4
Installing the unit .........................................................4
Connecting to the analog output jacks .......................4
Connecting to the digital output jack ..........................4
Supplying the power .................................................. 5
To connect the AC power cord of the main unit ............ 5
To install the batteries in the remote control unit
(for XL-FZ258BK) ........................................................... 5
COMPU LINK connection ...................................................... 6
BASIC OPERATIONS ....................................... 7
Basic functions for disc playback ............................... 7
Turning on the power of this unit .................................... 7
Loading discs in the disc tray ........................................ 7
Remote control operation (for XL-FZ258BK) .................. 7
Playing a disc ................................................................. 7
Stopping playback ......................................................... 7
Locating a point to start playback .............................. 8
Skipping to a desired disc ............................................. 8
Skipping to a desired track ............................................ 8
Searching for a desired section ..................................... 8
Specifying a desired disc .............................................. 8
Specifying a desired track (for XL-FZ258BK) ................ 8
Changing discs during playback................................9
VARIOUS PLAYBACK PATTERNS ................. 9
Playing tracks in a order of track/disc number ...........9
Playing tracks in a desired order .............................. 10
Playing tracks in a random order .............................. 11
Playing repeatedly .................................................... 11
Repeating all discs ....................................................... 11
Repeating one track ..................................................... 11
GENERAL INFORMATIONS ........................... 12
COMPU LINK remote control system ....................... 12
Care and handling .................................................... 13
Troubleshooting ........................................................ 14
Specifications............................................................ 14
Page 1
INTRODUCTION
Precautions
Load compact discs only
Never insert anything other than compact discs into any part of the
player.
If a problem persists
If something goes wrong, turn off the power immediately. If the same
problem reoccurs when the power is turned on once more, turn off the
power again and consult your JVC dealer.
Handling the power cord
When unplugging from the wall socket, always pull the plug body,
never the power cable.
Volume settings
A CD player has almost zero background noise. Because of this, the
technique of listening to the background level and then setting the
volume before the music starts, as used with analog turntables or tape
decks, cannot be used. If you raise the volume level too high, speaker
damage may result.
Condensation
The CD player uses optical components. If it is moved from a cold
location to a warm one, or is used in a room subject to excessive
humidity or where a fire has just been lit, condensation could form on
the optical components.
This may prevent the laser beam from being properly transmitted and
thus causes noise or even a malfunction.
If condensation has formed and the CD player does not function
correctly, we recommend that you leave it turned on for an hour or two.
If at the end of this time the CD player still does not function properly,
please consult your JVC dealer.
Transporting the unit
When carrying this unit, it is best to avoid either tilting it or turning it
upside-down. Where you cannot avoid doing so, please remove the
discs first.
About this manual
This manual covers the operating instructions for the compact disc
automatic changers XL-FZ258BK and XL-FZ158BK.
There are several functions which require separate instructions for
each model. Please check the model number stated on the carton box
and follow the descriptions applicable to your unit.
Especially, please note that the remote control unit RM-SX254U is
supplied only with XL-FZ258BK. For XL-FZ158BK, ignore all the
descriptions on the remote control unit.
This manual is organized as follows:
The first part, “INTRODUCTION”, gives you the precautions when
using this unit, and shows you the names of buttons on the main unit
and the remote control unit.
The second part, “BEFORE USING FOR THE FIRST TIME”, tells you
what kind of operations you should do before playing discs. This part
describes where to place the unit for best results, how to install
batteries in the remote control unit and how to connect this unit to the
amplifier/receiver and other components.
The third part, “BASIC OPERATIONS”, describes how to load discs,
and convenient basic functions for playing discs.
The fourth part, “VARIOUS PLAYBACK PATTERNS”, describes various functions for playing discs, and convenient functions for recording.
The fifth part, “GENERAL INFORMATIONS”, describes the COMPU
LINK remote control system which facilitates various operations between JVC components, and explains how to take care of discs.
This part also includes “Troubleshooting”, which tells you how to check
the unit when a malfunction occurs, and the technical informations
regarding this unit.
Using compact discs
Compact discs are made of plastic and can easily be damaged. If the
disc is dirty, scratched, warped or otherwise damaged, the digital
information may not be picked up correctly.
Applicable discs
This unit can only be used with compact discs bearing the mark below.
Never use discs of other types.
'
Page 1
Names of buttons
Main unit
INTRODUCTION
POWER button
CALL: displaying
program contents
button
POWER
PHONES LEVEL
MIN MAX
PHONES
PHONES: head-
phones jack
PHONES LEVEL control
MEMORY button
RANDOM: random
playback button
COMPACT DISC AUTOMATIC CHANGER
CALL
12345
PLAY & EXCHANGE SYSTEM
RANDOM
MEMORY
DISC
5
PLAY MODE REPEAT
DISC
DISC buttons
remote sensor
(XL-FZ258BK only)
PLAY MODE: switching play mode
(continue/program) button
REPEAT button
Display window
1 BIT P E M D D CONVERTER
Disc tray
1/¡, 4/¢ SEARCH:
skip, fast forward/backward
buttons
7 STOP/CANCEL button
DISC SKIP button
DISC SKIP SEARCH
STANDBY
RECEIVED
1 2 3 4 5
6 7 8 9 10 +10
STOP/CANCEL
Track buttons
(XL-FZ258BK only)
XL-FZ258BK:
STANDBY/RECEIVED indicator:
lights in standby mode and upon reception of the remote control signal
XL-FZ158BK:
STANDBY indicator
3 PLAY/8 PAUSE button
PLAY/PAUSE
/
OPEN/CLOSE
EXCHANGE
0 OPEN/CLOSE
button
EXCHANGE: changing
discs button
DIGITAL OUT
jack (optical)
DIGITAL OUT
OPTICAL
AC IN
AC POWER CORD inlet
OUTPUT jacks
COMPU LINK - 3
OUTPUT (SYNCHRO)
RIGHT LEFT
COMPU LINK-3 (SYNCHRO) jacks
Page 2
Remote control unit (for XL-FZ258BK)
PROGRAM button
CONTINUE button
DISC buttons
CONTINUE
DISC
123
45
TRACK
RANDOM
PROGRAM
DISC SKIP
12 43
POWER
OPEN/
CLOSE
EXCHANGE
Remote control signal transmitter
RANDOM: random playback button
POWER: POWER button
Turns on the unit or put it in STANDBY mode
OPEN/CLOSE button
EXCHANGE: changing discs button
DISC SKIP button
TRACK buttons
REPEAT button
4/¢: skip/check buttons
1/¡: fast forward/backward
buttons
Display window
Disc number indicators
1 2 3 4 5
EXCHANGE
REPEAT I
DISC TRACK TOTAL TIME STEP
56 87
910 + 10
REPEAT
RM-SXLFZ258JR REMOTE CONTROL
Play mode indicators
PROGRAM
RANDOM
1
2
6
7
11
12
16
17
Music calender
13
18
CALL
3
8
CANCEL
4
9
14
19
CALL: displaying program contents button
CANCEL button
3: Play button
7: Stop button
8: Pause button
Notes on the disc number indicators
÷ When the power is turned on or the disc tray is closed
5
10
15
20
with the 0 OPEN/CLOSE button, the unit searches for
loaded discs starting from the disc tray 1. When no disc
is loaded, the disc number disappears from the display
and unit goes on searching for the next tray.
÷ When no disc is loaded in the unit, “no disc” appears on
the display.
÷ In continue play mode, when playback of one disc is
finished, the circle around the corresponding disc
number disappears.
÷ In program mode, circle appears around the disc
number selected at that moment.
÷ When the EXCHANGE button is pressed, the indication
of the disc numbers is reset to the original status and all
the disc numbers (1-5) with their circle appear on the
display.
Page 3
Loading...